اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدModelling the transfer function of two-dimensional SQUID and SQIF arrays with thermal noise
119
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We present a theoretical model for 2D SQUID and SQIF arrays with over-damped Josephson junctions for uniform bias current injection at 77 K. Our simulations demonstrate the importance of including Johnson thermal noise and reveal that the mutual inductive coupling between SQUID loops is of minor importance. Our numerical results establish the validity of a simple scaling behaviour between the voltages of 1D and 2D SQUID arrays and show that the same scaling behaviour applies to the maximum transfer functions. The maximum transfer function of a 2D SQUID array can be further optimised by applying the optimal bias current which depends on the SQUID loop self-inductance and the junction critical current. Our investigation further reveals that a scaling behaviour exits between the maximum transfer function of a 2D SQUID array and that of a single dc-SQUID. Finally, we investigate the voltage response of 1D and 2D SQIF arrays and illustrate the effects of adding spreads in the heights and widths of SQUID loops.
قيم البحث
اقرأ أيضاً
We investigate theoretically the effect of the coupling radius on the transfer function in 1D and 2D SQUID arrays with different number of Josephson junctions in parallel and series at 77 K. Our results show a plateauing of the array maximum transfer
function with the number of junctions in parallel. The plateauing defines the array coupling radius which we show increases with decreasing the normalised impedance of the SQUID loop inductance. The coupling radius is found to be independent of the number of junctions in series. Finally, we investigate the voltage versus magnetic field response and maximum transfer function of one 1D and two 2D SQIF arrays with different SQUID loop area distributions.
A superconducting quantum interference device with differential output or DSQUID was proposed earlier for operation in the presence of large common-mode signals. The DSQUID is the differential connection of two identical SQUIDs. Here we show that bes
ides suppression of electromagnetic interference this device provides effective linearization of DC SQUID voltage response. In the frame of the resistive shunted junction model with zero capacitance, we demonstrate that Spur-Free Dynamic Range (SFDR) of DSQUID magnetic flux-to-voltage transfer function is higher than SFDR > 100 dB while Total Harmonic Distortion (THD) of a signal is less than THD < $10^{-3}%$ with a peak-to-peak amplitude of a signal being a quarter of half flux quantum, $2Phi_a = Phi_0/8$. Analysis of DSQUID voltage response stability to a variation of the circuit parameters shows that DSQUID implementation allows doing highly linear magnetic flux-to-voltage transformation at the cost of a high identity of Josephson junctions and high-precision current supply.
The diamagnetic susceptibility of a superconductor is directly related to its superfluid density. Mutual inductance is a highly sensitive method for characterizing thin films; however, in traditional mutual inductance measurements, the measured respo
nse is a non-trivial average over the area of the mutual inductance coils, which are typically of millimeter size. Here we image localized, isolated features in the diamagnetic susceptibility of {delta}-doped SrTiO3, the 2-DES at the interface between LaAlO3 and SrTiO3, and Nb superconducting thin film systems using scanning superconducting quantum interference device susceptometry, with spatial resolution as fine as 0.7 {mu}m. We show that these features can be modeled as locally suppressed superfluid density, with a single parameter that characterizes the strength of each feature. This method provides a systematic means of finding and quantifying submicron defects in two-dimensional superconductors.
We present a new theoretical framework to analyze microwave amplifiers based on the dc SQUID. Our analysis applies input-output theory generalized for Josephson junction devices biased in the running state. Using this approach we express the high fre
quency dynamics of the SQUID as a scattering between the participating modes. This enables us to elucidate the inherently nonreciprocal nature of gain as a function of bias current and input frequency. This method can, in principle, accommodate an arbitrary number of Josephson harmonics generated in the running state of the junction. We report detailed calculations taking into account the first few harmonics that provide simple semi-quantitative results showing a degradation of gain, directionality and noise of the device as a function of increasing signal frequency. We also discuss the fundamental limits on device performance and applications of this formalism to real devices.
We study the critical depinning current J_c, as a function of the applied magnetic flux Phi, for quasiperiodic (QP) pinning arrays, including one-dimensional (1D) chains and two-dimensional (2D) arrays of pinning centers placed on the nodes of a five
-fold Penrose lattice. In 1D QP chains of pinning sites, the peaks in J_c(Phi) are shown to be determined by a sequence of harmonics of long and short periods of the chain. This sequence includes as a subset the sequence of successive Fibonacci numbers. We also analyze the evolution of J_c(Phi) while a continuous transition occurs from a periodic lattice of pinning centers to a QP one; the continuous transition is achieved by varying the ratio gamma = a_S/a_L of lengths of the short a_S and the long a_L segments, starting from gamma = 1 for a periodic sequence. We find that the peaks related to the Fibonacci sequence are most pronounced when gamma is equal to the golden mean. The critical current J_c(Phi) in QP lattice has a remarkable self-similarity. This effect is demonstrated both in real space and in reciprocal k-space. In 2D QP pinning arrays (e.g., Penrose lattices), the pinning of vortices is related to matching conditions between the vortex lattice and the QP lattice of pinning centers. Although more subtle to analyze than in 1D pinning chains, the structure in J_c(Phi) is determined by the presence of two different kinds of elements forming the 2D QP lattice. Indeed, we predict analytically and numerically the main features of J_c(Phi) for Penrose lattices. Comparing the J_cs for QP (Penrose), periodic (triangular) and random arrays of pinning sites, we have found that the QP lattice provides an unusually broad critical current J_c(Phi), that could be useful for practical applications demanding high J_cs over a wide range of fields.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
