ترغب بنشر مسار تعليمي؟ اضغط هنا

Low thermal conductivity of iron-silicon alloys at Earth core conditions with implications for the geodynamo

66   0   0.0 ( 0 )
 نشر من قبل Wen-Pin Hsieh
 تاريخ النشر 2020
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Earth core is composed of iron (Fe) alloyed with light elements, e.g., silicon (Si). Its thermal conductivity critically affects Earth thermal structure, evolution, and dynamics, as it controls the magnitude of thermal and compositional sources required to sustain a geodynamo over Earth history. Here we directly measured thermal conductivities of solid Fe and Fe-Si alloys up to 144 GPa and 3300 K. 15 at% Si alloyed in Fe substantially reduces its conductivity by about 2 folds at 132 GPa and 3000 K. An outer core with 15 at% Si would have a conductivity of about 20 W m-1 K-1, lower than pure Fe at similar pressure-temperature conditions. This suggests a lower minimum heat flow, around 3 TW, across the core-mantle boundary than previously expected, and thus less thermal energy needed to operate the geodynamo. Our results provide key constraints on inner core age that could be older than two billion-years.

قيم البحث

اقرأ أيضاً

The Earth acts as a gigantic heat engine driven by decay of radiogenic isotopes and slow cooling, which gives rise to plate tectonics, volcanoes, and mountain building. Another key product is the geomagnetic field, generated in the liquid iron core b y a dynamo running on heat released by cooling and freezing to grow the solid inner core, and on chemical convection due to light elements expelled from the liquid on freezing. The power supplied to the geodynamo, measured by the heat-flux across the core-mantle boundary (CMB), places constraints on Earths evolution. Estimates of CMB heat-flux depend on properties of iron mixtures under the extreme pressure and temperature conditions in the core, most critically on the thermal and electrical conductivities. These quantities remain poorly known because of inherent difficulties in experimentation and theory. Here we use density functional theory to compute these conductivities in liquid iron mixtures at core conditions from first principles- the first directly computed values that do not rely on estimates based on extrapolations. The mixtures of Fe, O, S, and Si are taken from earlier work and fit the seismologically-determined core density and inner-core boundary density jump. We find both conductivities to be 2-3 times higher than estimates in current use. The changes are so large that core thermal histories and power requirements must be reassessed. New estimates of adiabatic heat-flux give 15-16 TW at the CMB, higher than present estimates of CMB heat-flux based on mantle convection; the top of the core must be thermally stratified and any convection in the upper core driven by chemical convection against the adverse thermal buoyancy or lateral variations in CMB heat flow. Power for the geodynamo is greatly restricted and future models of mantle evolution must incorporate a high CMB heat-flux and explain recent formation of the inner core.
We report on the thermal and electrical conductivities of two liquid silicon-oxygen-iron mixtures (Fe$_{0.82}$Si$_{0.10}$O$_{0.08}$ and Fe$_{0.79}$Si$_{0.08}$O$_{0.13}$), representative of the composition of the Earths outer core at the relevant pres sure-temperature conditions, obtained from density functional theory calculations with the Kubo-Greenwood formulation. We find thermal conductivities $k$ =100 (160) W m$^{-1}$ K$^{-1}$, and electrical conductivities $sigma = 1.1 (1.3) times 10^6 Omega^{-1}$ m$^{-1}$ at the top (bottom) of the outer core. These new values are between 2 and 3 times higher than previous estimates, and have profound implications for our understanding of the Earths thermal history and the functioning of the Earths magnetic field, including rapid cooling rate for the whole core or high level of radiogenic elements in the core. We also show results for a number of structural and dynamic properties of the mixtures, including the partial radial distribution functions, mean square displacements, viscosities and speeds of sound.
The electronic state and transport properties of hot dense iron are of the utmost importance to geophysics. Combining the density functional and dynamical mean field theories we study the impact of electron correlations on electrical and thermal resi stivity of hexagonal close-packed $epsilon$-Fe at Earths core conditions. $epsilon$-Fe is found to behave as a nearly perfect Fermi liquid. The quadratic dependence of the scattering rate in Fermi liquids leads to a modification of the Wiedemann-Franz law with suppression of the thermal conductivity as compared to the electrical one. This significantly increases the electron-electron thermal resistivity which is found to be of comparable magnitude to the electron-phonon one. The implications of this effect on the dynamics of Earths core is discussed.
The electronic and thermal transport properties of the Earths core are crucial for many geophysical models such as the geodynamo model of the Earths magnetic field and of its reversals. Here we show, by considering bcc-iron and iron-rich iron-silicon alloy as a representative of the Earths core composition and applying the first-principles modeling that the spin disorder at the Earths core conditions provides an essential contribution, of order 20~$muOmega$,cm, to the electrical resistivity. This value is comparable in magnitude with the electron-phonon and with the recently estimated electron-electron scattering contributions. The origin of the spin-disorder resistivity (SDR) consists in the existence of fluctuating local moments that are stabilized at high temperatures by the magnetic entropy even at pressures at which the ground state of iron is non-magnetic. We find that electron-phonon and SDR contributions are not additive at high temperatures. We thus observe a large violation of the Matthiessen rule, not common in conventional metallic alloys at ambient conditions.
We study the low-temperature electrical and thermal conductivity of CoSi and Co$_{1-x}$M$_x$Si alloys (M = Fe, Ni; $x leq$ 0.06). Measurements show that the low-temperature electrical conductivity of Co$_{1-x}$Fe$_{x}$Si alloys decreases at $x > $ 0. 01 by an order of magnitude compared with that of pure CoSi. It was expected that both the lattice and electronic contributions to thermal conductivity would decrease in the alloys. However, our experimental results revealed that at temperatures below 20K the thermal conductivity of Fe- and Ni-containing alloys is several times larger than that of pure CoSi. We discuss possible mechanisms of the thermal conductivity enhancement. The most probable one is related to the dominant scattering of phonons by charge carriers. We propose a simple theoretical model that takes into account the complex semimetallic electronic structure of CoSi with nonequivalent valleys, and show that it explains well the increase of the lattice thermal conductivity with increasing disorder and the linear temperature dependence of the thermal conductivity in the Co$_{1-x}$Fe$_x$Si alloys below 20K.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا