اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدEffect of oxygen incorporation on normal and superconducting properties of MgB2 films
134
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Oxygen was systematically incorporated in MBE grown MgB2 films using in-situ post-growth anneals in an oxygen environment. Connectivity analysis in combination with measurements of the critical temperature and resistivity indicate that oxygen is distributed both within and between the grains. High values of critical current densities in field (~4x10^5 A/cm^2 at 8 T and 4.2 K), extrabolated critical fields (>45 T) and slopes of critical field versus temperature (1.4 T/K) are observed. Our results suggest that low growth temperatures (300oC) and oxygen doping (>0.65%) can produce MgB2 with high Jc values in field and Hc2 for high-field magnet applications.
قيم البحث
اقرأ أيضاً
The amount of oxygen incorporated into MgB2 thin films upon exposure to atmospheric gasses is found to depend strongly on the materials stoichiometry. Rutherford backscattering spectroscopy was used to monitor changes in oxygen incorporation resultin
g from exposure to: (a) ambient atmosphere, (b) humid atmospheres, (c) anneals in air and (d) anneals in oxygen. The study investigated thin-film samples with compositions that were systematically varied from Mg0.9B2 to Mg1.1B2. A significant surface oxygen contamination was observed in all of these films. The oxygen content in the bulk of the film, on the other hand, increased significantly only in Mg rich films and in films exposed to humid atmospheres.
Our Rutherford backscattering spectrometry (RBS) study has found that concentrations up to 7 atomic percent of Rb and Cs can be introduced to a depth of ~700 A in MgB2 thin films by annealing in quartz ampoules containing elemental alkali metals at <
350 degree centigrade. No significant change in transition temperature (Tc) was observed, in contrast to an earlier report of very high Tc (>50 K) for similar experiments on MgB2 powders. The lack of a significant change in Tc and intra-granular carrier scattering suggests that Rb and Cs diffuse into the film, but do not enter the grains. Instead, the observed changes in the electrical properties, including a significant drop in Jc and an increase in delta rho (rho300-rho40), arise from a decrease in inter-granular connectivity due to segregation of the heavy alkaline metals and other impurities (i.e. C and O) introduced into the grain boundary regions during the anneals.
Iron is an important sheath material for fabrication of MgB2 wires. However, the effect of Fe doping on the superconducting properties of MgB2 remains controversial. In this work, we present results of nano-scale Fe particle doping in to MgB2. The Fe
doping experiments were performed using both bulk and thin film form. It was found that Fe doping did not affect the lattice parameters of MgB2, as evidenced by the lack of change in the XRD peak positions for MgB2. Because of the high reactivity of nano-scale Fe particles, Fe doping is largely in the form of FeB at low doping level while Fe2B was detected at 10wt% doping by both XRD and TEM. There is no evidence for Fe substitution for Mg. The transition temperature decreased modestly with increasing Fe doping levels. The Jc(H) performance was severely depressed at above 3wt% doping level. The detrimental effect of nano-scale Fe doping on both Tc and Jc(H) is attributable to the grain decoupling as a result of magnetic scattering of Fe-containing dopants at grain boundaries.
We study the effect of synthesis temperature on the phase formation in nano(n)-SiC added bulk MgB2 superconductor. In particular we study: lattice parameters, amount of carbon (C) substitution, microstructure, critical temperature (Tc), irreversibili
ty field (Hirr), critical current density (Jc), upper critical field (Hc2) and flux pinning. Samples of MgB2+(n-SiC)x with x=0.0, 0.05 & 0.10 were prepared at four different synthesis temperatures i.e. 850, 800, 750, and 700oC with the same heating rate as 10oC/min. We found 750oC as the optimal synthesis temperature for n-SiC doping in bulk MgB2 in order to get the best superconducting performance in terms of Jc, Hc2 and Hirr. Carbon (C) substitution enhances the Hc2 while the low temperature synthesis is responsible for the improvement in Jc due to the smaller grain size, defects and nano-inclusion induced by C incorporation into MgB2 matrix, which is corroborated by elaborative HRTEM (high-resolution transmission electron microscopy) results. We optimized the the Tc(R=0) of above 15K for the studied n-SiC doped and 750 0C synthesized MgB2 under 140 KOe field, which is one of the highest values yet obtained for variously processed and nano-particle added MgB2 in literature to our knowledge.
This review paper illustrates the main normal and superconducting state properties of magnesium diboride, a material known since early 1950s, but recently discovered to be superconductive at a remarkably high critical temperature Tc=40K for a binary
compound. What makes MgB2 so special? Its high Tc, simple crystal structure, large coherence lengths, high critical current densities and fields, transparency of grain boundaries to current promises that MgB2 will be a good material for both large scale applications and electronic devices. During the last seven month, MgB2 has been fabricated in various forms, bulk, single crystals, thin films, tapes and wires. The largest critical current densities >10MA/cm2 and critical fields 40T are achieved for thin films. The anisotropy ratio inferred from upper critical field measurements is still to be resolved, a wide range of values being reported, between 1.2 and 9. Also there is no consensus about the existence of a single anisotropic or double energy gap. One central issue is whether or not MgB2 represents a new class of superconductors, being the tip of an iceberg who awaits to be discovered. Up to date MgB2 holds the record of the highest Tc in its class. However, the discovery of superconductivity in MgB2 revived the interest in non-oxides and initiated a search for superconductivity in related materials, several compounds being already announced to become superconductive: TaB2, BeB2.75, C-S composites, and the elemental B under pressure.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
