اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدOptical-mechanical operation of the F2T2 Filter: a tunable filter designed to search for First Light
53
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The Flamingos-2 Tandem Tunable filter is a tunable, narrow-band filter, consisting of two Fabry-Perot etalons in series, capable of scanning to any wavelength from 0.95 to 1.35 microns with a spectral resolution of R~800. It is an accessory mode instrument for the near-IR Flamingos-2 imaging-spectrograph designed for the Gemini South 8m Observatory and will be fed through the upcoming Multi-Conjugate Adaptive Optics feed. The primary science goal of the F2T2 filter is to perform a ground-based search for the first star forming regions in the universe at redshifts of 7 < z < 11. The construction of the F2T2 filter is complete and it is currently in its calibration and commissioning phases. In this proceeding, we describe the calibration and performance of the instrument.
قيم البحث
اقرأ أيضاً
This paper describes the Maryland-Magellan Tunable Filter (MMTF) on the Magellan-Baade 6.5-meter telescope. MMTF is based on a 150-mm clear aperture Fabry-Perot (FP) etalon that operates in low orders and provides transmission bandpass and central wa
velength adjustable from ~5 to ~15 A and from ~5000 to over ~9200 A, respectively. It is installed in the Inamori Magellan Areal Camera and Spectrograph (IMACS) and delivers an image quality of ~0.5 over a field of view of 27 in diameter (monochromatic over ~10). This versatile and easy-to-operate instrument has been used over the past three years for a wide variety of projects. This paper first reviews the basic principles of FP tunable filters, then provides a detailed description of the hardware and software associated with MMTF and the techniques developed to observe with this instrument and reduce the data. The main lessons learned in the course of the commissioning and implementation of MMTF are highlighted next, before concluding with a brief outlook on the future of MMTF and of similar facilities which are soon coming on line.
We present a detailed theoretical analysis of a Fock-state filter based on the photon-number dependent group delay in cavity induced transparency proposed in Phys. Rev. Lett. 105, 013601 (2010). We derive a general expression for the propagation velo
city of different photon-number components of a light pulse interacting with an optically dense ensemble of three-level atoms coupled to a resonator mode under conditions of cavity induced transparency. These predictions are compared to numerical simulations of the propagation of few photon wave packets, and an estimation for experimental realization is made.
This paper presents a new Tunable Filter Instrument for the SOAR telescope. The Brazilian Tunable Filter Imager (BTFI) is a versatile, new technology, tunable optical imager to be used in seeing-limited mode and at higher spatial fidelity using the S
AM Ground-Layer Adaptive Optics facility at the SOAR telescope. The instrument opens important new science capabilities for the SOAR community, from studies of the centers of nearby galaxies and the insterstellar medium to statistical cosmological investigations. The BTFI takes advantage of three new technologies. The imaging Bragg Tunable Filter concept utilizes Volume Phase Holographic Gratings in a double-pass configuration, as a tunable filter, while a new Fabry-Perot (FP) concept involves technologies which allow a single FP etalon to act over a large range of interference orders and spectral resolutions. Both technologies will be in the same instrument. Spectral resolutions spanning the range between 25 and 30,000 can be achieved through the use of iBTF at low resolution and scanning FPs beyond R ~2,000. The third new technologies in BTFI is the use of EMCCDs for rapid and cyclically wavelength scanning thus mitigating the damaging effect of atmospheric variability through data acquisition. An additional important feature of the instrument is that it has two optical channels which allow for the simultaneous recording of the narrow-band, filtered image with the remaining (complementary) broad-band light. This avoids the uncertainties inherent in tunable filter imaging using a single detector. The system was designed to supply tunable filter imaging with a field-of-view of 3 arcmin on a side, sampled at 0.12 for direct Nasmyth seeing-limited area spectroscopy and for SAMs visitor instrument port for GLAO-fed area spectroscopy. The instrument has seen first light, as a SOAR visitor instrument. It is now in comissioning phase.
The paper presents a current tunable multifunction filter using current conveyor. The proposed circuit can be realized as on chip tunable low pass, high pass, band pass and elliptical notch filter. The circuit employs two current conveyors, one OTA,
four resistors and two grounded capacitors, ideal for integration. It has only one output terminal and the number of input terminals may be used. Further, there is no requirement for component matching in the circuit. The resonance frequency ({omega}0) and bandwidth ({omega}0 /Q) enjoy orthogonal tuning. The cutoff frequency of the filter is tunable by changing the bias current, which makes it on chip tunable filter. The circuit is realized by using commercially available current conveyor AD844 and OTA LM13700. A HSPICE simulation of circuit is also studied for the verification of theoretical results.
We present observations of the H-alpha, H-beta, [SII] 6716, 6731 and [NII] 6583 emission lines in the galactic HII region Sh2-235 with the Mapper of Narrow Galaxy Lines (MaNGaL), a tunable filter at the 1-m telescope of Special Astrophysical Observat
ory of the Russian Academy of Sciences. We show that the HII region is obscured by neutral material with AV = 2-4 mag. The area with the highest AV is situated to the south-west from the ionizing star and coincides with a maximum detected electron density of >=300 cm(-3). The combination of these results with archive AKARI far-infrared data allows us to estimate the contribution of the front and rear walls to the total column density of neutral material in S235, and explain the three-dimensional structure of the region. The HII region consist of a denser, more compact portion deeply embedded in the neutral medium and the less dense and obscured gas. The front and rear walls of the HII region are inhomogeneous, with the material in the rear wall having a higher column density. We find a two-sided photodissociation region in the dense clump S235 East 1, illuminated by a UV field with G0=50-70 and 200 Habing units in the western and eastern parts, respectively.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
