Particle transport due to Ion Temperature Gradient/Trapped Electron (ITG/TE) mode turbulence is investigated using the gyrokinetic code GENE. Both a reduced quasilinear (QL) treatment and nonlinear (NL) simulations are performed for typical tokamak p
arameters corresponding to ITG dominated turbulence. A selfconsistent treatment is used, where the stationary local profiles are calculated corresponding to zero particle flux simultaneously for electrons and trace impurities. The scaling of the stationary profiles with magnetic shear, safety factor, electron-to-ion temperature ratio, collisionality, toroidal sheared rotation, triangularity, and elongation is investigated. In addition, the effect of different main ion mass on the zero flux condition is discussed. The electron density gradient can significantly affect the stationary impurity profile scaling. It is therefore expected, that a selfconsistent treatment will yield results more comparable to experimental results for parameter scans where the stationary background density profile is sensitive. This is shown to be the case in scans over magnetic shear, collisionality, elongation, and temperature ratio, for which the simultaneous zero flux electron and impurity profiles are calculated. A slight asymmetry between hydrogen, deuterium and tritium with respect to profile peaking is obtained, in particular for scans in collisionality and temperature ratio.
Gyrokinetic simulations of ion temperature gradient mode and trapped electron mode driven impurity transport in a realistic tokamak geometry are presented and compared with results using simplified geometries. The gyrokinetic results, obtained with t
he GENE code in both linear and non-linear modes are compared with data and analysis for a dedicated impurity injection discharge at JET. The impact of several factors on heat and particle transport is discussed, lending special focus to tokamak geometry and rotational shear. To this end, results using s-alpha and concentric circular equilibria are compared with results with magnetic geometry from a JET experiment. To further approach experimental conditions, non-linear gyrokinetic simulations are performed with collisions and a carbon background included. The impurity peaking factors, computed by finding local density gradients corresponding to zero particle flux, are discussed. The impurity peaking factors are seen to be reduced by a factor of ~2 in realistic geometry compared with the simplified geometries, due to a reduction of the convective pinch. It is also seen that collisions reduce the peaking factor for low-Z impurities, while increasing it for high charge numbers, which is attributed to a shift in the transport spectra towards higher wavenumbers with the addition of collisions. With the addition of roto-diffusion, an overall reduction of the peaking factors is observed, but this decrease is not sufficient to explain the flat carbon profiles seen at JET.
The turbulent transport of main ion and trace impurities in a tokamak device in the presence of steep electron density gradients has been studied. The parameters are chosen for trapped electron (TE) mode turbulence, driven primarily by steep electron
density gradients relevant to H-mode physics, but with a transition to temperature gradient driven turbulence as the density gradient flattens. Results obtained through non-linear (NL) and quasilinear (QL) gyrokinetic simulations using the GENE code are compared with results obtained from a fluid model. Main ion and impurity transport is studied by examining the balance of convective and diffusive transport, as quantified by the density gradient corresponding to zero particle flux (peaking factor). Scalings are obtained for the impurity peaking with the background electron density gradient and the impurity charge number. It is shown that the impurity peaking factor is weakly dependent on impurity charge and significantly smaller than the driving electron density gradient.
In the present paper the transport of impurities driven by trapped electron (TE) mode turbulence is studied. Non-linear (NL) gyrokinetic simulations using the code GENE are compared with results from quasilinear (QL) gyrokinetic simulations and a com
putationally efficient fluid model. The main focus is on model comparisons for electron temperature gra- dient driven turbulence regarding the sign of the convective impurity velocity (pinch) and the impurity density gradient R/LnZ (peaking factor) for zero impurity flux. In particular, the scaling of the impurity peaking factors with impurity charge Z and with driving temper- ature gradient is investigated and compared with the results for Ion Temperature Gradient (ITG) driven turbulence. In addition, the impurity peaking is compared to the main ion peaking obtained by a self-consistent fluid calculation of the density gradients corresponding to zero particle fluxes. For the scaling of the peaking factor with impurity charge Z, a weak dependence is obtained from NL GENE and fluid simulations. The QL GENE results show a stronger dependence for low Z impurities and overestimates the peaking factor by up to a factor of two in this region. As in the case of ITG dominated turbulence, the peaking factors saturate as Z increases, at a level much below neoclassical predictions. However, the scaling with Z is weak or reversed as compared to the ITG case. The scaling of impurity peaking with the background temperature gradients is found to be weak in the NL GENE and fluid simulations. The QL results are also here found to significantly overestimate the peaking factor for low Z values. For the parameters considered, the background density gradient for zero particle flux is found to be slightly larger than the corresponding impurity zero flux gradient.
