اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدImproved 2D Intelligent Driver Model simulating synchronized flow and evolution concavity in traffic flow
65
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
This paper firstly show that 2 Dimensional Intelligent Driver Model (Jiang et al., PloS one, 9(4), e94351, 2014) is not able to replicate the synchronized traffic flow. Then we propose an improved model by considering the difference between the driving behaviors at high speeds and that at low speeds. Simulations show that the improved model can reproduce the phase transition from synchronized flow to wide moving jams, the spatiotemporal patterns of traffic flow induced by traffic bottleneck, and the evolution concavity of traffic oscillations (i.e. the standard deviation of the velocities of vehicles increases in a concave/linear way along the platoon). Validating results show that the empirical time series of traffic speed obtained from Floating Car Data can be well simulated as well.
قيم البحث
اقرأ أيضاً
Traffic breakdown, as one of the most puzzling traffic flow phenomena, is characterized by sharply decreasing speed, abruptly increasing density and in particular suddenly plummeting capacity. In order to clarify its root mechanisms and model its obs
erved properties, this paper proposes a car-following model based on the following assumptions: (i) There exists a preferred time-varied and speed-dependent space gap that cars hope to maintain; (ii) there exists a region R restricted by two critical space gaps and two critical speeds in the car following region on the speed-space gap diagram, in which cars movements are determined by the weighted mean of the space- gap-determined acceleration and the speed-difference-determined acceleration; and (iii) out of region R, cars either accelerate to the free flow speed or decelerate to keep safety. Simulation results show that this model is able to simultaneously reproduce traffic breakdown and the transition from the synchronized traffic flow to wide moving jams. To our knowledge, this is the first car-following model that is able to fully depict traffic breakdown, spontaneous formation of jams, and the concave growth of the oscillations.
In the emerging field of 3D bioprinting, cell damage due to large deformations is considered a main cause for cell death and loss of functionality inside the printed construct. Those deformations, in turn, strongly depend on the mechano-elastic respo
nse of the cell to the hydrodynamic stresses experienced during printing. In this work, we present a numerical model to simulate the deformation of biological cells in arbitrary three-dimensional flows. We consider cells as an elastic continuum according to the hyperelastic Mooney-Rivlin model. We then employ force calculations on a tetrahedralized volume mesh. To calibrate our model, we perform a series of FluidFM(R) compression experiments with REF52 cells demonstrating that all three parameters of the Mooney-Rivlin model are required for a good description of the experimental data at very large deformations up to 80%. In addition, we validate the model by comparing to previous AFM experiments on bovine endothelial cells and artificial hydrogel particles. To investigate cell deformation in flow, we incorporate our model into Lattice Boltzmann simulations via an Immersed-Boundary algorithm. In linear shear flows, our model shows excellent agreement with analytical calculations and previous simulation data.
Traffic flow forecasting is hot spot research of intelligent traffic system construction. The existing traffic flow prediction methods have problems such as poor stability, high data requirements, or poor adaptability. In this paper, we define the tr
affic data time singularity ratio in the dropout module and propose a combination prediction method based on the improved long short-term memory neural network and time series autoregressive integrated moving average model (SDLSTM-ARIMA), which is derived from the Recurrent Neural Networks (RNN) model. It compares the traffic data time singularity with the probability value in the dropout module and combines them at unequal time intervals to achieve an accurate prediction of traffic flow data. Then, we design an adaptive traffic flow embedded system that can adapt to Java, Python and other languages and other interfaces. The experimental results demonstrate that the method based on the SDLSTM - ARIMA model has higher accuracy than the similar method using only autoregressive integrated moving average or autoregressive. Our embedded traffic prediction system integrating computer vision, machine learning and cloud has the advantages such as high accuracy, high reliability and low cost. Therefore, it has a wide application prospect.
We present a new algorithm for computing balanced flows in equality networks arising in market equilibrium computations. The current best time bound for computing balanced flows in such networks requires $O(n)$ maxflow computations, where $n$ is the
number of nodes in the network [Devanur et al. 2008]. Our algorithm requires only a single parametric flow computation. The best algorithm for computing parametric flows [Gallo et al. 1989] is only by a logarithmic factor slower than the best algorithms for computing maxflows. Hence, the running time of the algorithms in [Devanur et al. 2008] and [Duan and Mehlhorn 2015] for computing market equilibria in linear Fisher and Arrow-Debreu markets improve by almost a factor of $n$.
This paper has incorporated the stochasticity into the Newell car following model. Three stochastic driving factors have been considered: (i) Drivers acceleration is bounded. (ii) Drivers deceleration includes stochastic component, which is depicted
by a deceleration with the randomization probability that is assumed to increase with the speed. (iii) Vehicles in the jam state have a larger randomization probability. Two simulation scenarios are conducted to test the model. In the first scenario, traffic flow on a circular road is investigated. In the second scenario, empirical traffic flow patterns in the NGSIM data induced by a rubberneck bottleneck is studied, and the simulated traffic oscillations and synchronized traffic flow are consistent with the empirical patterns. Moreover, two experiments of model calibration and validation are conducted. The first is to calibrate and validate using experimental data, which illustrates that the concave growth pattern has been quantitatively simulated. The second is to calibrate and cross validate vehicles trajectories using NGSIM data, which exhibits that the car following behaviors of single vehicles can be well described. Therefore, our study highlights the importance of speed dependent stochasticity in traffic flow modeling, which cannot be ignored as in most car-following studies.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
