اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدBulk and surface electronic states in the dosed semimetallic HfTe$boldsymbol{_2}$
94
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The dosing of layered materials with alkali metals has become a commonly used strategy in ARPES experiments. However, precisely what occurs under such conditions, both structurally and electronically, has remained a matter of debate. Here we perform a systematic study of 1T-HfTe$_2$, a prototypical semimetal of the transition metal dichalcogenide family. By utilizing photon energy-dependent angle-resolved photoemission spectroscopy (ARPES), we have investigated the electronic structure of this material as a function of Potassium (K) deposition. From the k$_z$ maps, we observe the appearance of 2D dispersive bands after electron dosing, with an increasing sharpness of the bands, consistent with the wavefunction confinement at the topmost layer. In our highest-dosing cases, a monolayer-like electronic structure emerges, presumably as a result of intercalation of the alkali metal. Here, by bringing the topmost valence band below $E_F$, we can directly measure a band overlap of $sim$ 0.2 eV. However, 3D bulk-like states still contribute to the spectra even after considerable dosing. Our work provides a reference point for the increasingly popular studies of the alkali metal dosing of semimetals using ARPES.
قيم البحث
اقرأ أيضاً
We present a comprehensive theoretical investigation of the electron-phonon contribution to the lifetime broadening of the surface states on Cu(111) and Ag(111), in comparison with high-resolution photoemission results. The calculations, including el
ectron and phonon states of the bulk and the surface, resolve the relative importance of the Rayleigh mode, being dominant for the lifetime at small hole binding energies. Including the electron-electron interaction, the theoretical results are in excellent agreement with the measured binding energy and temperature dependent lifetime broadening.
The band inversion in topological phase matters bring exotic physical properties such as the emergence of a topologically protected surface states. They strongly influence the surface electronic structures of the investigated materials and could serv
e as a good platform to gain insight into the catalytic mechanism of surface reactions. Here we synthesized high-quality bulk single crystals of the topological semimetal Co$_3$Sn$_2$S$_2$. We found that at room temperature, Co$_3$Sn$_2$S$_2$ naturally hosts the band structure of a topological semimetal. This guarantees the existence of robust surface states from the Co atoms. Bulk single crystal of Co$_3$Sn$_2$S$_2$ exposes their Kagome lattice that constructed by Co atoms and have high electrical conductivity. They serves as catalytic centers for oxygen evolution process (OER), making bonding and electron transfer more efficient due to the partially filled $e_g$ orbital. The bulk single crystal exhibits outstanding OER catalytic performance, although the surface area is much smaller than that of Co-based nanostructured catalysts. Our findings emphasize the importance of tailoring topological non-trivial surface states for the rational design of high-activity electrocatalysts.
We report high-resolution angle resolved photoemission measurements on single crystals of Pt2HgSe3 grown by high-pressure synthesis. Our data reveal a gapped Dirac nodal line whose (001)-projection separates the surface Brillouin zone in topological
and trivial areas. In the non-trivial $k$-space range we find surface states with multiple saddle-points in the dispersion resulting in two van Hove singularities in the surface density of states. Based on density functional theory calculations, we identify these surface states as signatures of a topological crystalline state which coexists with a weak topological phase.
A comprehensive bulk and surface investigation of high-quality In$_2$O$_3$(001) single crystals is reported. The transparent-yellow, cube-shaped single crystals were grown using the flux method. Inductively coupled plasma mass spectrometry (ICP-MS) r
eveals small residues of Pb, Mg, and Pt in the crystals. Four-point-probe measurements show a resistivity of 2.0 $pm$ 0.5 $times$ 10$^5$ {Omega} cm, which translates into a carrier concentration of $approx$10$^{12}$ cm$^{-3}$. The results from x-ray diffraction (XRD) measurements revise the lattice constant to 10.1150(5) {AA} from the previously accepted value of 10.117 {AA}. Scanning tunneling microscopy (STM) images of a reduced (sputtered/annealed) and oxidized (exposure to atomic oxygen at 300 {deg}C) surface show a step height of 5 {AA}, which indicates a preference for one type of surface termination. The surfaces stay flat without any evidence for macroscopic faceting under any of these preparation conditions. A combination of low-energy ion scattering (LEIS) and atomically resolved STM indicates an indium-terminated surface with small islands of 2.5 {AA} height under reducing conditions, with a surface structure corresponding to a strongly distorted indium lattice. Scanning tunneling spectroscopy (STS) reveals a pronounced surface state at the Fermi level ($E_F$). Photoelectron spectroscopy (PES) shows additional, deep-lying band gap states, which can be removed by exposure of the surface to atomic oxygen. Oxidation also results in a shoulder at the O 1s core level at a higher binding energy, possibly indicative of a surface peroxide species. A downward band bending of 0.4 eV is observed for the reduced surface, while the band bending of the oxidized surface is of the order of 0.1 eV or less.
We have performed angle-resolved photoemission spectroscopy on transition-metal dichalcogenide 1$T$-HfTe$_2$ to elucidate the evolution of electronic states upon potassium (K) deposition. In pristine HfTe$_2$, an in-plane hole pocket and electron poc
kets are observed at the Brillouin-zone center and corner, respectively, indicating the semimetallic nature of bulk HfTe$_2$, with dispersion perpendicular to the plane. In contrast, the band structure of heavily K-dosed HfTe$_2$ is obviously different from that of bulk, and resembles the band structure calculated for monolayer HfTe$_2$. It was also observed that lightly K-dosed HfTe$_2$ is characterized by quantized bands originating from bilayer and trilayer HfTe$_2$, indicative of staging. The results suggest that the dimensionality-crossover from 3D (dimensional) to 2D electronic states due to systematic K intercalation takes place via staging in a single sample. The study provides a new strategy for controlling the dimensionality and functionality of novel quantum materials.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
