اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدEfficient quantum dot single photon extraction into an optical fiber using a nanophotonic directional coupler
132
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We demonstrate a spectrally broadband and effcient technique for collecting photoluminescence from a single InAs quantum dot directly into a standard single mode optical fiber. In this approach, an optical fiber taper waveguide is placed in contact with a suspended GaAs nanophotonic waveguide with embedded quantum dots, forming an effcient and broadband directional coupler with standard optical fiber input and output. Effcient photoluminescence collection over a wavelength range of tens of nanometers is demonstrated, and a maximum collection effciency of 6.05 % (corresponding single photon rate of 3.0 MHz) into a single mode optical fiber was estimated for a single quantum dot exciton.
قيم البحث
اقرأ أيضاً
We present a numerical method for the accurate and efficient simulation of strongly localized light sources, such as quantum dots, embedded in dielectric micro-optical structures. We apply the method in order to optimize the photon extraction efficie
ncy of a single-photon emitter consisting of a quantum dot embedded into a multi-layer stack with further lateral structures. Furthermore, we present methods to study the robustness of the extraction efficiency with respect to fabrication errors and defects.
We demonstrate a nanostructure composed of partially etched annular trenches in a suspended GaAs membrane, designed for efficient and moderately broadband (approx. 5 nm) emission extraction from single InAs quantum dots. Simulations indicate that a d
ipole embedded in the nanostructure center radiates upwards into free space with a nearly Gaussian far-field, allowing a collection efficiency > 80 % with a high numerical aperture (NA=0.7) optic, and with 12X Purcell radiative rate enhancement. Fabricated devices exhibit an approx. 10 % photon collection efficiency with a NA=0.42 objective, a 20X improvement over quantum dots in unpatterned GaAs. A fourfold exciton lifetime reduction indicates moderate Purcell enhancement.
We demonstrate a high-accuracy distributed fiber-optic temperature sensor using superconducting nanowire single-photon detectors and single-photon counting techniques. Our demonstration uses inexpensive single-mode fiber at standard telecommunication
s wavelengths as the sensing fiber, which enables extremely low-loss experiments and compatibility with existing fiber networks. We show that the uncertainty of the temperature measurement decreases with longer integration periods, but is ultimately limited by the calibration uncertainty. Temperature uncertainty on the order of 3 K is possible with spatial resolution of the order of 1 cm and integration period as small as 60 seconds. Also, we show that the measurement is subject to systematic uncertainties, such as polarization fading, which can be reduced with a polarization diversity receiver.
Planar nanostructures allow near-ideal extraction of emission from a quantum emitter embedded within, thereby realizing deterministic single-photon sources. Such a source can be transformed into M single-photon sources by implementing active temporal
-to-spatial mode demultiplexing. We report on the realization of such a demultiplexed source based on a quantum dot embedded in a nanophotonic waveguide. Efficient outcoupling (>60%) from the waveguide into a single mode optical fiber is obtained with high-efficiency grating couplers. As a proof-of-concept, active demultiplexing into M=4 spatial channels is demonstrated by the use of electro-optic modulators with an end-to-end efficiency of >81% into single-mode fibers. Overall we demonstrate four-photon coincidence rates of >1 Hz even under non-resonant excitation of the quantum dot. The main limitation of the current source is the residual population of other exciton transitions that corresponds to a finite preparation efficiency of the desired transition. We quantitatively extract a preparation efficiency of 15% using the second-order correlation function measurements. The experiment highlights the applicability of planar nanostructures as efficient multiphoton sources through temporal-to-spatial demultiplexing and lays out a clear path way of how to scale up towards demonstrating quantum advantages with the quantum dot sources.
Highly efficient coupling of photons from nanoemitters into single-mode optical fibers is demonstrated using tapered fibers. 7.4 +/- 1.2 % of the total emitted photons from single CdSe/ZnS nanocrystals were coupled into a 300-nm-diameter tapered fibe
r. The dependence of the coupling efficiency on the taper diameter was investigated and the coupling efficiency was found to increase exponentially with decreasing diameter. This method is very promising for nanoparticle sensing and single-photon sources.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
