اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدPotential of a longitudinally focusing insertion for a storage ring X-ray FEL
115
0
0.0
(
0
)
تأليف
I. Agapov
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
In present work we investigate the potential of a longitudinally focusing device to compress bunches passing an undulator for a synchrotron storage ring. If integrated into a storage ring similar to PETRAIII such device could potentially produce continuous $sim$1ps pulses of photons in the $nm$ range with peak pulse powers of tens of GW. Even without operating in FEL saturation mode the longitudinal focusing can provide means to increase the brightness and shorten the photon pulse length.
قيم البحث
اقرأ أيضاً
We explore the possibility of operating a SASE FEL with a Storage Ring. We use a semi-analytical model to obtain the evolution inside the undulator by taking into account the interplay on the laser dynamics due to the induced energy spread and to the
radiation damping. We obtain the Renieris limit for the stationary output power and discuss the possibility of including in our model the effect of the beam instabilities.
We report on an injection feedback scheme for the ThomX storage ring project. ThomX is a 50-MeV-electron accelerator prototype which will use Compton backscattering in a storage ring to generate a high flux of hard X-rays. Given the slow beam damping
(in the ring), the injection must be performed with high accuracy to avoid large betatron oscillations. A homemade analytic code is used to compute the corrections that need to be applied before the beam injection to achieve a beam position accuracy of a few hundred micrometers in the first beam position monitors (BPMs). In order to do so the code needs the information provided by the rings diagnostic devices. The iterative feedback system has been tested using MadX simulations. Our simulations show that a performance that matches the BPMs accuracy can be achieved in less than 50 iterations in all cases. Details of this feedback algorithm, its efficiency and the simulations are discussed.
Using calculations and mathematical modeling, we demonstrate the feasibility of constructing a synchrotron storage ring for neutral polar molecules. The lattice is a racetrack type 3.6 m in circumference consisting of two of 180-degree arcs, six bunc
hers, and two long straight sections. Each straight section contains two triplet focusing lenses and space for beam injection and experiments. The design also includes a matched injector and a linear decelerator. Up to 60 bunches can be loaded and simultaneously stored in the ring. The molecules are injected at 90 m/s but the velocity of the circulating beam can be decelerated to 60 m/s after injection. The modeling uses deuterated ammonia molecules in a weak-field seeking state. Beam that survives 400 turns (15 s), has horizontal and vertical acceptances of 35 mm-mr and 70 mm-mr respectively, and an energy acceptance of plus or minus 2%.
This paper reports the first simultaneous measurement of the horizontal and vertical components of the polarization vector in a storage ring under the influence of a radio frequency (rf) solenoid. The experiments were performed at the Cooler Synchrot
ron COSY in Julich using a vector polarized, bunched $0.97,textrm{GeV/c}$ deuteron beam. Using the new spin feedback system, we set the initial phase difference between the solenoid field and the precession of the polarization vector to a predefined value. The feedback system was then switched off, allowing the phase difference to change over time, and the solenoid was switched on to rotate the polarization vector. We observed an oscillation of the vertical polarization component and the phase difference. The oscillations can be described using an analytical model. The results of this experiment also apply to other rf devices with horizontal magnetic fields, such as Wien filters. The precise manipulation of particle spins in storage rings is a prerequisite for measuring the electric dipole moment (EDM) of charged particles.
We are proposing a facility based on high gradient acceleration via x-band RF structures and plasma acceleration. We plan to reach an electron energy of the order of 1 GeV, suitable to drive a Free Electron Laser for applications in the so called wat
er window (2 - 4 nm). A conceptual design of the beamline, from the photon beam from the undulators to the user experimental chamber, mainly focusing on diagnostic, manipulation and transport of the radiation is presented and discussed. We also briefly outline a user end station for coherent imaging, laser ablation and pump-probe experiments.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
