اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدMechanics of Adhered, Pressurized Graphene Blisters
106
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We study the mechanics of pressurized graphene membranes using an experimental configuration that allows the determination of the elasticity of graphene and the adhesion energy between a substrate and a graphene (or other two-dimensional solid) membrane. The test consists of a monolayer graphene membrane adhered to a substrate by surface forces. The substrate is patterned with etched microcavities of a prescribed volume and when they are covered with the graphene monolayer it traps a fixed number (N) of gas molecules in the microchamber. By lowering the ambient pressure, and thus changing the pressure difference across the graphene membrane, the membrane can be made to bulge and delaminate in a stable manner from the substrate. Here we describe the analysis of the membrane/substrate as a thermodynamic system and explore the behavior of the system over representative experimentally-accessible geometry and loading parameters. We carry out companion experiments and compare them to the theoretical predictions and then use the theory and experiments together to determine the adhesion energy of graphene/SiO2 interfaces. We find an average adhesion energy of 0.24 J/m2 which is lower, but in line with our previously reported values. We assert that this test, which we call the constant N blister test, is a valuable approach to determine the adhesion energy between two-dimensional solid membranes and a substrate, which is an important, but not well-understood aspect of behavior. The test also provides valuable information that can serve as the basis for subsequent research to understand the mechanisms contributing to the observed adhesion energy. Finally, we show how in the limit of a large microcavity, the constant N test approaches the behavior observed in a constant pressure blister test and we provide an experimental observation that suggests this behavior.
قيم البحث
اقرأ أيضاً
Antiferromagnets offer remarkable promise for future spintronics devices, where antiferromagnetic order is exploited to encode information. The control and understanding of antiferromagnetic domain walls (DWs) - the interfaces between domains with di
ffering order parameter orientations - is a key ingredient for advancing such antiferromagnetic spintronics technologies. However, studies of the intrinsic mechanics of individual antiferromagnetic DWs remain elusive since they require sufficiently pure materials and suitable experimental approaches to address DWs on the nanoscale. Here we nucleate isolated, 180{deg} DWs in a single-crystal of Cr$_2$O$_3$, a prototypical collinear magnetoelectric antiferromagnet, and study their interaction with topographic features fabricated on the sample. We demonstrate DW manipulation through the resulting, engineered energy landscape and show that the observed interaction is governed by the DWs elastic properties. Our results advance the understanding of DW mechanics in antiferromagnets and suggest a novel, topographically defined memory architecture based on antiferromagnetic DWs.
Graphene is a promising candidate for optoelectronic applications such as photodetectors, terahertz imagers, and plasmonic devices. The origin of photoresponse in graphene junctions has been studied extensively and is attributed to either thermoelect
ric or photovoltaic effects. In addition, hot carrier transport and carrier multiplication are thought to play an important role. Here we report the intrinsic photoresponse in biased but otherwise homogeneous graphene. In this classic photoconductivity experiment, the thermoelectric effects are insignificant. Instead, the photovoltaic and a photo-induced bolometric effect dominate the photoresponse due to hot photocarrier generation and subsequent lattice heating through electron-phonon cooling channels respectively. The measured photocurrent displays polarity reversal as it alternates between these two mechanisms in a backgate voltage sweep. Our analysis yields elevated electron and phonon temperatures, with the former an order higher than the latter, confirming that hot electrons drive the photovoltaic response of homogeneous graphene near the Dirac point.
Graphene oxide (GO) flakes have been deposited to bridge the gap between two epitaxial graphene electrodes to produce all-graphene devices. Electrical measurements indicate the presence of Schottky barriers (SB) at the graphene/graphene oxide junctio
ns, as a consequence of the band-gap in GO. The barrier height is found to be about 0.7 eV, and is reduced after annealing at 180 $^circ$C, implying that the gap can be tuned by changing the degree of oxidation. A lower limit of the GO mobility was found to be 850 cm$^2$/Vs, rivaling silicon. {it In situ} local oxidation of patterned epitaxial graphene has been achieved.
Graphene is an ideal material for fabricating atomically thin nanometre spaced electrodes. Recently, carbon-based nanoelectrodes have been employed to create single-molecule transistors and phase change memory devices. In spite of the significant rec
ent interest in their use in a range of nanoscale devices from phase change memories to molecular electronics, the operating and scaling limits of these electrodes are completely unknown. In this paper, we report on our observations of consistent voltage driven resistance switching in sub-5 nm graphene nanogaps. We find that we are able to reversibly cycle between a low and a high resistance state using feedback-controlled voltage ramps.We attribute this unexplained switching in the gap to the formation and breakdown of carbon filaments.By increasing the gap, we find that such intrinsic resistance switching of graphene nanogaps imposes a scaling limit of 10 nm (approx.) on the gap-size for devices with operating voltages of 1 to 2 volts.
The two-dimensionality of graphene and other layered materials can be exploited to simplify the theoretical description of their plasmonic and polaritonic modes. We present an analytical theory that allows us to simulate these excitations in terms of
plasmon wave functions (PWFs). Closed-form expressions are offered for their associated extinction spectra, involving only two real parameters for each plasmon mode and graphene morphology, which we calculate and tabulate once and for all. Classical and quantum-mechanical formulations of this PWF formalism are introduced, in excellent mutual agreement for armchaired islands with $>10,$nm characteristic size. Examples of application are presented to predict both plasmon-induced transparency in interacting nanoribbons and excellent sensing capabilities through the response to the dielectric environment. We argue that the PWF formalism has general applicability and allows us to analytically describe a wide range of 2D polaritonic behavior, thus facilitating their use for the design of actual devices.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
