اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدCatalyst preparation for CMOS-compatible silicon nanowire synthesis
73
0
0.0
(
0
)
تأليف
Vincent T. Renard
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Metallic contamination was key to the discovery of semiconductor nanowires, but today it stands in the way of their adoption by the semiconductor industry. This is because many of the metallic catalysts required for nanowire growth are not compatible with standard CMOS (complementary metal oxide semiconductor) fabrication processes. Nanowire synthesis with those metals which are CMOS compatible, such as aluminium and copper, necessitate temperatures higher than 450 C, which is the maximum temperature allowed in CMOS processing. Here, we demonstrate that the synthesis temperature of silicon nanowires using copper based catalysts is limited by catalyst preparation. We show that the appropriate catalyst can be produced by chemical means at temperatures as low as 400 C. This is achieved by oxidizing the catalyst precursor, contradicting the accepted wisdom that oxygen prevents metal-catalyzed nanowire growth. By simultaneously solving material compatibility and temperature issues, this catalyst synthesis could represent an important step towards real-world applications of semiconductor nanowires.
قيم البحث
اقرأ أيضاً
Hyperdoping consists of the intentional introduction of deep-level dopants into a semiconductor in excess of equilibrium concentrations. This causes a broadening of dopant energy levels into an intermediate band between the valence and conduction ban
ds.[1,2] Recently, bulk Si hyperdoped with chalcogens or transition metals has been demonstrated to be an appropriate intermediate-band material for Si-based short-wavelength infrared photodetectors.[3-5] Intermediate-band nanowires could potentially be used instead of bulk materials to overcome the Shockley-Queisser limit and to improve efficiency in solar cells,[6-9] but fundamental scientific questions in hyperdoping Si nanowires require experimental verification. The development of a method for obtaining controlled hyperdoping levels at the nanoscale concomitant with the electrical activation of dopants is, therefore, vital to understanding these issues. Here, we show a CMOS-compatible technique based on non-equilibrium processing for the controlled doping of Si at the nanoscale with dopant concentrations several orders of magnitude greater than the equilibrium solid solubility. Through the nanoscale spatially controlled implantation of dopants, and a bottom-up template-assisted solid phase recrystallization of the nanowires with the use of millisecond-flash lamp annealing, we form Se-hyperdoped Si/SiO2 core/shell nanowires that have a room-temperature sub-band gap optoelectronic photoresponse when configured as a photoconductor device.
Morphotropic phase boundaries (MPBs) show substantial piezoelectric and dielectric responses, which have practical applications. The predicted existence of MPB in HfO2-ZrO2 solid solution thin film has provided a new way to increase the dielectric pr
operties of a silicon-compatible device. Here, we present a new fabrication design by which the density of MPB and consequently the dielectric constant of HfO2-ZrO2 thin film was considerably increased. The density of MPB was controlled by fabrication of a 10-nm [1 nm-Hf0.5Zr0.5O2 (Ferroelectric)/1 nm-ZrO2 (Antiferroelectric)] nanolaminate followed by an appropriate annealing process. The coexistence of orthorhombic and tetragonal structures, which are the origins of ferroelectric (FE) and antiferroelectric (AFE) behaviors, respectively, was structurally confirmed, and a double hysteresis loop that originates from AFE ordering, with some remnant polarization that originates from FE ordering, was observed in P-E curve. A remarkable increase in dielectric constant compared to the conventional HfO2-ZrO2 thin film was achieved by controlling the FE-AFE ratio. The fabrication process was performed at low temperature and the device is compatible with silicon technology, so the new design yields a device that has possible applications in near-future electronics.
The synthesis of Si3N4 nanowires from the reaction of silicon nanoparticles with N2 in the 1200-1440 C temperature range is reported. The nitridation conditions are such that the reaction with nitrogen is favoured by the presence of silicon oxide in
the particles and by the active oxidation of silicon without a catalyst. It is shown that the Si to Si3N4 conversion rate depends on the amount of silicon particles used in the experiments and that, in general, the reaction slows down for greater amounts. This trend is explained by particle stacking, which restricts the exchange of gases between the furnace atmosphere and the atmosphere around the inner particles. In a first stage, local oxygen partial pressure increases around the inner particles and inhibits nitridation locally. If the amount of reactant Si nanoparticles is small enough, this extrinsic effect is avoided and the intrinsic nitridation kinetics can be measured. Experiments show that intrinsic kinetics does not depend on temperature.
We report a complementary metal oxide semiconductor (CMOS) technology compatible ferroelectric tunnel junction memristor grown directly on top of a Silicon substrate using a scandium doped aluminum nitride as the ferroelectric layer.
Band gap modification for small-diameter (1 nm) silicon nanowires resulting from the use of different species for surface termination is investigated by density functional theory calculations. Because of quantum confinement, small-diameter wires exhi
bit a direct band gap that increases as the wire diameter narrows, irrespective of surface termination. This effect has been observed in previous experimental and theoretical studies for hydrogenated wires. For a fixed cross-section, the functional group used to saturate the silicon surface significantly modifies the band gap, resulting in relative energy shifts of up to an electronvolt. The band gap shifts are traced to details of the hybridization between the silicon valence band and the frontier orbitals of the terminating group, which is in competition with quantum confinement.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
