اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدEffects of Al content on the oxygen permeability through dual-phase membrane 60Ce$_{0.9}$Pr$_{0.1}$O$_{2-delta}$-40Pr$_{0.6}$Sr$_{0.4}$Fe$_{1-x}$Al$_x$O$_{3-delta}$
111
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Ceramic dual-phase oxygen transport membranes with the composition of 60wt.% Ce0.9Pr0.1O2-{delta}-40wt.%Pr0.6Sr0.4Fe1-xAlxO3-{delta} (x = 0.05, 0.1, 0.2, 0.3, 0.4, 0.6, 0.8, 1.0) (60CPO-40PSF1-xAxO) based on 60Ce0.9Pr0.1O2-{delta}-40Pr0.6Sr0.4FeO3-{delta} doped Al was successfully synthesized through a modified Pechini method. Crystal structure, surface microtopography and oxygen permeability are investigated systematically. The cell parameters of perovskite phase first increased and then decreased with the increase of Al content, which is related to the radius of the Al3+ and the formation of impurity phase. As x ranges from 0.1 to 0.8, the oxygen permeability of the materials first increases and then decreases, and the maximum value of oxygen permeation rate for 60CPO-40PSF1-xAxO membranes with 0.4mm thickness at 1000 {deg}C is 1.12 mL min-1 cm-2 when x = 0.4. XRD measurements revealed high temperature stability and CO2-tolerant property of the dual-phase composites. The partial replacement of Fe$^{3+}$/Fe$^{4+}$ by Al$^{3+}$ causes the material not only to exhibit good stability, but also to increase the oxygen permeability of the membranes.
قيم البحث
اقرأ أيضاً
High stability and oxygen permeability are two prominent requirements for the oxygen transport membrane candidates used as industrialization. Herein, we report several composite membranes based on xwt.%Ce0.9Pr0.1O2(CPO)-(100-x)wt.%Pr0.6Sr0.4Fe0.8Al0.
2O3(PSFAO) (x = 50, 60 and 75) prepared via a modified Pechini method. Oxygen permeability test reveals that the 60CPO-40PSFAO composition exhibits the highest oxygen permeability. The oxygen permeation flux through the optimal uncoated 0.33 mm-thickness 60CPO-40PSFAO composite can reach 1.03 mL cm-2 min-1 (over the general requirement value of 1 mL cm-2 min-1) in air/He atmosphere at 1000 {deg}C. In situ XRD performance confirms the optimal 60CPO-40PSFAO sample shows excellent stability in CO2-containing atmospheres. The 60CPO-40PSFAO membrane still exhibits simultaneously excellent oxygen permeability and phase stability after operating for over 100 h at air/CO2 condition at 1000 {deg}C, which further indicates that the 60CPO-40PSFAO composite is likely to be used for oxygen supply in CO2 capture
While reversibility is a fundamental concept in thermodynamics, most reactions are not readily reversible, especially in solid state physics. For example, thermal diffusion is a widely known concept, used among others to inject dopant atoms into the
substitutional positions in the matrix and improve the device properties. Typically, such a diffusion process will create a concentration gradient extending over increasingly large regions, without possibility to reverse this effect. On the other hand, while the bottom up growth of semiconducting nanowires is interesting, it can still be difficult to fabricate axial heterostructures with high control. In this paper, we report a reversible thermal diffusion process occurring in the solid-state exchange reaction between an Al metal pad and a Si$_x$Ge$_{1-x}$ alloy nanowire observed by in-situ transmission electron microscopy. The thermally assisted reaction results in the creation of a Si-rich region sandwiched between the reacted Al and unreacted SixGe1-x part, forming an axial Al/Si/Si$_x$Ge$_{1-x}$ heterostructure. Upon heating or (slow) cooling, the Al metal can repeatably move in and out of the Si$_x$Ge$_{1-x}$ alloy nanowire while maintaining the rod-like geometry and crystallinity, allowing to fabricate and contact nanowire heterostructures in a reversible way in a single process step, compatible with current Si based technology. This interesting system is promising for various applications, such as phase change memories in an all crystalline system with integrated contacts, as well as Si/Si$_x$Ge$_{1-x}$/Si heterostructures for near-infrared sensing applications.
Developing good performance and low-cost oxygen permeable membranes for CO2 capture based on the oxy-fuel concept is greatly desirable but challenging. Despite tremendous efforts in exploring new CO2-stable dual-phase membranes, its presence is howev
er still far from meeting the industrial requirements. Here we report a series of new Ca-containing CO2-resistant oxygen transporting membranes with composition 60wt.%Ce0.9Ln0.1O2-40wt.%Ln0.6Ca0.4FeO3(CLnO-LnCFO; Ln = La, Pr, Nd, Sm) synthesized via a Pechini one-pot method. Our results indicate all investigated compounds are composed of perovskite and fluorite phases, while the perovskite phases in the CNO-NCFO and CSO-SCFO membranes after sintering generates Ca-rich and Ca-less two kinds of grains with different morphologies, where the Ca-less small perovskite grains block the transport of oxygen ions and eventually result in poor oxygen permeability. Among our investigated CLnO-LnCFO membranes, CPO-PCFO exhibits the highest oxygen permeability and excellent CO2 stability, which were mainly associated with the improvement in crystal symmetry, non-negligible electronic conductivity of fluorite phase and the enhancement in electronic conductivity of perovskite. Our results establish Ca-containing oxides as candidate material platforms for membrane engineering devices that combine CO2 capture and oxygen separation.
e report the effect of pressure on the steplike magnetostriction of single crystalline bilayered manganite (LaPr)1.2Sr1.8Mn2O8, for our understandings of the ultrasharp nature of the field-induced first-order transition from a paramagnetic insulator
to a ferromagnetic metal phase. The application of pressure suppresses a steplike transformation and causes a broad change in the magnetostriction. The injection of an electric current to the crystal also weakens the steplike variation in both the magnetostriction and magnetoresistance. The stabilization of ferromagnetic interaction or the delocalization of charge carriers is promoted with the applied pressure or applied current, resulting in the suppressed steplike behavior. Our findings suggest that the step phenomenon is closely related to the existence of localized carriers such as the short-range charge-orbital ordered clusters.
Hard x-ray photoelectron spectroscopy (HAXPES) and variable kinetic energy x-ray photoelectron spectroscopy (VKE-XPS) analyses have been performed on 10 unit cell La$_{(1-{delta})}$Al$_{(1+{delta})}$O$_3$ films, with La:Al ratios of 1.1, 1.0, and 0.9
, deposited on SrTiO$_3$. Of the three films, only the Al-rich film was known to have a conductive interface. VKE-XPS, coupled with maximum entropy analysis, shows significant differences in the compositional depth profile between the Al-rich, the La-rich, and stoichiometric films; significant La enrichment at the interface is observed in the La-rich and stoichiometric films, while the Al-rich shows little to no intermixing. Additionally, the La-rich and stoichiometric films show a high concentration of Al at the surface, which is not observed in the Al-rich film. HAXPES valence band (VB) analysis shows a broadening of the VB for the Al-rich sample relative to the stoichiometric and La-rich samples, which have insulating interfaces. This broadening is consistent with an electric field across the Al-rich film. These results are consistent with a defect driven electronic reconstruction.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
