A high-throughput investigation of local epitaxy (called combinatorial substrate epitaxy) was carried out on Ca$_2$MnO$_4$ Ruddlesden-Popper thin films of six thicknesses (from 20 to 400 nm), all deposited on isostructural polycrystalline Sr$_2$TiO$_
4$ substrates. Electron backscatter diffraction revealed grain-over-grain local epitaxial growth for all films, resulting in a single orientation relationship ($OR$) for each substrate-film grain pair. Two preferred epitaxial $ORs$ accounted for more than 90 % of all ORs on 300 different microcrystals, based on analyzing 50 grain pairs for each thickness. The unit cell over unit cell $OR$ ([100][001]$_{film}$ $parallel$ [100][001]$_{substrate}$, or $OR1$) accounted for approximately 30 % of each film. The $OR$ that accounted for 60 % of each film ([100][001]$_{film}$ $parallel$ [100][010]$_{substrate}$, or $OR2$) corresponds to a rotation from $OR1$ by 90$^{circ}$ about the a-axis. $OR2$ is strongly favored for substrate orientations in the center of the stereographic triangle, and $OR1$ is observed for orientations very close to (001) or to those near the edge connecting (100) and (110). While $OR1$ should be lower in energy, the majority observation of $OR2$ implies kinetic hindrances decrease the frequency of $OR1$. Persistent grain over grain growth and the absence of variations of the $OR$ frequencies with thickness implies that the growth competition is finished within the first few si{ anometer}, and local epitaxy persists thereafter during growth.
The local epitaxial growth of pulsed laser deposited Ca$_2$MnO$_4$ films on polycrystalline spark plasma sintered Sr$_2$TiO$_4$ substrates was investigated to determine phase formation and preferred epitaxial orientation relationships ($ORs$) for iso
structural Ruddlesden-Popper (RP) heteroepitaxy, further developing the high-throughput synthetic approach called Combinatorial Substrate Epitaxy (CSE). Both grazing incidence X-ray diffraction and electron backscatter diffraction (EBSD) patterns of the film and substrate were indexable as single-phase RP-structured compounds. The optimal growth temperature (between 650 $^{circ}$C and 800 $^{circ}$C) was found to be 750 $^{circ}$C using the maximum value of the average image quality (IQ) of the backscattered diffraction patterns. Films grew in a grain-over-grain pattern such that each Ca$_2$MnO$_4$ grain had a single $OR$ with the Sr$_2$TiO$_4$ grain on which it grew. Three primary $ORs$ described 47 out of 49 grain pairs that covered nearly all of RP orientation space. The first $OR$, found for 20 of the 49, was the expected RP unit-cell over RP unit-cell $OR$, expressed as [100][001]$_{film}$||[100][001]$_{sub}$. The other two $ORs$ were essentially rotated from the first by 90$^{circ}$, with one (observed for 17 of 49 pairs) being rotated about the [100] and the other (observed for 10 of 49 pairs) being rotated about the [110] (and not exactly by 90$^{circ}$). These results indicate that only a small number of $ORs$ are needed to describe isostructural RP heteroepitaxy and further demonstrate the potential of CSE in the design and growth of a wide range of complex functional oxides.
While structure refinement is routinely achieved for simple bulk materials, the accurate structural determination still poses challenges for thin films due on the one hand to the small amount of material deposited on the thicker substrate and, on the
other hand, to the intricate epitaxial relationships that substantially complicate standard X-ray diffraction analysis. Using a combined approach, we analyze the crystal structure of epitaxial LaVO$_3$ thin films grown on (100)-oriented SrTiO$_3$. Transmission electron microscopy study reveals that the thin films are epitaxially grown on SrTiO$_3$ and points to the presence of 90$^{circ}$ oriented domains. The mapping of the reciprocal space obtained by high resolution X-ray diffraction permits refinement of the lattice parameters. We finally deduce that strain accommodation imposes a monoclinic structure onto the LaVO$_3$ film. The reciprocal space maps are numerically processed and the extracted data computed to refine the atomic positions, which are compared to those obtained using precession electron diffraction tomography. We discuss the obtained results and our methodological approach as a promising thin film structure determination for complex systems.
Multiferroic BiFeO3 (BFO) / La0.7Sr0.3MnO3 heterostructured thin films were grown by pulsed laser deposition on polished spark plasma sintered LaAlO3 (LAO) polycrystalline substrates. Both polycrystalline LAO substrates and BFO films were locally cha
racterized using electron backscattering diffraction (EBSD), which confirmed the high-quality local epitaxial growth on each substrate grain. Piezoforce microscopy was used to image and switch the piezo-domains, and the results are consistent with the relative orientation of the ferroelectric variants with the surface normal. This high-throughput synthesis process opens the routes towards wide survey of electronic properties as a function of crystalline orientation in complex oxide thin film synthesis.
Properties of complex oxide thin films can be tuned over a range of values as a function of mismatch, composition, orientation, and structure. Here, we report a strategy for growing structured epitaxial thermoelectric thin films leading to improved S
eebeck coefficient. Instead of using single-crystal sapphire substrates to support epitaxial growth, Ca$_3$Co$_4$O$_9$ films are deposited, using the Pulsed Laser Deposition technique, onto Al$_2$O$_3$ polycrystalline substrates textured by Spark Plasma Sintering. The structural quality of the 2000 AA thin film was investigated by Transmission Electron Microscopy, while the crystallographic orientation of the grains and the epitaxial relationships were determined by Electron Back Scatter Diffraction. The use of a polycrystalline ceramic template leads to structured films that are in good local epitaxial registry. The Seebeck coefficient is about 170 $mu$V/K at 300 K, a typical value of misfit material with low carrier density. This high-throughput process, called combinatorial substrate epitaxy, appears to facilitate the rational tuning of functional oxide films, opening a route to the epitaxial synthesis of high quality complex oxides.
Bulk p and n-type bismuth telluride were prepared using spark plasma texturization method. The texture development along the uniaxial load in the 001 direction is confirmed from both x-ray diffraction analysis and Electron Backscattering Diffraction
measurements. Interestingly, those textured samples outperform the samples prepared by conventional spark plasma sintering (SPS) leading to a reduced thermal conductivity in the ab-plane. The textured samples of n- type BiTe2.7Se0.3 and p-type Bi0.5Sb1.5Te3 showed a 42% and 33% enhancement in figure of merit at room temperature respectively, as compared to their SPS counterparts, opening the route for applications.
Textured alumina ceramics were obtained by Spark Plasma Sintering (SPS) of undoped commercial a-Al2O3 powders. Various parameters (density, grain growth, grain size distribution) of the alumina ceramics, sintered at two typical temperatures 1400{deg}
C and 1700{deg}C, are investigated. Quantitative textural and structural analysis, carried out using a combination of Electron Back Scattering Diffraction (EBSD) and X-ray diffraction (XRD), are represented in the form of mapping, and pole figures. The mechanical properties of these textured alumina ceramics include high elastic modulus and hardness value with high anisotropic nature, opening the door for a large range of applications
The synthesis, morphology and magneto-transport properties of nanostructure-engineered charge-ordered Pr0.5Ca0.5MnO3 grown on ZnO nanowires are reported. The stability of the charge-ordering can be tuned, but more interestingly the sign of the magnet
oresistance is inverted at low temperatures. Coexistence of ferromagnetic clusters on the surface and antiferromagnetic phase in the core of the grains were considered in order to understand these features. This work suggests that such a process of growing on nanowires network can be readily extended to other transition metal oxides and open doors towards tailoring their functionalities.
Large magnetocaloric effect has been observed in Mn3O4 around its ferrimagnetic transition at TN = 42.75 K. Field-induced isothermal entropy changes (DeltaS) were derived from both magnetic and calorimetric techniques. The maximum |DeltaS| and adiaba
tic temperature change ({Delta}Tad) at TN are 11 J kg-1 K-1 and 1.9 K, respectively, for a magnetic field change of 20 kOe. Moreover, it is found that the complex magnetic phase transitions taking place below TN produce additional -but smaller- features on DeltaS(T).
Magnetic properties of a series of (La0.7Sr0.3MnO3/SrRuO3) superlattices, where the SrRuO3 layer thickness is varying, are examined. A room-temperature magnetocaloric effect is obtained owing to the finite size effect which reduces the TC of La0.7Sr0
.3MnO3 layers. While the working temperature ranges are enlarged,, -DeltaSmax values remains similar to the values in polycrystalline La0.7Sr0.3MnO3. Consequently, the relative cooling powers are significantly improved, the microscopic mechanism of which is related to the effect of the interfaces at La0.7Sr0.3MnO3/SrRuO3 and higher nanostructural disorder. This study indicates that artificial oxide superlattices/multilayers might provide an alternative pathway in searching for efficient room-temperature magnetic refrigerators for (nano)microscale systems.
