اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدExperimental test of the spin mixing interface conductivity concept
53
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We perform a quantitative, comparative study of the spin pumping, spin Seebeck and spin Hall magnetoresistance effects, all detected via the inverse spin Hall effect in a series of over 20 yttrium iron garnet/Pt samples. Our experimental results fully support present, exclusively spin current-based, theoretical models using a single set of plausible parameters for spin mixing conductance, spin Hall angle and spin diffusion length. Our findings establish the purely spintronic nature of the aforementioned effects and provide a quantitative description in particular of the spin Seebeck effect.
قيم البحث
اقرأ أيضاً
Ferromagnetic materials exhibiting low magnetic damping ($alpha$) and moderately high saturation magnetization are required from the viewpoints of generation, transmission and detection of spin wave. Since spin-to-charge conversion efficiency is anot
her important parameter, high spin mixing conductance ($g_{r}^{uparrow downarrow}$) is the key for efficient spin-to-charge conversion. Full Heusler alloys e.g. $Co_2Fe_{0.4}Mn_{0.6}Si$ (CFMS), which are predicted to be 100$%$ spin polarized, possess low $alpha$. However, the $g_{r}^{uparrow downarrow}$ at the interface between CFMS and a paramagnet has not fully been understood. Here, we report the investigations of spin pumping and inverse spin Hall effect in $CFMS/Pt$ bilayers. Damping analysis indicates the presence of significant spin pumping at the interface of CFMS and Pt, which is also confirmed by the detection of inverse spin Hall voltage. We show that in CFMS/Pt the $g_{r}^{uparrow downarrow}$ (1.77$times$10$^{20}$m$^{-2}$) and interface transparency (84$%$) are higher compared to values reported for other ferromagnet/heavy metal systems.
We report on the first measurement of the thermal conductivity of a suspended single layer graphene. The measurements were performed using a non-contact optical technique. The near room-temperature values of the thermal conductivity in the range ~ 48
40 to 5300 W/mK were extracted for a single-layer graphene. The extremely high value of the thermal conductivity suggests that graphene can outperform carbon nanotubes in heat conduction.
AlN is an ultra-wide bandgap semiconductor which has been developed for applications including power electronics and optoelectronics. Thermal management of these applications is the key for stable device performance and allowing for long lifetimes. A
lN, with its potentially high thermal conductivity, can play an important role serving as a dielectric layer, growth substrate, and heat spreader to improve device performance. However, the intrinsic high thermal conductivity of bulk AlN predicted by theoretical calculations has not been experimentally observed because of the difficulty in producing materials with low vacancy and impurity levels, and other associated defect complexes in AlN which can decrease the thermal conductivity. This work reports the growth of thick AlN layers by MOCVD with an air-pocketed AlN layer and the first experimental observation of intrinsic thermal conductivity from 130 K to 480 K that matches density-function-theory calculations for single crystal AlN, producing some of the highest values ever measured. Detailed material characterizations confirm the high quality of these AlN samples with one or two orders of magnitude lower impurity concentrations than seen in commercially available bulk AlN. Measurements of these commercially available bulk AlN substrates from 80 K to 480 K demonstrated a lower thermal conductivity, as expected. A theoretical thermal model is built to interpret the measured temperature dependent thermal conductivity. Our work demonstrates that it is possible to obtain theoretically high values of thermal conductivity in AlN and such films may impact the thermal management and reliability of future electronic and optoelectronics devices.
The perovskite SrTiO$_3$-LaAlO$_3$ structure has advanced to a model system to investigate the rich electronic phenomena arising at polar interfaces. Using first principles calculations and transport measurements we demonstrate that an additional SrT
iO$_3$ capping layer prevents structural and chemical reconstruction at the LaAlO$_3$ surface and triggers the electronic reconstruction at a significantly lower LaAlO$_3$ film thickness than for the uncapped systems. Combined theoretical and experimental evidence (from magnetotransport and ultraviolet photoelectron spectroscopy) suggests two spatially separated sheets with electron and hole carriers, that are as close as 1 nm.
Multilayered heterostructures of Ce0.85Sm0.15O2-delta and Y0.16Zr0.92O2-delta of a high crystallographic quality were fabricated on (001) - oriented MgO single crystal substrates. Keeping the total thickness of the heterostructures constant, the numb
er of ceria-zirconia bilayers was increased while reducing the thickness of each layer. At each interface Ce was found primarily in the reduced, 3+ oxidation state in a layer extending about 2 nm from the interface. Concurrently, the conductivity decreased as the thickness of the layers was reduced suggesting a progressive confinement of the charge transport along the YSZ layers. The comparative analysis of the in-plane electrical characterization suggests that the contribution to the total electrical conductivity of these interfacial regions is negligible. For the smallest layer thickness of 2 nm the doped ceria layers are electrically insulating and the ionic transport only occurs through the zirconia layers. This is explained in terms of a reduced mobility of the oxygen vacancies in the highly reduced ceria.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
