اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدOptomechanical Raman-Ratio Thermometry
103
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The temperature dependence of the asymmetry between Stokes and anti-Stokes Raman scattering can be exploited for self-calibrating, optically-based thermometry. In the context of cavity optomechanics, we observe the cavity-enhanced scattering of light interacting with the standing-wave drumhead modes of a silicon nitride membrane mechanical resonator. The ratio of the amplitude of Stokes to anti-Stokes scattered light is used to measure temperatures of optically-cooled mechanical modes down to the level of a few vibrational quanta. We demonstrate that the Raman-ratio technique is able to measure the physical temperature of our device over a range extending from cryogenic temperatures to within an order of magnitude of room temperature.
قيم البحث
اقرأ أيضاً
The radiation-pressure driven interaction of a coherent light field with a mechanical oscillator induces correlations between the amplitude and phase quadratures of the light. These correlations result in squeezed light -- light with quantum noise lo
wer than shot noise in some quadratures, and higher in others. Due to this lower quantum uncertainty, squeezed light can be used to improve the sensitivity of precision measurements. In particular, squeezed light sources based on nonlinear optical crystals are being used to improve the sensitivity of gravitational wave (GW) detectors. For optomechanical squeezers, thermally driven fluctuations of the mechanical oscillators position makes it difficult to observe the quantum correlations at room temperature, and at low frequencies. Here we present a measurement of optomechanically (OM) squeezed light, performed at room-temperature, in a broad band near audio-frequency regions relevant to GW detectors. We observe sub-poissonian quantum noise in a frequency band of 30 kHz to 70 kHz with a maximum reduction of 0.7 $pm$ 0.1 dB below shot noise at 45 kHz. We present two independent methods of measuring this squeezing, one of which does not rely on calibration of shot noise.
We present a novel discrete-variable quantum teleportation scheme using pulsed optomechanics. In our proposal, we demonstrate how an unknown optical input state can be transferred onto the joint state of a pair of mechanical oscillators, without phys
ically interacting with one another. We further analyze how experimental imperfections will affect the fidelity of the teleportation and highlight how our scheme can be realized in current state-of-the-art optomechanical systems.
The polarizations of optical fields, besides field intensities, provide more degrees of freedom to manipulate coherent light-matter interactions. Here we propose how to achieve a coherent switch of optomechanical entanglement in a polarized-light-dri
ven cavity system. We show that by tuning the polarizations of the driving field, the effective optomechanical coupling can be well controlled and, as a result, quantum entanglement between the mechanical oscillator and the optical transverse electric (TE) mode can be coherently and reversibly switched to that between the same phonon mode and the optical transverse magnetic (TM) mode. This ability of switching optomechanical entanglement with such a vectorial device can be important for building a quantum network being capable of efficient quantum information interchanges between processing nodes and flying photons.
Quantum sensors with solid state electron spins have attracted considerable interest due to their nanoscale spatial resolution.A critical requirement is to suppress the environment noise of the solid state spin sensor.Here we demonstrate a nanoscale
thermometer based on silicon carbide (SiC) electron spins.We experimentally demonstrate that the performance of the spin sensor is robust against dephasing due to a self protected machenism. The SiC thermometry may provide a promising platform for sensing in a noisy environment ,e.g. biological system sensing.
We provide a fully analytical treatment for the partial refrigeration of the thermal motion of a quantum mechanical resonator under the action of feedback. As opposed to standard cavity optomechanics where the aim is to isolate and cool a single mech
anical mode, the aim here is to extract the thermal energy from many vibrational modes within a large frequency bandwidth. We consider a standard cold-damping technique where homodyne read-out of the cavity output field is fed into a feedback loop that provides a cooling action directly applied on the mechanical resonator. Analytical and numerical results predict that low final occupancies are achievable independently of the number of modes addressed by the feedback as long as the cooling rate is smaller than the intermode frequency separation. For resonators exhibiting a few nearly degenerate pairs of modes cooling is less efficient and a weak dependence on the number of modes is obtained. These scalings hint towards the design of frequency resolved mechanical resonators where efficient refrigeration is possible via simultaneous cold-damping feedback.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
