اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدA high-Q, ultrathin-walled microbubble resonator for aerostatic pressure sensing
42
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Sensors based on whispering gallery resonators have minute footprints and can push achievable sensitivities and resolutions to their limits. Here, we use a microbubble resonator, with a wall thickness of 500 nm and an intrinsic Q-factor of $10^7$ in the telecommunications C-band, to investigate aerostatic pressure sensing via stress and strain of the material. The microbubble is made using two counter-propagating CO$_2$ laser beams focused onto a microcapillary. The measured sensitivity is 19 GHz/bar at 1.55 $mu$m. We show that this can be further improved to 38 GHz/bar when tested at the 780 nm wavelength range. In this case, the resolution for pressure sensing can reach 0.17 mbar with a Q-factor higher than $5times10^7$.
قيم البحث
اقرأ أيضاً
Frequency comb generation in microresonators at visible wavelengths has found applications in a variety of areas such as metrology, sensing, and imaging. To achieve Kerr combs based on four-wave mixing in a microresonator, dispersion must be in the a
nomalous regime. In this work, we demonstrate dispersion engineering in a microbubble resonator (MBR) fabricated by a two-CO$_2$ laser beam technique. By decreasing the wall thickness of the MBR down to 1.4 $mu$m, the zero dispersion wavelength shifts to values shorter than 764 nm, making phase matching possible around 765 nm. With the optical textit{Q}-factor of the MBR modes being greater than $10^7$, four-wave mixing is observed at 765 nm for a pump power of 3 mW. By increasing the pump power, parametric oscillation is achieved, and a frequency comb with 14 comb lines is generated at visible wavelengths.
We demonstrate an ultralow loss monolithic integrated lithium niobate photonic platform consisting of dry-etched subwavelength waveguides. We show microring resonators with a quality factor of 10$^7$ and waveguides with propagation loss as low as 2.7 dB/m.
Quantitative measurements of the vibrational eigenmodes in ultra-high-Q silica microspheres are reported. The modes are efficiently excited via radiation-pressure induced dynamical back-action of light confined in the optical whispering-gallery modes
of the microspheres (i.e. via the parametric oscillation instability). Two families of modes are studied and their frequency dependence on sphere size investigated. The measured frequencies are in good agreement both with Lambs theory and numerical finite element simulation and are found to be proportional to the spheres inverse diameter.
High Q optical resonators are a key component for ultra-narrow linewidth lasers, frequency stabilization, precision spectroscopy and quantum applications. Integration of these resonators in a photonic waveguide wafer-scale platform is key to reducing
their cost, size and power as well as sensitivity to environmental disturbances. However, to date, the intrinsic Q of integrated all-waveguide resonators has been relegated to below 150 Million. Here, we report an all-waveguide Si3N4 resonator with an intrinsic Q of 422 Million and a 3.4 Billion absorption loss limited Q. The resonator has a 453 kHz intrinsic linewidth and 906 kHz loaded linewidth, with a finesse of 3005. The corresponding linear loss of 0.060 dB/m is the lowest reported to date for an all-waveguide design with deposited upper cladding oxide. These are the highest intrinsic and absorption loss limited Q factors and lowest linewidth reported to date for a photonic integrated all-waveguide resonator. This level of performance is achieved through a careful reduction of scattering and absorption loss components. We quantify, simulate and measure the various loss contributions including scattering and absorption including surface-state dangling bonds that we believe are responsible in part for absorption. In addition to the ultra-high Q and narrow linewidth, the resonator has a large optical mode area and volume, both critical for ultra-low laser linewidths and ultra-stable, ultra-low frequency noise reference cavities. These results demonstrate the performance of bulk optic and etched resonators can be realized in a photonic integrated solution, paving the way towards photonic integration compatible Billion Q cavities for precision scientific systems and applications such as nonlinear optics, atomic clocks, quantum photonics and high-capacity fiber communications systems on-chip.
For the need of measurements focused in condensed matter physics and especially Bernoulli effect in superconductors we have developed an active resonator with dual operational amplifiers. A tunable high-Q resonator is performed in the schematics of t
he the General Impedance Converter (GIC). In the framework of frequency dependent open-loop gain of operational amplifiers, a general formula of the frequency dependence of the impedance of GIC is derived. The explicit formulas for the resonance frequency and Q-factor include as immanent parameter the crossover frequency of the operational amplifier. Voltage measurements of GIC with a lock-in amplifier perfectly agree with the derived formulas. A table reveals that electrometer operational amplifiers are the best choice to build the described resonator.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
