اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدAbsence of Debye Sheaths Due to Secondary Electron Emission
615
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
A bounded plasma where the electrons impacting the walls produce more than one secondary on average is studied via particle-in-cell simulation. It is found that no classical Debye sheath or space-charge limited sheath exists. Ions are not drawn to the walls and electrons are not repelled. Hence the plasma electrons travel unobstructed to the walls, causing extreme particle and energy fluxes. Each wall has a positive charge, forming a small potential barrier or inverse sheath that pulls some secondaries back to the wall to maintain the zero current condition.
قيم البحث
اقرأ أيضاً
A Computationally Assisted Spectroscopic Technique to measure secondary electron emission coefficients ($gamma$-CAST) in capacitively-coupled radio-frequency plasmas is proposed. This non-intrusive, sensitive diagnostic is based on a combination of P
hase Resolved Optical Emission Spectroscopy and particle-based kinetic simulations. In such plasmas (under most conditions in electropositive gases) the spatio-temporally resolved electron-impact excitation/ionization rate features two distinct maxima adjacent to each electrode at different times within each RF period. While one maximum is the consequence of the energy gain of electrons due to sheath expansion, the second maximum is produced by secondary electrons accelerated towards the plasma bulk by the sheath electric field at the time of maximum voltage drop across the adjacent sheath. Due to these different excitation/ionization mechanisms, the ratio of the intensities of these maxima is very sensitive to the secondary electron emission coefficient $gamma$. This sensitvity, in turn, allows $gamma$ to be determined by comparing experimental excitation profiles and simulation data obtained with various $gamma$-coefficients. The diagnostic, tested here in a geometrically symmetric argon discharge, yields an effective secondary electron emission coefficient of $gamma = 0.066 pm 0.01$ for stainless steel electrodes.
A new regime of fast magnetic reconnection with an out-of-plane (guide) magnetic field is reported in which the key role is played by an electron pressure anisotropy described by the Chew-Goldberger-Low gyrotropic equations of state in the generalize
d Ohms law, which even dominates the Hall term. A description of the physical cause of this behavior is provided and two-dimensional fluid simulations are used to confirm the results. The electron pressure anisotropy causes the out-of-plane magnetic field to develop a quadrupole structure of opposite polarity to the Hall magnetic field and gives rise to dispersive waves. In addition to being important for understanding what causes reconnection to be fast, this mechanism should dominate in plasmas with low plasma beta and a high in-plane plasma beta with electron temperature comparable to or larger than ion temperature, so it could be relevant in the solar wind and some tokamaks.
The frictional force (stopping power) acting on a test electron moving through the ideal electron gas is calculated taking into account electron-neutral atom collisions using the linear plasma response formalism. This allows us to elucidate how the e
ffective Coulomb logarithm is affected by electron-neutral collisions. In agreement with a recent investigation by Hagelaar, Donko, and Dyatko [Phys. Rev. Lett. {bf 123}, 025004 (2019)] we observe that the effective Coulomb logarithm decreases considerably due to electron-neutral collisions and becomes inversely proportional to the collision frequency in the highly collisional limit.
We wish to transmit messages to and from a hypersonic vehicle around which a plasma sheath has formed. For long distance transmission, the signal carrying these messages must be necessarily low frequency, typically 2 GHz, to which the plasma sheath i
s opaque. The idea is to use the plasma properties to make the plasma sheath appear transparent.
Charging up the surface of an insulator after beam impact can lead either to reverse sign of field between the surface and collector of electrons for case of thick sample or appearance of very high internal field for thin films. Both situations disca
rd correct measurements of secondary electron emission (SEE) and can be avoided via reducing the beam dose. The single pulse method with pulse duration of order of tens microseconds has been used. The beam pulsing was carried out by means of an analog switch introduced in deflection plate circuit which toggles its output between beam on and beam off voltages depending on level of a digital pulse. The error in measuring the beam current for insulators with high value of SEE was significantly reduced due to the use for this purpose a titanium sample having low value of the SEE with DC method applied. Results obtained for some not coated insulators show considerable increase of the SEE after baking out at 3500C what could be explained by the change of work function. Titanium coatings on alumina exhibit results close to the ones for pure titanium and could be considered as an effective antimultipactor coating.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
