Timing performance of 30-nm-wide superconducting nanowire avalanche photodetectors

We investigated the timing jitter of superconducting nanowire avalanche photodetectors (SNAPs, also referred to as cascade switching superconducting single photon detectors) based on 30-nm-wide nanowires. At bias currents (IB) near the switching current, SNAPs showed sub 35 ps FWHM Gaussian jitter similar to standard 100 nm wide superconducting nanowire single-photon detectors. At lower values of IB, the instrument response function (IRF) of the detectors became wider, more asymmetric, and shifted to longer time delays. We could reproduce the experimentally observed IRF time-shift in simulations based on an electrothermal model, and explain the effect with a simple physical picture.

Afterpulsing and Instability in Superconducting Nanowire Avalanche Photodetectors

We investigated the reset time of superconducting nanowire avalanche photodetectors (SNAPs) based on 30 nm wide nanowires. We studied the dependence of the reset time of SNAPs on the device inductance and discovered that SNAPs can provide a speed-up relative to SNSPDs with the same area, but with some limitations: (1) reducing the series inductance of SNAPs (necessary for the avalanche formation) could result in the detectors operating in an unstable regime; (2) a trade-off exists between maximizing the bias current margin and minimizing the reset time of SNAPs; and (3) reducing the reset time of SNAPs below ~ 1 ns resulted in afterpulsing.

Single-photon detectors based on ultra-narrow superconducting nanowires

Superconducting nanowire single-photon detectors (SNSPDs) perform single-photon counting with exceptional sensitivity and time resolution at near-infrared wavelengths. State-of-the-art SNSPDs, based on 100 nm-wide, 4 to 5 nm thick NbN nanowires, are vulnerable to constrictions, which significantly limit their yield. Also, their sensitivity becomes negligible beyond 2 mu m wavelength, which makes them unsuitable for mid-infrared applications. SNSPDs based on few-tens-of-nanometer-wide nanowires are expected to efficiently detect mid-infrared photons and to operate at low bias currents, so constrictions may have less impact on their performance. Prior to this work, SNSPDs based on nanowires narrower than 50-nm had not been demonstrated because: (1) the SNSPD signal is roughly proportional to the nanowire width, so narrow nanowires have poor signal-to-noise ratio; and (2) fabrication at these length scales is extremely challenging. In this letter we report how we addressed these issues and demonstrated single-photon detection (20% detection efficiency at 1550 nm wavelength) with 30- and 20-nm-wide-nanowire detectors.