The resistance $R$ vs perpendicular external magnetic field $H$ was measured for superconducting Nb thin--film microbridges with and without microholes [antidots (ADs)]. Well below the transition temperature, integral $R(H)$ measurements of the resis
tive transition to the normal state on the plain bridge show two distinct regions, which can be identified as bulk and edge superconductivity, respectively. The latter case appears when bulk superconductivity becomes suppressed at the upper critical field $H_{c2}$ and below the critical field of edge superconductivity $H_{c3}approx 1.7, H_{c2}$. The presence of additional edges in the AD bridge leads to a different shape of the $R(H)$ curves. We used low-temperature scanning laser microscopy (LTSLM) to visualize the current distribution in the plain and AD bridge upon sweeping $H$. While the plain bridge shows a dominant LTSLM signal at its edges for $H > H_{c2}$ the AD bridge also gives a signal from the inner parts of the bridge due to the additional edge states around the ADs. LTSLM reveals an asymmetry in the current distribution between left and right edges, which confirms theoretical predictions. Furthermore, the experimental results are in good agreement with our numerical simulations (based on the time-dependent Ginzburg--Landau model) yielding the spatial distribution of the order parameter and current density for different bias currents and $H$ values.
Tunneling magnetoresistance (TMR) in a vertical manganite junction was investigated by low-temperature scanning laser microscopy (LTSLM) allowing to determine the local relative magnetization M orientation of the two electrodes as a function of magni
tude and orientation of the external magnetic field H. Sweeping the field amplitude at fixed orientation revealed magnetic domain nucleation and propagation in the junction electrodes. For the high-resistance state an almost single-domain antiparallel magnetization configuration was achieved, while in the low-resistance state the junction remained in a multidomain state. Calculated resistance $R_mathrm{calc}(H)$ based on the local M configuration obtained by LTSLM is in quantitative agreement with R(H) measured by magnetotransport.
Heteroepitaxially grown bilayers of ferromagnetic La$_{0.7}$Ca$_{0.3}$MnO$_3$ (LCMO) on top of superconducting YBa$_2$Cu$_3$O$_7$ (YBCO) thin films were investigated by focusing on electric transport properties as well as on magnetism and orbital occ
upation at the interface. Transport measurements on YBCO single layers and on YBCO/LCMO bilayers, with different YBCO thickness $d_Y$ and constant LCMO thickness $d_L=50$,nm, show a significant reduction of the superconducting transition temperature $T_c$ only for $d_Y<10$,nm,with only a slightly stronger $T_c$ suppression in the bilayers, as compared to the single layers. X-ray magnetic circular dichroism (XMCD) measurements confirm recently published data of an induced magnetic moment on the interfacial Cu by the ferromagnetically ordered Mn ions, with antiparallel alignment between Cu and Mn moments. However, we observe a significantely larger Cu moment than previously reported, indicating stronger coupling between Cu and Mn at the interface. This in turn could result in an interface with lower transparency, and hence smaller spin diffusion length, that would explain our electric transport data, i.e.smaller $T_c$ suppression. Moreover, linear dichroism measurements did not show any evidence for orbital reconstruction at the interface, indicating that a large change in orbital occupancies through hybridization is not necessary to induce a measurable ferromagnetic moment on the Cu atoms.
Cerium-doped manganite thin films were grown epitaxially by pulsed laser deposition at $720 ^circ$C and oxygen pressure $p_{O_2}=1-25 $Pa and were subjected to different annealing steps. According to x-ray diffraction (XRD) data, the formation of CeO
$_2$ as a secondary phase could be avoided for $p_{O_2}ge 8 $Pa. However, transmission electron microscopy shows the presence of CeO$_2$ nanoclusters, even in those films which appear to be single phase in XRD. With O$_2$ annealing, the metal-to-insulator transition temperature increases, while the saturation magnetization decreases and stays well below the theoretical value for electron-doped La$_{0.7}$Ce$_{0.3}$MnO$_3$ with mixed Mn$^{3+}$/Mn$^{2+}$ valences. The same trend is observed with decreasing film thickness from 100 to 20 nm, indicating a higher oxygen content for thinner films. Hall measurements on a film which shows a metal-to-insulator transition clearly reveal holes as dominating charge carriers. Combining data from x-ray photoemission spectroscopy, for determination of the oxygen content, and x-ray absorption spectroscopy (XAS), for determination of the hole concentration and cation valences, we find that with increasing oxygen content the hole concentration increases and Mn valences are shifted from 2+ to 4+. The dominating Mn valences in the films are Mn$^{3+}$ and Mn$^{4+}$, and only a small amount of Mn$^{2+}$ ions can be observed by XAS. Mn$^{2+}$ and Ce$^{4+}$ XAS signals obtained in surface-sensitive total electron yield mode are strongly reduced in the bulk-sensitive fluorescence mode, which indicates hole-doping in the bulk for those films which do show a metal-to-insulator transition.
