Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userLow-Frequency 1/f Noise in MoS2 Thin-Film Transistors: Comparison of Single and Multilayer Structures
291
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
We report on the transport and low-frequency noise measurements of MoS2 thin-film transistors with thin (2-3 atomic layers) and thick (15-18 atomic layers) channels. The back-gated transistors made with the relatively thick MoS2 channels have advantages of the higher electron mobility and lower noise level. The normalized noise spectral density of the low-frequency 1/f noise in thick MoS2 transistors is of the same level as that in graphene. The MoS2 transistors with the atomically thin channels have substantially higher noise levels. It was established that, unlike in graphene devices, the noise characteristics of MoS2 transistors with thick channels (15-18 atomic planes) could be described by the McWhorter model. Our results indicate that the channel thickness optimization is crucial for practical applications of MoS2 thin-film transistors.
rate research
Read More
We report on the results of the low-frequency (1/f, where f is frequency) noise measurements in MoS2 field-effect transistors revealing the relative contributions of the MoS2 channel and Ti/Au contacts to the overall noise level. The investigation of the 1/f noise was performed for both as fabricated and aged transistors. It was established that the McWhorter model of the carrier number fluctuations describes well the 1/f noise in MoS2 transistors, in contrast to what is observed in graphene devices. The trap densities extracted from the 1/f noise data for MoS2 transistors, are 1.5 x 10^19 eV-1cm-3 and 2 x 10^20 eV-1cm-3 for the as fabricated and aged devices, respectively. It was found that the increase in the noise level of the aged MoS2 transistors is due to the channel rather than the contact degradation. The obtained results are important for the proposed electronic applications of MoS2 and other van der Waals materials.
We have demonstrated selective gas sensing with molybdenum disulfide (MoS2) thin films transistors capped with a thin layer of hexagonal boron nitride (h-BN). The resistance change was used as a sensing parameter to detect chemical vapors such as ethanol, acetonitrile, toluene, chloroform and methanol. It was found that h-BN dielectric passivation layer does not prevent gas detection via changes in the source-drain current in the active MoS2 thin film channel. The use of h-BN cap layers (thickness H=10 nm) in the design of MoS2 thin film gas sensors improves device stability and prevents device degradation due to environmental and chemical exposure. The obtained results are important for applications of van der Waals materials in chemical and biological sensing.
We demonstrated selective gas sensing with MoS2 thin-film transistors using the change in the channel conductance, characteristic transient time and low-frequency current fluctuations as the sensing parameters. The back-gated MoS2 thin-film field-effect transistors were fabricated on Si/SiO2 substrates and intentionally aged for a month to verify reliability and achieve better current stability. The same devices with the channel covered by 10 nm of Al2O3 were used as reference samples. The exposure to ethanol, acetonitrile, toluene, chloroform, and methanol vapors results in drastic changes in the source-drain current. The current can increase or decrease by more than two-orders of magnitude depending on the analyte. The reference devices with coated channel did not show any response. It was established that transient time of the current change and the normalized spectral density of the low-frequency current fluctuations can be used as additional sensing parameters for selective gas detection with thin-film MoS2 transistors.
Low frequency noise close to the carrier remains little explored in spin torque nano oscillators. However, it is crucial to investigate as it limits the oscillators frequency stability. This work addresses the low offset frequency flicker noise of a TMR-based spin-torque vortex oscillator in the regime of large amplitude steady oscillations. We first phenomenologically expand the nonlinear auto-oscillator theory aiming to reveal the properties of this noise. We then present a thorough experimental study of the oscillators $1/f$ flicker noise and discuss the results based on the theoretical predictions. Hereby, we connect the oscillators nonlinear dynamics with the concept of flicker noise and furthermore refer to the influence of a standard $1/f$ noise description based on the Hooge formula, taking into account the non-constant magnetic oscillation volume, which contributes to the magnetoresistance.
We report the realization of field-effect transistors (FETs) made with chemically synthesized multilayer 2D crystal semiconductor MoS2. Electrical properties such as the FET mobility, subthreshold swing, on/off ratio, and contact resistance of chemically synthesized (s-) MoS2 are indistinguishable from that of mechanically exfoliated (x-) MoS2, however flat-band voltages are different, possibly due to polar chemical residues originating in the transfer process. Electron diffraction studies and Raman spectroscopy show the structural similarity of s-MoS2 to x-MoS2. This initial report on the behavior and properties of s-MoS2 illustrates the feasibility of electronic devices using synthetic layered 2D crystal semiconductors.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
