اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدRe-estimating the Spin Parameter of the Black Hole in Cygnus X-1
122
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Cygnus X-1 is a well-studied persistent black hole X-ray binary. Recently, the three parameters needed to estimate the black hole spin of this system, namely the black hole mass $M$, the orbital inclination $i$ and the source distance $D$, have been updated. In this work we redetermine the spin parameter using the continuum-fitting technique for those updated parameter values. Based on the assumption that the spin axis of the black hole is aligned with the orbital plane, we fit the thermal disk component to a fully relativistic thin accretion disk model. The error in the spin estimate arising from the combined observational uncertainties is obtained via Monte Carlo (MC) simulations. We demonstrate that, without considering the counteracting torque effect, the new spin parameter is constrained to be a$_* > 0.9985$ (3$sigma$), which confirms that the spin of the black hole in Cygnus X-1 is extreme.
قيم البحث
اقرأ أيضاً
The compact primary in the X-ray binary Cygnus X-1 was the first black hole to be established via dynamical observations. We have recently determined accurate values for its mass and distance, and for the orbital inclination angle of the binary. Buil
ding on these results, which are based on our favored (asynchronous) dynamical model, we have measured the radius of the inner edge of the black holes accretion disk by fitting its thermal continuum spectrum to a fully relativistic model of a thin accretion disk. Assuming that the spin axis of the black hole is aligned with the orbital angular momentum vector, we have determined that Cygnus X-1 contains a near-extreme Kerr black hole with a spin parameter a/M>0.95 (3sigma). For a less probable (synchronous) dynamical model, we find a/M>0.92 (3sigma). In our analysis, we include the uncertainties in black hole mass, orbital inclination angle and distance, and we also include the uncertainty in the calibration of the absolute flux via the Crab. These four sources of uncertainty totally dominate the error budget. The uncertainties introduced by the thin-disk model we employ are particularly small in this case given the extreme spin of the black hole and the disks low luminosity.
Black-hole binary (BHB) systems comprise a stellar-mass black hole and a closely orbiting companion star. Matter is transferred from the companion to the black hole, forming an accretion disk, corona and jet structures. The resulting release of gravi
tational energy leads to emission of X-rays. The radiation is affected by special/general relativistic effects, and can serve as a probe of the properties of the black hole and surrounding environment, if the accretion geometry is properly identified. Two competing models describe the disk-corona geometry for the hard spectral state of BHBs, based on spectral and timing measurements. Measuring the polarization of hard X-rays reflected from the disk allows the geometry to be determined. The extent of the corona differs between the two models, affecting the strength of relativistic effects (e.g., enhancement of polarization fraction and rotation of polarization angle). Here, we report observational results on linear polarization of hard X-ray (19-181 keV) emission from a BHB, Cygnus X-1, in the hard state. The low polarization fraction, <8.6% (upper limit at 90% confidence level), and the alignment of the polarization angle with the jet axis show that the dominant emission is not influenced by strong gravity. When considered together with existing spectral and timing data, our result reveals that the accretion corona is either an extended structure, or is located far from the black hole in the hard state of Cygnus X-1.
Because of their inherently high flux allowing the detection of clear signals, black hole X-ray binaries are interesting candidates for polarization studies, even if no polarization signals have been observed from them before. Such measurements would
provide further detailed insight into these sources emission mechanisms. We measured the polarization of the gamma-ray emission from the black hole binary system Cygnus X-1 with the INTEGRAL/IBIS telescope. Spectral modeling of the data reveals two emission mechanisms: The 250-400 keV data are consistent with emission dominated by Compton scattering on thermal electrons and are weakly polarized. The second spectral component seen in the 400keV-2MeV band is by contrast strongly polarized, revealing that the MeV emission is probably related to the jet first detected in the radio band.
The knowledge of the spectral state of a black hole is essential for the interpretation of data from black holes in terms of their emission models. Based on pointed observations of Cyg X-1 with the Rossi X-ray timing Explorer (RXTE) that are used to
classify simultaneous RXTE-ASM observations, we develop a scheme based on RXTE -ASM colors and count rates that can be used to classify all observations of this canonical black hole that were performed between 1996 and 2011. We show that a simple count rate criterion, as used previously, leads to a significantly higher fraction of misclassified observations. This scheme enables us to classify single INTEGRAL-IBIS science windows and to obtain summed spectra for the soft, intermediate and hard state with low contamination by other states.
We present the analysis of an extended textit{INTEGRAL} dataset of the high-mass microquasar Cygnus X-1. We first classify, in a model-independent way, all the textit{INTEGRAL} individual pointings taken between 2003 and 2016 in three basic spectral
states. This, in particular, allows us to triple the exposure time of the soft state in comparison with previous publication. We then study the spectral properties of the 5--400 keV stacked spectra of the soft and hard states and provide the parameters obtained with our modelling. Using a refined alternative method of extracting the Compton double events of the IBIS telescope, we then extract high-energy ($>$400 keV) spectra in the two states. We do detect an hard tail in both states. Our refined analysis allows us to obtain a hard state (count) spectrum at a flux lower than previously published by our team. Although a full estimate of the calibration property of this improved software is still needed, this seems to be more inline with the hard state hard tail seen with other instruments.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
