اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدPost-Impact Thermal Evolution of Porous Planetesimals
116
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Impacts between planetesimals have largely been ruled out as a heat source in the early Solar System, by calculations that show them to be an inefficient heat source and unlikely to cause global heating. However, the long-term, localized thermal effects of impacts on planetesimals have never been fully quantified. Here, we simulate a range of impact scenarios between planetesimals to determine the post-impact thermal histories of the parent bodies, and hence the importance of impact heating in the thermal evolution of planetesimals. We find on a local scale that heating material to petrologic type 6 is achievable for a range of impact velocities and initial porosities, and impact melting is possible in porous material at a velocity of > 4 km/s. Burial of heated impactor material beneath the impact crater is common, insulating that material and allowing the parent body to retain the heat for extended periods (~ millions of years). Cooling rates at 773 K are typically 1 - 1000 K/Ma, matching a wide range of measurements of metallographic cooling rates from chondritic materials. While the heating presented here is localized to the impact site, multiple impacts over the lifetime of a parent body are likely to have occurred. Moreover, as most meteorite samples are on the centimeter to meter scale, the localized effects of impact heating cannot be ignored.
قيم البحث
اقرأ أيضاً
Disruptive collisions have been regarded as an important process for planet formation, while non-disruptive, small-scale collisions (hereafter called erosive collisions) have been underestimated or neglected by many studies. However, recent studies h
ave suggested that erosive collisions are also important to the growth of planets, because they are much more frequent than disruptive collisions. Although the thresholds of the specific impact energy for disruptive collisions (Q_RD^*) have been investigated well, there is no reliable model for erosive collisions. In this study, we systematically carried out impact simulations of gravity-dominated planetesimals for a wide range of specific impact energy (Q_R) from disruptive collisions (Q_R ~ Q_RD^*) to erosive ones (Q_R << Q_RD^*) using the smoothed particle hydrodynamics method. We found that the ejected mass normalized by the total mass (M_ej/M_tot) depends on the numerical resolution, the target radius (R_tar) and the impact velocity (v_imp), as well as on Q_R, but that it can be nicely scaled by Q_RD^* for the parameter ranges investigated (R_tar = 30-300 km, v_imp = 2-5 km/s). This means that M_ej/M_tot depends only on Q_R/Q_RD^* in these parameter ranges. We confirmed that the collision outcomes for much less erosive collisions (Q_R < 0.01 Q_RD^*) converge to the results of an impact onto a planar target for various impact angles and that M_ej/M_tot = C * QR/QRD* holds. For disruptive collisions (Q_R ~ Q_RD^*), the curvature of the target has a significant effect on Mej/Mtot. We also examined the angle-averaged value of M_ej/M_tot and found that the numerically obtained relation between angle-averaged M_ej/M_tot and Q_R/Q_RD^* is very similar to the cases for 45-degree impacts. We proposed a new erosion model based on our numerical simulations for future research on planet formation with collisional erosion.
We model the heating of a primordial planetesimal by decay of the short-lived radionuclides Al-26 and Fe-60 to determine (i) the timescale on which melting will occur; (ii) the minimum size of a body that will produce silicate melt and differentiate;
(iii) the migration rate of molten material within the interior; and (iv) the thermal consequences of the transport of Al-26 in partial melt. Our models incorporate results from previous studies of planetary differentiation and are constrained by petrologic (i.e. grain size distributions), isotopic (e.g. Pb-Pb and Hf-W ages) and mineralogical properties of differentiated achondrites. We show that formation of a basaltic crust via melt percolation was limited by the formation time of the body, matrix grain size and viscosity of the melt. We show that low viscosity (< 1 Pa-s) silicate melt can buoyantly migrate on a timescale comparable to the mean life of Al-26. The equilibrium partitioning of Al into silicate partial melt and the migration of that melt acts to dampen internal temperatures. However, subsequent heating from the decay of Fe-60 generated melt fractions in excess of 50%, thus completing differentiation for bodies that accreted within 2 Myr of CAI formation (i.e. the onset of isotopic decay). Migration and concentration of Al-26 into a crust results in remelting of that crust for accretion times less than 2 Myr and for bodies >100 km in size. Differentiation would be most likely for planetesimals larger than 20 km in diameter that accreted within ~2.7 Myr of CAI formation.
We investigate the influence of impacts of large planetesimals and small planetary embryos on the early Martian surface on the hydrodynamic escape of an early steam atmosphere that is exposed to the high soft X-ray and EUV flux of the young Sun. Impa
ct statistics in terms of number, masses, velocities, and angles of asteroid impacts onto the early Mars are determined via n-body integrations. Based on these statistics, smoothed particle hydrodynamics (SPH) simulations result in estimates of energy transfer into the planetary surface material and according surface heating. For the estimation of the atmospheric escape rates we applied a soft X-ray and EUV absorption model and a 1-D upper atmosphere hydrodynamic model to a magma ocean-related catastrophically outgassed steam atmosphere with surface pressure values of 52 bar H2O and 11 bar CO2. The estimated impact rates and energy deposition onto an early Martian surface can account for substantial heating. The energy influx and conversion rate into internal energy is most likely sufficient to keep a shallow magma ocean liquid for an extended period of time. Higher surface temperatures keep the outgassed steam atmosphere longer in vapor form and therefore enhance its escape to space within about 0.6 Myr after its formation.
The satellites of extrasolar planets (exomoons) have been recently proposed as astrobiological targets. Since giant planets in the habitable zone are thought to have migrated there, it is possible that they may have captured a former terrestrial plan
et or planetesimal. We therefore attempt to model the dynamical evolution of a terrestrial planet captured into orbit around a giant planet in the habitable zone of a star. We find that approximately half of loose elliptical orbits result in stable circular orbits over timescales of less than a few million years. We also find that those orbits are mostly low-inclination, but have no prograde/retrograde preference. In addition, we calculate the transit timing and duration variations for the resulting systems, and find that potentially habitable Earth-mass exomoons should be detectable.
In order to examine the ``giant impact hypothesis for the Moon formation, we run the first grid-based, high-resolution hydrodynamic simulations for an impact between proto-Earth and a proto-planet. The spatial resolution for the impact-generated disk
is greatly improved from previous particle-based simulations. This allows us to explore fine structures of a circumterrestrial debris disk and its long-term evolution. We find that in order to form a debris disk from which a lunar-sized satellite can be accumulated, the impact must result in a disk of mostly liquid or solid debris, where pressure is not effective, well before the accumulation process starts. If the debris is dominated by vapor gas, strong spiral shocks are generated, and therefore the circumterrestrial disk cannot survive more than several days. This suggests that there could be an appropriate mass range for terrestrial planets to harbor a large moon as a result of giant impacts, since vaporization during an impact depends on the impact energy.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
