اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدThickness-independent transport channels in topological insulator Bi2Se3 thin films
175
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
With high quality topological insulator (TI) Bi2Se3 thin films, we report thickness-independent transport properties over wide thickness ranges. Conductance remained nominally constant as the sample thickness changed from 256 to ~8 QL (QL: quintuple layer, 1 QL = ~1 nm). Two surface channels of very different behaviors were identified. The sheet carrier density of one channel remained constant at ~3.0 x 10^13 cm^-2 down to 2 QL, while the other, which exhibited quantum oscillations, remained constant at ~8 x 10^12 cm^-2 only down to ~8 QL. The weak antilocalization parameters also exhibited similar thickness-independence. These two channels are most consistent with the topological surface states and the surface accumulation layers, respectively.
قيم البحث
اقرأ أيضاً
In ideal topological insulator (TI) films the bulk state, which is supposed to be insulating, should not provide any electric coupling between the two metallic surfaces. However, transport studies on existing TI films show that the topological states
on opposite surfaces are electrically tied to each other at thicknesses far greater than the direct coupling limit where the surface wavefunctions overlap. Here, we show that as the conducting bulk channels are suppressed, the parasitic coupling effect diminishes and the decoupled surface channels emerge as expected for ideal TIs. In Bi2Se3 thin films with fully suppressed bulk states, the two surfaces, which are directly coupled below ~10 QL, become gradually isolated with increasing thickness and are completely decoupled beyond ~20 QL. On such a platform, it is now feasible to implement transport devices whose functionality relies on accessing the individual surface layers without any deleterious coupling effects.
Thin films of topological insulators (TI) usually exhibit multiple parallel conduction channels for the transport of electrical current. Beside the topologically protected surface states (TSS), parallel channels may exist, namely the interior of the
not-ideally insulating TI film, the interface layer to the substrate, and the substrate itself. To be able to take advantage of the auspicious transport properties of the TSS, the influence of the parasitic parallel channels on the total current transport has to be minimized. Because the conductivity of the interior (bulk) of the thin TI film is difficult to access by measurements, we propose here an approach for calculating the mobile charge carrier concentration in the TI film. To this end, we calculate the near-surface band bending using parameters obtained experimentally from surface-sensitive measurements, namely (gate-dependent) four-point resistance measurements and angle-resolved photoelectron spectroscopy (ARPES). While in most cases another parameter in the calculations, i.e. the concentration of unintentional dopants inside the thin TI film, is unknown, it turns out that in the thin-film limit the band bending is largely independent of the dopant concentration in the film. Thus, a well-founded estimate of the total mobile charge carrier concentration and the conductivity of the interior of the thin TI film proves possible. Since the interface and substrate conductivities can be measured by a four-probe conductance measurement prior to the deposition of the TI film, the total contribution of all parasitic channels, and therefore also the contribution of the vitally important TSS, can be determined reliably.
We show that a number of transport properties in topological insulator (TI) Bi2Se3 exhibit striking thickness-dependences over a range of up to five orders of thickness (3 nm - 170 mu m). Volume carrier density decreased with thickness, presumably du
e to diffusion-limited formation of selenium vacancies. Mobility increased linearly with thickness in the thin film regime and saturated in the thick limit. The weak anti-localization effect was dominated by a single two-dimensional channel over two decades of thickness. The sublinear thickness-dependence of the phase coherence length suggests the presence of strong coupling between the surface and bulk states.
Electrical field control of the carrier density of topological insulators (TI) has greatly expanded the possible practical use of these materials. However, the combination of low temperature local probe studies and a gate tunable TI device remains ch
allenging. We have overcome this limitation by scanning tunneling microscopy and spectroscopy measurements on in-situ molecular beam epitaxy growth of Bi2Se3 films on SrTiO3 substrates with pre-patterned electrodes. Using this gating method, we are able to shift the Fermi level of the top surface states by 250 meV on a 3 nm thick Bi2Se3 device. We report field effect studies of the surface state dispersion, band gap, and electronic structure at the Fermi level.
The microstructure of Bi2Se3 topological-insulator thin films grown by molecular beam epitaxy on InP(111)A and InP(111)B substrates that have different surface roughnesses has been studied in detail using X-ray diffraction, X-ray reflectivity, atomic
force microscopy and probe-corrected scanning transmission electron microscopy. The use of a rough Fe-doped InP(111)B substrate results in complete suppression of twin formation in the Bi2Se3 thin films and a perfect interface between the films and their substrates. The only type of structural defects that persist in the twin-free films is an antiphase domain boundary, which is associated with variations in substrate height. It is also shown that the substrate surface termination determines which family of twin domains dominates.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
