Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userOptical Receiver with Helicity Dependent Switching of Magnetization
131
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
In this work, we propose helicity-dependent switching (HDS) of magnetization of Co/Pt for energy efficient optical receiver. Designing a low power optical receiver for optical-to-electrical signal conversion has proven to be very challenging. Current day receivers use a photodiode that produces a photocurrent in response to input optical signals, and power hungry trans-impedance amplifiers are required to amplify the small photocurrents. Here, we propose light helicity induced switching of magnetization to overcome the requirement of photodiodes and subsequent trans-impedance amplification by sensing the change in magnetization with a magnetic tunnel junction (MTJ). Magnetization switching of a thin ferromagnet layer using circularly polarized laser pulses have recently been demonstrated which shows one-to-one correspondence between light helicity and the magnetization state. We propose to utilize this phenomena by using digital input dependent circularly polarized laser pulses to directly switch the magnetization state of a thin Co/Pt ferromagnet layer at the receiver. The Co/Pt layer is used as the free layer of an MTJ, the resistance of which is modified by the laser pulses. With the one-to-one dependence between input data and output magnetization state, the MTJ resistance is directly converted to digital output signal. Our device to circuit level simulation results indicate that, HDS based optical receiver consumes only 0.124 pJ/bit energy, which is much lower than existing techniques.
rate research
Read More
We report on the controlled switching of domain wall (DW) magnetization in aligned stripe domain structures, stabilized in [Co (0.44 nm)/Pt (0.7 nm)]$_X$ ($X = 48$, 100, 150) multilayers with perpendicular magnetic anisotropy. The switching process, induced by an external magnetic field, is monitored by measuring the evolution of the in-plane magnetization. % We show that the remanent in-plane magnetization originates from the polarization of the Bloch-type DWs. With micromagnetic simulations, we reveal that the reversal of the DW polarization is the result of the emergence and collapse of horizontal Bloch lines within the DWs at particular strengths of the external magnetic field, applied opposite to the DW polarization. Our findings are relevant for DW-based magnonics and bubble skyrmion applications in magnetic multilayers.
We report on the switching of the in-plane magnetization of thin yttrium iron garnet (YIG)/Pt bilayers induced by an electrical current. The switching is either field-induced and assisted by a dc current, or current-induced and assisted by a static magnetic field. The reversal of the magnetization occurs at a current density as low as $10^5$~A/cm$^{2}$ and magnetic fields of $sim 40$~$mu$T, two orders of magnitude smaller than in ferromagnetic metals, consistently with the weak uniaxial anisotropy of the YIG layers. We use the transverse component of the spin Hall magnetoresistance to sense the magnetic orientation of YIG while sweeping the current. Our measurements and simulations reveal that the current-induced effective field responsible for switching is due to the Oersted field generated by the current flowing in the Pt layer rather than by spin-orbit torques, and that the switching efficiency is influenced by pinning of the magnetic domains.
The ferroelectric polarization switching in ferroelectric hafnium zirconium oxide (Hf0.5Zr0.5O2, HZO) in the HZO/Al2O3 ferroelectric/dielectric stack is investigated systematically by capacitance-voltage and polarization-voltage measurements. The thickness of dielectric layer is found to have a determinant impact on the ferroelectric polarization switching of ferroelectric HZO. A suppression of ferroelectricity is observed with thick dielectric layer. In the gate stacks with thin dielectric layers, a full polarization switching of the ferroelectric layer is found possible by the proposed leakage-current-assist mechanism through the ultrathin dielectric layer. Theoretical simulation results agree well with experimental data. This work clarifies some of the critical parts of the long-standing confusions and debating related to negative capacitance field-effect transistors (NC-FETs) concepts and experiments.
Luminescent colloidal CdSe nanorings are a new type of semiconductor structure that have attracted interest due to the potential for unique physics arising from their non-trivial toroidal shape. However, the exciton properties and dynamics of these materials with complex topology are not yet well understood. Here, we use a combination of femtosecond vibrational spectroscopy, temperature-resolved photoluminescence (PL), and single particle measurements to study these materials. We find that on transformation of CdSe nanoplatelets to nanorings, by perforating the center of platelets, the emission lifetime decreases and the emission spectrum broadens due to ensemble variations in the ring size and thickness. The reduced PL quantum yield of nanorings (~10%) compared to platelets (~30%) is attributed to an enhanced coupling between: (i) excitons and CdSe LO-phonons at 200 cm-1 and (ii) negatively charged selenium-rich traps which give nanorings a high surface charge (~-50 mV). Population of these weakly emissive trap sites dominates the emission properties with an increased trap emission at low temperatures relative to excitonic emission. Our results provide a detailed picture of the nature of excitons in nanorings and the influence of phonons and surface charge in explaining the broad shape of the PL spectrum and the origin of PL quantum yield losses. Furthermore, they suggest that the excitonic properties of nanorings are not solely a consequence of the toroidal shape but are also a result of traps introduced by puncturing the platelet center.
Understanding the resistive switching behavior, or the resistance change, of oxide-based memristor devices, is critical to predicting their responses with known electrical inputs. Also, with the known electrical response of a memristor, one can confirm its usefulness in non-volatile memory and/or in artificial neural networks. Although bi- or multi-layered oxides have been reported to improve the switching performance, compared to the single oxide layer, the detailed explanation about why the switching can easily be improved for some oxides combinations is still missing. Herein, we fabricated two types of bi-layered heterostructure devices, quasi-HfO$_x$/AlO$_y$ and AlO$_y$/HfO$_x$ sandwiched between Au electrodes, and their electrical responses are investigated. For a deeper understanding of the switching mechanism, the performance of a HfOx only device is also considered, which serves as a control device. The role of bi-layered heterostructures is investigated using both the experimental and simulated results. Our results suggest that synergistic switching performance can be achieved with a proper combination of these materials and/or devices. These results open the avenue for designing more efficient double- or multi-layers memristor devices for an analog response.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
