ترغب بنشر مسار تعليمي؟ اضغط هنا

Ab Initio Liquid Hydrogen Muon Cooling Simulations with ELMS in ICOOL

40   0   0.0 ( 0 )
 نشر من قبل Wade Allison
 تاريخ النشر 2006
  مجال البحث فيزياء
والبحث باللغة English
 تأليف W. W. M. Allison




اسأل ChatGPT حول البحث

This paper presents new theoretical results on the passage of muons through liquid hydrogen which have been confirmed in a recent experiment. These are used to demonstrate that muon bunches may be compressed by ionisation cooling more effectively than suggested by previous calculations. Muon cooling depends on the differential cross section for energy loss and scattering of muons. We have calculated this cross section for liquid H2 from first principles and atomic data, avoiding traditional assumptions. Thence, 2-D probability maps of energy loss and scattering in mm-scale thicknesses are derived by folding, and stored in a database. Large first-order correlations between energy loss and scattering are found for H2, which are absent in other simulations. This code is named ELMS, Energy Loss & Multiple Scattering. Single particle trajectories may then be tracked by Monte Carlo sampling from this database on a scale of 1 mm or less. This processor has been inserted into the cooling code ICOOL. Significant improvements in 6-D muon cooling are predicted compared with previous predictions based on GEANT. This is examined in various geometries. The large correlation effect is found to have only a small effect on cooling. The experimental scattering observed for liquid H2 in the MUSCAT experiment has recently been reported to be in good agreement with the ELMS prediction, but in poor agreement with GEANT simulation.

قيم البحث

اقرأ أيضاً

103 - D. J. Summers 2005
Progress on six dimensional ionization muon cooling with relatively small rings of magnets is described. Lattices being explored include scaling sector cyclotrons with edge focusing and strong focusing, fixed field alternating gradient (FFAG) rings. Ionization cooling is provided by high pressure hydrogen gas which removes both transverse and longitudinal momentum. Lost longitudinal momentum is replaced using radio frequency (RF) cavities, giving a net transverse emittance reduction. The longer path length in the hydrogen of higher momentum muons decreases longitudinal emittance at the expense of transverse emittance. Thus emittance exchange allows these rings to cool in all six dimensions and not just transversely. Alternatively, if the RF is located after the ring, it may be possible to cool the muons by stopping them as they spiral adiabatically into a central swarm. As momentum goes to zero, the momentum spread goes to zero. The resulting cooled muons can lead to an intense muon beam which could be a source for neutrino factories or muon colliders.
A 10 MeV/c $mu^+$ beam was stopped in helium gas of a few mbar in a magnetic field of 5 T. The muon swarm has been efficiently compressed from a length of 16 cm down to a few mm along the magnetic field axis (longitudinal compression) using electrost atic fields. The simulation reproduces the low energy interactions of slow muons in helium gas. Phase space compression occurs on the order of microseconds, compatible with the muon lifetime of 2 $mu$s. This paves the way for preparation of a high quality muon beam.
Possible application for muon experiments such as mu2e is discussed of the initial part of the ionization cooling channel originally developed for muon collider. It is shown that with the FNAL Booster as the proton driver the mu2e sensitivity can be increased by two orders of magnitude compared to the presently considered experiment.
High-brightness muon beams of energy comparable to those produced by state-of-the-art electron, proton and ion accelerators have yet to be realised. Such beams have the potential to carry the search for new phenomena in lepton-antilepton collisions t o extremely high energy and also to provide uniquely well-characterised neutrino beams. A muon beam may be created through the decay of pions produced in the interaction of a proton beam with a target. To produce a high-brightness beam from such a source requires that the phase space volume occupied by the muons be reduced (cooled). Ionization cooling is the novel technique by which it is proposed to cool the beam. The Muon Ionization Cooling Experiment collaboration has constructed a section of an ionization cooling cell and used it to provide the first demonstration of ionization cooling. We present these ground-breaking measurements.
A novel single-particle technique to measure emittance has been developed and used to characterise seventeen different muon beams for the Muon Ionisation Cooling Experiment (MICE). The muon beams, whose mean momenta vary from 171 to 281 MeV/c, have e mittances of approximately 1.5--2.3 pi mm-rad horizontally and 0.6--1.0 pi mm-rad vertically, a horizontal dispersion of 90--190 mm and momentum spreads of about 25 MeV/c. There is reasonable agreement between the measured parameters of the beams and the results of simulations. The beams are found to meet the requirements of MICE.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا