اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSTAR: Simultaneous Transmission And Reflection for 360{deg} Coverage by Intelligent Surfaces
160
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
A novel simultaneously transmitting and reflecting (STAR) system design relying on reconfigurable intelligent surfaces (RISs) is conceived. First, an existing prototype is reviewed and the potential benefits of STAR-RISs are discussed. Then, the key differences between conventional reflecting-only RISs and STAR-RISs are identified from the perspectives of hardware design, physics principles, and communication system design. Furthermore, the basic signal model of STAR-RISs is introduced, and three practical protocols are proposed for their operation, namely energy splitting, mode switching, and time switching. Based on the proposed protocols, a range of promising application scenarios are put forward for integrating STAR-RISs into next-generation wireless networks. By considering the downlink of a typical RIS-aided multiple-input single-output (MISO) system, numerical case studies are provided for revealing the superiority of STAR-RISs over other baselines, when employing the proposed protocols. Finally, several open research problems are discussed.
قيم البحث
اقرأ أيضاً
Reconfigurable intelligent surfaces (RISs) are planar structures with attached electronic circuitry that enable a partially programmable communication environment. RIS operation can be regarded as nearly passive since it acts by simply reflecting the
impinging traveling waves towards desired directions, thus requiring energy only for the reconfiguration of its reflective elements (REs). This paper tackles the problem of wirelessly powering RIS circuitry via control signaling. Simultaneous wireless information and power transfer (SWIPT) is considered by taking into account two basic principles: that signal quality of the control signals is sufficient for information detection, and that there is enough harvested energy for the reconfiguration. Some of the most common SWIPT receivers (time sharing, power splitting, dynamic power splitting, and antenna selection) are studied and the corresponding proposed optimization problems implementing the aforementioned principles are formulated and solved in closed form. Numerical results show the effectiveness of the proposed methods in the presence of received power fluctuations.
In this work, we investigate a novel simultaneous transmission and reflection reconfigurable intelligent surface (RIS)-assisted multiple-input multiple-output downlink system, where three practical transmission protocols, namely, energy splitting (ES
), mode selection (MS), and time splitting (TS), are studied. For the system under consideration, we maximize the weighted sum rate with multiple coupled variables. To solve this optimization problem, a block coordinate descent algorithm is proposed to reformulate this problem and design the precoding matrices and the transmitting and reflecting coefficients (TARCs) in an alternate manner. Specifically, for the ES scheme, the precoding matrices are solved using the Lagrange dual method, while the TARCs are obtained using the penalty concave-convex method. Additionally, the proposed method is extended to the MS scheme by solving a mixed-integer problem. Moreover, we solve the formulated problem for the TS scheme using a one-dimensional search and the Majorization-Minimization technique. Our simulation results reveal that: 1) Simultaneous transmission and reflection RIS (STAR-RIS) can achieve better performance than reflecting-only RIS; 2) In unicast communication, TS scheme outperforms the ES and MS schemes, while in broadcast communication, ES scheme outperforms the TS and MS schemes.
Large-scale antenna arrays employed by the base station (BS) constitute an essential next-generation communications technique. However, due to the constraints of size, cost, and power consumption, it is usually considered unrealistic to use a large-s
cale antenna array at the user side. Inspired by the emerging technique of reconfigurable intelligent surfaces (RIS), we firstly propose the concept of user-side RIS (US-RIS) for facilitating the employment of a large-scale antenna array at the user side in a cost- and energy-efficient way. In contrast to the existing employments of RIS, which belong to the family of base-station-side RISs (BSS-RISs), the US-RIS concept by definition facilitates the employment of RIS at the user side for the first time. This is achieved by conceiving a multi-layer structure to realize a compact form-factor. Furthermore, our theoretical results demonstrate that, in contrast to the existing single-layer structure, where only the phase of the signal reflected from RIS can be adjusted, the amplitude of the signal penetrating multi-layer US-RIS can also be partially controlled, which brings about a new degree of freedom (DoF) for beamformer design that can be beneficially exploited for performance enhancement. In addition, based on the proposed multi-layer US-RIS, we formulate the signal-to-noise ratio (SNR) maximization problem of US-RIS-aided communications. Due to the non-convexity of the problem introduced by this multi-layer structure, we propose a multi-layer transmit beamformer design relying on an iterative algorithm for finding the optimal solution by alternately updating each variable. Finally, our simulation results verify the superiority of the proposed multi-layer US-RIS as a compact realization of a large-scale antenna array at the user side for uplink transmission.
In this letter, simultaneous transmitting and reflecting reconfigurable intelligent surfaces (STAR-RISs) are studied. Compared with the conventional reflecting-only RISs, the coverage of STAR-RISs is extended to 360 degrees via simultaneous transmiss
ion and reflection. A general hardware model for STAR-RISs is presented. Then, channel models are proposed for the near-field and the far-field scenarios, base on which the diversity gain of the STAR-RISs is analyzed and compared with that of the conventional RISs. Numerical simulations are provided to verify analytical results and to demonstrate that full diversity order can be achieved on both sides of the STAR-RIS.
The recent development of metasurfaces has motivated their potential use for improving the performance of wireless communication networks by manipulating the propagation environment through nearly-passive sub-wavelength scattering elements arranged o
n a surface. However, most studies of this technology focus on reflective metasurfaces, i.e., the surface reflects the incident signals towards receivers located on the same side of the transmitter, which restricts the coverage to one side of the surface. In this article, we introduce the concept of intelligent omni-surface (IOS), which is able to serve mobile users on both sides of the surface to achieve full-dimensional communications by jointly engineering its reflective and refractive properties. The working principle of the IOS is introduced and a novel hybrid beamforming scheme is proposed for IOS-based wireless communications. Moreover, we present a prototype of IOS-based wireless communications and report experimental results. Furthermore, potential applications of the IOS to wireless communications together with relevant research challenges are discussed.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
