اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدThe EXPLORE Project: A Deep Search for Transiting Extra-Solar Planets
87
0
0.0
(
0
)
تأليف
H. K. C. Yee
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Searching for transits provides a very promising technique for finding close-in extra-solar planets. Transiting planets present the advantage of allowing one to determine physical properties such as mass and radius unambiguously. The EXPLORE (EXtra-solar PLanet Occultation REsearch) project is a transit search project carried out using wide-field CCD imaging cameras on 4-m class telescopes, and 8-10m class telescopes for radial velocity verification of the photometric candidates. We describe some of the considerations that go into the design of the EXPLORE transit search to maximize the discovery rate and minimize contaminating objects that mimic transiting planets. We show that high precision photometry (2 to 10 millimag) and high time sampling (few minutes) are crucial for sifting out contaminating signatures, such as grazing binaries. We have completed two searches using the 8k MOSAIC camera at the CTIO4m and the CFH12k camera at CFHT, with runs covering 11 and 16 nights, respectively. We obtained preliminary light curves for approximately 47,000 stars with better than ~1% photometric precision. A number of light curves with flat-bottomed eclipses consistent with being produced by transiting planets has been discovered. Preliminary results from follow-up spectroscopic observations using the VLT UVES spectrograph and the Keck HIRES spectrograph obtained for a number of the candidates are presented. Data from four of these can be interpreted consistently as possible planet candidates, although further data are still required for definitive confirmations.
قيم البحث
اقرأ أيضاً
(Abridged) We discuss the design considerations of the EXPLORE (EXtra-solar PLanet Occultation REsearch) project, a series of transiting planet searches using 4-m-class telescopes to continuously monitor a single field of stars in the Galactic Plane
in each ~2 week observing campaign. We discuss the general factors which determine the efficiency and the number of planets found by a transit search, including time sampling strategy and field selection. The primary goal is to select the most promising planet candidates for radial velocity follow-up observations. We show that with very high photometric precision light curves that have frequent time sampling and at least two detected transits, it is possible to uniquely solve for the main parameters of the eclipsing system (including planet radius) based on several important assumptions about the central star. Together with a measured spectral type for the star, this unique solution for orbital parameters provides a powerful method for ruling out most contaminants to transiting planet candidates. For the EXPLORE project, radial velocity follow-up observations for companion mass determination of the best candidates are done on 8-m-class telescopes within two or three months of the photometric campaigns. This same-season follow-up is made possible by the use of efficient pipelines to produce high quality light curves within weeks of the observations. We conclude by presenting early results from our first search, EXPLORE I, in which we reached <1% rms photometric precision (measured over a full night) on ~37,000 stars to I <= 18.2.
One of the obstacles in the search for exoplanets via transits is the large number of candidates that must be followed up, few of which ultimately prove to be exoplanets. Any method that could make this process more efficient by somehow identifying t
he best candidates and eliminating the worst would therefore be very useful. Seager and Mallen-Ornelas (2003) demonstrated that it was possible to discern between blends and exoplanets using only the photometric characteristics of the transits. However, these techniques are critically dependent on the shape of the transit, characterization of which requires very high precision photometry of a sort that is atypical for candidates identified from transit searches. We present a method relying only on transit duration, depth, and period, which require much less precise photometry to determine accurately. The numerical tool we derive, the exoplanet diagnostic eta, is intended to identify the subset of candidates from a transit search that is most likely to contain exoplanets, and thus most worthy of subsequent follow-up studies. The effectiveness of the diagnostic is demonstrated with its success in separating modeled exoplanetary transits and interlopers, and by applying it to actual OGLE transit candidates.
The EXPLORE Project is a series of searches for transiting extrasolar planets using large-format mosaic CCD cameras on 4-m class telescopes. Radial velocity follow-up is done on transiting planet candidates with 8--10m class telescopes. We present a
summary of transit candidates from the EXPLORE Project for which we have radial velocity data.
We present preliminary results from our spectroscopic search for planets within 1 AU of metal-poor field dwarfs using NASA time with HIRES on Keck I. The core accretion model of gas giant planet formation is sensitive to the metallicity of the raw ma
terial, while the disk instability model is not. By observing metal-poor stars in the field we eliminate the role of dynamical interactions in dense stellar environments, such as a globular cluster. The results of our survey should allow us to distinguish the relative roles of the two competing giant planet formation scenarios.
We present a model of the stellar populations in the fields observed by one of the SuperWASP-N cameras in the 2004 observing season. We use the Besancon Galactic model to define the range of stellar types and metallicities present, and populate these
objects with transiting extra-solar planets using the metallicity relation of Fischer & Valenti (2005). We investigate the ability of SuperWASP to detect these planets in the presence of realistic levels of correlated systematic noise (`red noise). We find that the number of planets that transit with a signal-to-noise ratio of 10 or more increases linearly with the number of nights of observations. Based on a simulation of detection rates across 20 fields observed by one camera, we predict that a total of 18.6 pm 8.0 planets should be detectable from the SuperWASP-N 2004 data alone. The best way to limit the impact of co-variant noise and increase the number of detectable planets is to boost the signal-to-noise ratio, by increasing the number of observed transits for each candidate transiting planet. This requires the observing baseline to be increased, by spending a second observing season monitoring the same fields.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
