اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSingle-photon detectors based on ultra-narrow superconducting nanowires
66
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Superconducting nanowire single-photon detectors (SNSPDs) perform single-photon counting with exceptional sensitivity and time resolution at near-infrared wavelengths. State-of-the-art SNSPDs, based on 100 nm-wide, 4 to 5 nm thick NbN nanowires, are vulnerable to constrictions, which significantly limit their yield. Also, their sensitivity becomes negligible beyond 2 mu m wavelength, which makes them unsuitable for mid-infrared applications. SNSPDs based on few-tens-of-nanometer-wide nanowires are expected to efficiently detect mid-infrared photons and to operate at low bias currents, so constrictions may have less impact on their performance. Prior to this work, SNSPDs based on nanowires narrower than 50-nm had not been demonstrated because: (1) the SNSPD signal is roughly proportional to the nanowire width, so narrow nanowires have poor signal-to-noise ratio; and (2) fabrication at these length scales is extremely challenging. In this letter we report how we addressed these issues and demonstrated single-photon detection (20% detection efficiency at 1550 nm wavelength) with 30- and 20-nm-wide-nanowire detectors.
قيم البحث
اقرأ أيضاً
We present a realistic scheme for how to construct a single-photon transistor where the presence or absence of a single microwave photon controls the propagation of a subsequent strong signal signal field. The proposal is designed to work with existi
ng superconducting artificial atoms coupled to cavities. We study analytically and numerically the efficiency and the gain of our proposal and show that current transmon qubits allow for error probabilities ~1% and gains of the order of hundreds.
Advanced quantum information science and technology (QIST) applications place exacting de- mands on optical components. Quantum waveguide circuits offer a route to scalable QIST on a chip. Superconducting single-photon detectors (SSPDs) provide infra
red single-photon sensitivity combined with low dark counts and picosecond timing resolution. In this study we bring these two technologies together. Using SSPDs we observe a two-photon interference visibility of 92.3pm1.0% in a silica-on-silicon waveguide directional coupler at lamda = 804 nm-higher than that measured with silicon detectors (89.9pm0.3%). We further operated controlled-NOT gate and quantum metrology circuits with SSPDs. These demonstrations present a clear path to telecom-wavelength quantum waveguide circuits.
We present an alternative approach to the fabrication of highly efficient superconducting nanowire single-photon detectors (SNSPDs) based on tungsten silicide. Using well-established technologies for the deposition of dielectric mirrors and anti-refl
ection coatings in conjunction with an embedded WSi bilayer photon absorber structure, we fabricated a bandwidth-enhanced detector. It exhibits system detection efficiencies (SDE) higher than $left(87.1pm1.3right),%$ in the range from $1450,mathrm{nm}$ to $1640,mathrm{nm}$, with a maximum of $left(92.9pm1.1right),%$ at $1515,mathrm{nm}$. Our measurements indicate SDE enhancements of up to $left(18.4pm1.7right),%$ over a single-absorber WSi SNSPD. The latter has been optimized for 1550 nm for comparison and exhibits maximum SDE of $left(93.5pm1.2right),%$ at 1555 nm. We emphasize that our technological approach has been tested with, but is not limited to, the wavelengths and absorber material presented here. It could be adapted flexibly for multi-color detector systems from the ultraviolet to the mid-infrared wavelength range. This bears the potential for significant improvements in many current quantum optical experiments and applications as well as for detector commercialization.
The Parallel Nanowire Detector (PND) is a photon number resolving (PNR) detector which uses spatial multiplexing on a subwavelength scale to provide a single electrical output proportional to the photon number. The basic structure of the PND is the p
arallel connection of several NbN superconducting nanowires (100 nm-wide, few nm-thick), folded in a meander pattern. PNDs were fabricated on 3-4 nm thick NbN films grown on MgO (TS=400C) substrates by reactive magnetron sputtering in an Ar/N2 gas mixture. The device performance was characterized in terms of speed and sensitivity. PNDs showed a counting rate of 80 MHz and a pulse duration as low as 660ps full width at half maximum (FWHM). Building the histograms of the photoresponse peak, no multiplication noise buildup is observable. Electrical and optical equivalent models of the device were developed in order to study its working principle, define design guidelines, and develop an algorithm to estimate the photon number statistics of an unknown light. In particular, the modeling provides novel insight of the physical limit to the detection efficiency and to the reset time of these detectors. The PND significantly outperforms existing PNR detectors in terms of simplicity, sensitivity, speed, and multiplication noise.
The realization of an ultra-fast source of heralded single photons emitted at the wavelength of 1540 nm is reported. The presented strategy is based on state-of-the-art telecom technology, combined with off-the-shelf fiber components and waveguide no
n-linear stages pumped by a 10 GHz repetition rate laser. The single photons are heralded at a rate as high as 2.1 MHz with a heralding efficiency of 42%. Single photon character of the source is inferred by measuring the second-order autocorrelation function. For the highest heralding rate, a value as low as 0.023 is found. This not only proves negligible multi-photon contributions but also represents the best measured value reported to date for heralding rates in the MHz regime. These prime performances, associated with a device-like configuration, are key ingredients for both fast and secure quantum communication protocols.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
