اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدEffects of low-frequency noise cross-correlations in coupled superconducting qubits
206
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We study the effects of correlated low frequency noise sources acting on a two qubit gate in a fixed coupling scheme. A phenomenological model for the spatial and cross-talk correlations is introduced. The decoherence inside the SWAP subspace is analysed by combining analytic results based on the adiabatic approximation and numerical simulations. Results critically depend on amplitude of the low frequency noise with respect to the qubits coupling strength. Correlations between noise sources induce qualitative different behaviors depending on the values of the above parameters. The possibility to reduce dephasing due to correlated low frequency noise by a recalibration protocol is discussed.
قيم البحث
اقرأ أيضاً
We have studied low-frequency resistance fluctuations in shadow-evaporated Al/AlOx/Al tunnel junctions. Between 300 K and 5 K the spectral density follows a 1/f-law. Below 5 K, individual defects distort the 1/f-shape of the spectrum. The spectral de
nsity decreases linearly with temperature between 150 K and 1 K and saturates below 0.8 K. At 4.2 K, the spectral density is about two orders of magnitude lower than expected from a recent survey [D. J. Van Harlingen et al., Phys. Rev. B 70, 064510 (2004)]. Due to the saturation below 0.8 K the estimated qubit dephasing times at 100 mK are only about two times longer than calculated by Van Harlingen et al.
A general method for directly measuring the low-frequency flux noise (below 10 Hz) in compound Josephson junction superconducting flux qubits has been used to study a series of 85 devices of varying design. The variation in flux noise across sets of
qubits with identical designs was observed to be small. However, the levels of flux noise systematically varied between qubit designs with strong dependence upon qubit wiring length and wiring width. Furthermore, qubits fabricated above a superconducting ground plane yielded lower noise than qubits without such a layer. These results support the hypothesis that localized magnetic impurities in the vicinity of the qubit wiring are a key source of low frequency flux noise in superconducting devices.
We use the density matrix formalism to analyze the interaction of interferometer-type superconducting qubits with a high quality tank circuit, which frequency is well below the gap frequency of a qubit. We start with the ground state characterization
of the superconducting flux and charge qubits. Then, by making use of a dressed state approach we describe the qubits spectroscopy when the qubit is irradiated by a microwave field which is tuned to the gap frequency. The last section of the paper is devoted to continuous monitoring of qubit states by using a DC SQUID in the inductive mode.
We report a direct measurement of the low-frequency noise spectrum in a superconducting flux qubit. Our method uses the noise sensitivity of a free-induction Ramsey interference experiment, comprising free evolution in the presence of noise for a fix
ed period of time followed by single-shot qubit-state measurement. Repeating this procedure enables Fourier-transform noise spectroscopy with access to frequencies up to the achievable repetition rate, a regime relevant to dephasing in ensemble-averaged time-domain measurements such as Ramsey interferometry. Rotating the qubits quantization axis allows us to measure two types of noise: effective flux noise and effective critical-current or charge noise. For both noise sources, we observe that the very same 1/f-type power laws measured at considerably higher frequencies (0.2-20 MHz) are consistent with the noise in the 0.01-100-Hz range measured here. We find no evidence of temperature dependence of the noises over 65-200 mK, and also no evidence of time-domain correlations between the two noises. These methods and results are pertinent to the dephasing of all superconducting qubits.
An electrical circuit consisting of two capacitively coupled inductive loops, each interrupted by a Josephson junction, is analyzed through the classical RSCJ model. The same circuit has recently been studied experimentally and the results were used
to demonstrate quantum mechanical entanglement in the system by observing the correlated states of the two inductive loops after initial microwave perturbations. Our classical analysis shows that the observed phenomenon exists entirely within the classical RSCJ model, and we provide a detailed intuitive description of the transient dynamics responsible for the observations.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
