اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدOn-chip correlation-based Brillouin sensing: design, experiment and simulation
171
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Wavelength-scale SBS waveguides are enabling novel on-chip functionalities. The micro- and nano-scale SBS structures and the complexity of the SBS waveguides require a characterization technique to monitor the local geometry-dependent SBS responses along the waveguide. In this work, we experimentally demonstrate detection of longitudinal features down to 200$mu$m on a silicon-chalcogenide waveguide using the Brillouin optical correlation domain analysis (BOCDA) technique. We provide simulation and analysis on how multiple acoustic and optical modes and geometrical variations influence the Brillouin spectrum.
قيم البحث
اقرأ أيضاً
Modern fiber-optic coherent communications employ advanced spectrally-efficient modulation formats that require sophisticated narrow linewidth local oscillators (LOs) and complex digital signal processing (DSP). Here, we establish a novel approach to
carrier recovery harnessing large-gain stimulated Brillouin scattering (SBS) on a photonic chip for up to 116.82 Gbit/sec self-coherent optical signals, eliminating the need for a separate LO. In contrast to SBS processing on-fiber, our solution provides phase and polarization stability while the narrow SBS linewidth allows for a record-breaking small guardband of ~265 MHz, resulting in higher spectral-efficiency than benchmark self-coherent schemes. This approach reveals comparable performance to state-of-the-art coherent optical receivers without requiring advanced DSP. Our demonstration develops a low-noise and frequency-preserving filter that synchronously regenerates a low-power narrowband optical tone that could relax the requirements on very-high-order modulation signaling and be useful in long-baseline interferometry for precision optical timing or reconstructing a reference tone for quantum-state measurements.
A highly sensitive refractive index sensor based on grating-assisted strip waveguide directional coupler is proposed. The sensor is designed using two coupled asymmetric strip waveguides with a top-loaded grating structure in one of the waveguides. M
aximum light couples from one waveguide to the other at the resonance wavelength, and the change in resonance wavelength with the change in refractive index of the medium in the cover region is a measure of the sensitivity. The proposed sensor would be an on-chip device with a high refractive index sensitivity of ~ 104 nm/RIU, and negligible temperature sensitivity (< 1nm/0C). The sensor configuration offers a low propagation loss, thereby enhancing the sensitivity. Variation of the sensitivity with the waveguide parameters of the proposed sensor have been studied to optimize the design.
Realizing highly sensitive interferometry is essential to accurate observation of quantum properties. Here we study two kinds of Ramsey interference fringes in a whispering-gallery resonator, where the coherent phonons for free evolution can be achie
ved by stimulated Brillouin scattering. These two different fringes appear, respectively, in the regimes of rotating wave approximation (RWA) and anti-RWA. Our work shows particularly that the anti-RWA Ramsey interference takes some quantum properties of squeezing, which enhances the strength and visibility of the fringes and shows robustness against the systems decay. In application, our proposal, feasible with current laboratory techniques, provides a practical idea for building better quantum interferometers.
Metasurfaces provide the disruptive technology enabling miniaturization of complex cascades of optical elements on a plane. We leverage the benefits of such a surface to develop a planar integrated photonic beam collimator for on-chip optofluidic sen
sing applications. While most of the current work focuses on miniaturizing the optical detection hardware, little attention is given to develop on-chip hardware for optical excitation. In this manuscript, we propose a flat metasurface for beam collimation in optofluidic applications. We implement an inverse design approach to optimize the metasurface using gradient descent method and experimentally compare its characteristics with conventional binary grating-based photonic beam diffractors. The proposed metasurface can enhance the illumination efficiency almost two times in on-chip applications such as fluorescence imaging, Raman and IR spectroscopy and can enable multiplexing of light sources for high throughput biosensing.
We present the first demonstration of a narrow linewidth, waveguide-based Brillouin laser which is enabled by large Brillouin gain of a chalcogenide chip. The waveguides are equipped with vertical tapers for low loss coupling. Due to optical feedback
for the Stokes wave, the lasing threshold is reduced to 360 mW, which is 5 times lower than the calculated single-pass Brillouin threshold for the same waveguide. The slope efficiency of the laser is found to be 30% and the linewidth of 100 kHz is measured using a self-heterodyne method.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
