اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدBiFeO3/La0.7Sr0.3MnO3 heterostructures deposited on Spark Plasma Sintered LaAlO3 Substrates
110
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Multiferroic BiFeO3 (BFO) / La0.7Sr0.3MnO3 heterostructured thin films were grown by pulsed laser deposition on polished spark plasma sintered LaAlO3 (LAO) polycrystalline substrates. Both polycrystalline LAO substrates and BFO films were locally characterized using electron backscattering diffraction (EBSD), which confirmed the high-quality local epitaxial growth on each substrate grain. Piezoforce microscopy was used to image and switch the piezo-domains, and the results are consistent with the relative orientation of the ferroelectric variants with the surface normal. This high-throughput synthesis process opens the routes towards wide survey of electronic properties as a function of crystalline orientation in complex oxide thin film synthesis.
قيم البحث
اقرأ أيضاً
We report the formation of a novel ferromagnetic state in the antiferromagnet BiFeO3 at the interface with La0.7Sr0.3MnO3. Using x-ray magnetic circular dichroism at Mn and Fe L2,3-edges, we discovered that the development of this ferromagnetic spin
structure is strongly associated with the onset of a significant exchange bias. Our results demonstrate that the magnetic state is directly related with an electronic orbital reconstruction at the interface, which is supported by the linearly polarized x-ray absorption measurement at oxygen K-edge.
We present the synthesis of D0$_{22}$ Mn$_{3 - delta}$Ga ($delta$ = 0, 1) Heusler alloys by Spark Plasma Sintering method. The single phase Mn$_3$Ga (T$_mathrm{c}$ $simeq$ 780 K) is synthesized, while Mn$_2$Ga (T$_mathrm{c}$ $simeq$ 710 K) is found t
o coexist with a near-stoichiometric room temperature paramagnetic Mn$_9$Ga$_5$~($approx$ 15 %) phase due to its lower formation energy, as confirmed from our density functional theory (DFT) calculations. The alloys show hard magnetic behavior with large room temperature spontaneous magnetization m$_s$(80 kOe) = 1.63 (0.83) $mu_mathrm{B}$/f.u. and coercivity H$_mathrm{c}$ = 4.28 (3.35) kOe for Mn$_3$Ga (Mn$_2$Ga). The magnetic properties are further investigated till T$_mathrm{c}$ and the H$_mathrm{c}$ (T) analysis by Stoner-Wohlfarth model shows the nucleation mechanism for the magnetization reversal. The experimental results are well supported by DFT calculations, which reveal that the ground state of D0$_{22}$ Mn$_2$Ga is achieved by the removal of Mn-atoms from full Heusler Mn$_3$Ga structure in accordance with half Heusler alloy picture.
Textured alumina ceramics were obtained by Spark Plasma Sintering (SPS) of undoped commercial a-Al2O3 powders. Various parameters (density, grain growth, grain size distribution) of the alumina ceramics, sintered at two typical temperatures 1400{deg}
C and 1700{deg}C, are investigated. Quantitative textural and structural analysis, carried out using a combination of Electron Back Scattering Diffraction (EBSD) and X-ray diffraction (XRD), are represented in the form of mapping, and pole figures. The mechanical properties of these textured alumina ceramics include high elastic modulus and hardness value with high anisotropic nature, opening the door for a large range of applications
The hysteretic piezoelectric response in LaAlO3/SrTiO3 heterostructures can provide important insights into the mechanism for interfacial conductance and its metastability under various conditions. We have performed a variety of nonlocal piezoelectri
c force microscopy experiments on 3 unit cell LaAlO3/SrTiO3 heterostructures. A hysteretic piezoresponse is observed under various environmental and driving conditions. The hysteresis is suppressed when either the sample is placed in vacuum or the interface is electrically grounded. We present a simple physical model which can account for the observed phenomena.
A new flash (ultra-rapid) spark plasma sintering method applicable to various materials systems, regardless of their electrical resistivity, is developed. A number of powders ranging from metals to electrically insulative ceramics have been successfu
lly densified resulting in homogeneous microstructures within sintering times of 8-35 s. A finite element simulation reveals that the developed method, providing an extraordinary fast and homogeneous heating concentrated in the samples volume and punches, is applicable to all the different samples tested. The utilized uniquely controllable flash phenomenon is enabled by the combination of the electric current concentration around the sample and the confinement of the heat generated in this area by the lateral thermal contact resistance. The presented new method allows: extending flash sintering to nearly all materials, controlling sample shape by an added graphite die, and an energy efficient mass production of small and intermediate size objects. This approach represents also a potential venue for future investigations of flash sintering of complex shapes.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
