اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدIncidence Angle and Polarization Dependence of Photo-Induced FMR in Co/Pd Multilayers
45
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Dependence of photo-induced FMR (phi-FMR) on incident angle of excitation and probing laser beams has been studied in a [Co (dCo = 0.78 nm) / Pd (dPd = 0.81 nm) ]5 multi-layer film with the aim to find experimentally the limitation of inducement and detection of magnetization dynamics with oblique light incidence. We have found, in the experiments changing the incident angle of a pump beam, that phi-FMR is observed up to the grazing incident angle of 88 degrees with p-polarized excitation pulses, whereas it disappears at the incidence angle of around 65 degrees with s-polarized excitation. As for the experiments changing the incident angle of a probe beam, phi-FMR disappears at the incidence angle of 65 degrees for both s- and p-polarizations, whereas it reappears with further increasing the angle for the p-polarization and vanishes at 75 degrees.
قيم البحث
اقرأ أيضاً
Depth-grading of magnetic anisotropy in perpendicular magnetic media has been predicted to reduce the field required to write data without sacrificing thermal stability. To study this prediction, we have produced Co/Pd multilayers with depth-dependen
t Co layer thickness. Polarized neutron reflectometry shows that the thickness grading results in a corresponding magnetic anisotropy gradient. Magnetometry reveals that the anisotropy gradient promotes domain nucleation upon magnetization reversal - a clear experimental demonstration of the effectiveness of graded anisotropy for reducing write-field.
Magnetic bubbles are topologically spin textures that offering the interesting physics and great promise for next-generation information storage technologies. The main obstacles so far are that magnetic bubbles are generated with no field stimuli in
new material systems at room temperature. Here, we report the observation of individual magnetic bubbles and its high frequency measurement at room temperature in an exchange-coupled [Co/Pd]4/Py multilayers. We demonstrate that the emergence of magnetic bubbles at remanence can be tuned by the in-plane tilted magnetic field (roughly 3{deg}) along the film plane at room temperature. High frequency results indicate that the presence of magnetic bubbles leads to broadening of the magnetic permeability spectrum lines (due to the non-uniformity of the magnetic moments). Our findings open the door to the bubble-based spintronics at room temperature in exchange-coupled magnetic multilayers.
The magnetic properties of (111)-oriented Rh/Co/Pt and Pd/Co/Pt multilayers are investigated by first-principles calculations. We focus on the interlayer exchange coupling, and identify thicknesses and composition where a typical ferromagnet or a syn
thetic antiferromagnet across the spacer layer is formed. All systems under investigation show a collinear magnetic intralayer order, but the Dzyaloshinskii-Moriya interaction (DMI) is rather strong for Pd-based systems, so that single magnetic skyrmions can be expected. In general, we find a strong sensitivity of the magnetic parameters (especially the DMI) in Rh-based systems, but Pd-based multilayers are less sensitive to structural details.
An efficient route to synthesize macroscopic amounts of graphene is highly desired and a bulk characterization of such samples, in terms of the number of layers, is equally important. We present a Raman spectroscopy-based method to determine the dist
ribution of the number of graphene layers in chemically exfoliated graphene. We utilize a controlled vapor-phase potassium intercalation technique and identify a lightly doped stage, where the Raman modes of undoped and doped few-layer graphene flakes coexist. The spectra can be unambiguously distinguished from alkali doped graphite, and a modeling with the distribution of the layers yields an upper limit of flake thickness of five layers with a significant single-layer graphene content. Complementary statistical AFM measurements on individual few-layer graphene flakes find a consistent distribution of the layer numbers.
The effects of hydrogen (H2) and deuterium (D2) absorption were studied in two Co/Pd multilayers with perpendicular magnetic anisotropy (PMA) using polarized neutron reflectivity (PNR). PNR was measured in an external magnetic field H applied in the
plane of the sample with the magnetization M confined in the plane for {mu}_o H= 6.0 T and partially out of plane at 0.65 T. Nominal thicknesses of the Co and Pd layers were 2.5 {AA} and 21 {AA}, respectively. Because of these small values, the actual layer chemical composition, thickness, and interface roughness parameters were determined from the nuclear scattering length density profile ({rho}_n) and its derivative obtained from both x-ray reflectivity and PNR, and uncertainties were determined using Monte Carlo analysis. The PNR {rho}_n showed that although D2 absorption occurred throughout the samples, absorption in the multilayer stack was modest (0.02 D per Pd atom) and thus did not expand. Direct magnetometry showed that H2 absorption decreased the total M at saturation and increased the component of M in the plane of the sample when not at saturation. The PNR magnetic scattering length density ({rho}_m) revealed that the Pd layers in the multilayer stack were magnetized and that their magnetization was preferentially modified upon D2 absorption. In one sample, a modulation of M with twice the multilayer period was observed at {mu}_o H= 0.65 T, which increased upon D2 absorption. These results indicate that H2 or D2 absorption decreases both the PMA and total magnetization of the samples. The lack of measurable expansion during absorption indicates that these changes are primarily governed by modification of the electronic structure of the material.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
