اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدTuning of Fermi Contour Anisotropy in GaAs (001) 2D Holes via Strain
147
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We demonstrate tuning of the Fermi contour anisotropy of two-dimensional (2D) holes in a symmetric GaAs (001) quantum well via the application of in-plane strain. The ballistic transport of high-mobility hole carriers allows us to measure the Fermi wavevector of 2D holes via commensurability oscillations as a function of strain. Our results show that a small amount of in-plane strain, on the order of $10^{-4}$, can induce significant Fermi wavevector anisotropy as large as 3.3, equivalent to a mass anisotropy of 11 in a parabolic band. Our method to tune the anisotropy textit{in situ} provides a platform to study the role of anisotropy on phenomena such as the fractional quantum Hall effect and composite fermions in interacting 2D systems.
قيم البحث
اقرأ أيضاً
We report a severe, spin-dependent, Fermi contour anisotropy induced by parallel magnetic field in a high-mobility (001) GaAs two-dimensional hole system. Employing commensurability oscillations created by a unidirectional, surface-strain-induced, pe
riodic potential modulation, we directly probe the anisotropy of the two spin subband Fermi contours. Their areas are obtained from the Fourier transform of the Shubnikov-de Haas oscillations. Our findings are in semi-quantitative agreement with the results of parameter-free calculations of the energy bands.
There has been a surge of recent interest in the role of anisotropy in interaction-induced phenomena in two-dimensional (2D) charged carrier systems. A fundamental question is how an anisotropy in the energy-band structure of the carriers at zero mag
netic field affects the properties of the interacting particles at high fields, in particular of the composite fermions (CFs) and the fractional quantum Hall states (FQHSs). We demonstrate here tunable anisotropy for holes and hole-flux CFs confined to GaAs quantum wells, via applying textit{in situ} in-plane strain and measuring their Fermi wavevector anisotropy through commensurability oscillations. For strains on the order of $10^{-4}$ we observe significant deformations of the shapes of the Fermi contours for both holes and CFs. The measured Fermi contour anisotropy for CFs at high magnetic field ($alpha_mathrm{CF}$) is less than the anisotropy of their low-field hole (fermion) counterparts ($alpha_mathrm{F}$), and closely follows the relation: $alpha_mathrm{CF} = sqrt{alpha_mathrm{F}}$. The energy gap measured for the $ u = 2/3$ FQHS, on the other hand, is nearly unaffected by the Fermi contour anisotropy up to $alpha_mathrm{F} sim 3.3$, the highest anisotropy achieved in our experiments.
It is demonstrated that the electric dipole layer due to the overlapping of electron wavefunctions at metal/graphene contact results in negative Fermi-level pinning effect on the region of GaAs surface with low interface-trap density in metal/graphen
e/n-GaAs(001) junction. The graphene interlayer takes a role of diffusion barrier preventing the atomic intermixing at interface and preserving the low interface-trap density region. The negative Fermi-level pinning effect is supported by the Schottky barrier decreasing as metal work-function increasing. Our work shows that the graphene interlayer can invert the effective work-function of metal between $high$ and $low$, making it possible to form both Schottky and Ohmic-like contacts with identical (particularly $high$ work-function) metal electrodes on a semiconductor substrate possessing low surface-state density.
By performing density functional theory-based ab-initio calculations, Raman active phonon modes of novel single-layer two-dimensional (2D) materials and the effect of in-plane biaxial strain on the peak frequencies and corresponding activities of the
Raman active modes are calculated. Our findings confirm the Raman spectrum of the unstrained 2D crystals and provide expected variations in the Raman active modes of the crystals under in-plane biaxial strain. The results are summarized as follows; (i) frequencies of the phonon modes soften (harden) under applied tensile (compressive) strains, (ii) the response of the Raman activities to applied strain for the in-plane and out-of-plane vibrational modes have opposite trends, thus, the built-in strains in the materials can be monitored by tracking the relative activities of those modes, (iii) in particular, the A-peak in single-layer Si and Ge disappear under a critical tensile strain, (iv) especially in mono and di- atomic single-layers, the shift of the peak frequencies is stronger indication of the strain rather than the change in Raman activities, (v) Raman active modes of single-layer ReX 2 (X=S, Se) are almost irresponsive to the applied strain. Strain-induced modifications in the Raman spectrum of 2D materials in terms of the peak positions and the relative Raman activities of the modes could be a convenient tool for characterization.
The physical properties of two-dimensional van der Waals (2D vdW) crystals depend sensitively on the interlayer coupling, which is intimately connected to the stacking arrangement and the interlayer spacing. For example, simply changing the twist ang
le between graphene layers can induce a variety of correlated electronic phases, which can be controlled further in a continuous manner by applying hydrostatic pressure to decrease the interlayer spacing. In the recently discovered 2D magnets, theory suggests that the interlayer exchange coupling strongly depends on layer separation, while the stacking arrangement can even change the sign of the magnetic exchange, thus drastically modifying the ground state. Here, we demonstrate pressure tuning of magnetic order in the 2D magnet CrI3. We probe the magnetic states using tunneling and scanning magnetic circular dichroism microscopy measurements. We find that the interlayer magnetic coupling can be more than doubled by hydrostatic pressure. In bilayer CrI3, pressure induces a transition from layered antiferromagnetic to ferromagnetic phases. In trilayer CrI3, pressure can create coexisting domains of three phases, one ferromagnetic and two distinct antiferromagnetic. The observed changes in magnetic order can be explained by changes in the stacking arrangement. Such coupling between stacking order and magnetism provides ample opportunities for designer magnetic phases and functionalities.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
