اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدCompton Polarimetry at a TEV Collider
241
0
0.0
(
0
)
تأليف
M. Woods
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
An electron beam polarization of 80% or greater will be a key feature of a 1 TeV Linear Collider. Accurate measurements of the beam polarization will therefore be needed. We discuss design considerations and capabilities for a Compton-scattering polarimeter located in the extraction line from the Interaction Point. Polarization measurements with 1% accuracy taken parasitic to collision data look feasible, but detailed simulations are needed. Polarimeter design issues are similar for both electron-positron and electron-electron collider modes, though beam disruption creates more difficulties for the electron-electron mode.
قيم البحث
اقرأ أيضاً
At a future linear collider, a polarized electron beam will play an important role in interpreting new physics signals. Backgrounds to a new physics reaction can be reduced by choice of the electron polarization state. The origin of a new physics rea
ction can be clarified by measuring its polarization-dependence. This paper examines some options for polarimetry with an emphasis on physics issues that motivate how precise the polarization determination needs to be. In addition to Compton polarimetry, the possibility of using Standard Model asymmetries, such as the asymmetry in forward W-pairs, is considered as a possible polarimeter. Both e+e- and e-e- collider modes are considered.
A lepton collider in the multi-TeV range has the potential to measure the trilinear Higgs self-coupling constant $lambda_{hhh}$ via the W-fusion mode $ell^+ell^- rightarrow u_ell bar{ u}_ell h h$. In this paper we do a generator-level study to explo
re how center-of-mass energy spread, cone size, tracking resolution, and collision energy range affect how precisely a muon collider can measure $lambda_{hhh}$ in comparison to an $e^+e^-$ collider. The smaller spread in center-of-mass energy and higher energy range of a muon collider improve cross section while the larger cone required to reduce beam-induced background hinders detection of double-Higgs events. Our results motivate a more detailed study of a multi-TeV muon collider and innovative detector and analysis technologies required for background rejection and precision measurement.
This paper describes simulations of detector response to multi-TeV physics at the Future Circular Collider (FCC-hh) or Super proton-proton Collider (SppC) which aim to collide proton beams with a centre-of-mass energy of 100 TeV. The unprecedented en
ergy regime of these future experiments imposes new requirements on detector technologies which can be studied using the detailed GEANT4 simulations presented in this paper. The initial performance of a detector designed for physics studies at the FCC-hh or SppC experiments is described with an emphasis on measurements of single particles up to 33 TeV in transverse momentum. The reconstruction of hadronic jets has also been studied in the transverse momentum range from 50 GeV to 26 TeV. The granularity requirements for calorimetry are investigated using the two-particle spatial resolution achieved for hadron showers.
We report on the highest precision yet achieved in the measurement of the polarization of a low energy, $mathcal{O}$(1 GeV), electron beam, accomplished using a new polarimeter based on electron-photon scattering, in Hall~C at Jefferson Lab. A number
of technical innovations were necessary, including a novel method for precise control of the laser polarization in a cavity and a novel diamond micro-strip detector which was able to capture most of the spectrum of scattered electrons. The data analysis technique exploited track finding, the high granularity of the detector and its large acceptance. The polarization of the $180~mu$A, $1.16$~GeV electron beam was measured with a statistical precision of $<$~1% per hour and a systematic uncertainty of 0.59%. This exceeds the level of precision required by the qweak experiment, a measurement of the vector weak charge of the proton. Proposed future low-energy experiments require polarization uncertainty $<$~0.4%, and this result represents an important demonstration of that possibility. This measurement is also the first use of diamond detectors for particle tracking in an experiment.
This report summarises the properties of Standard Model processes at the 100 TeV pp collider. We document the production rates and typical distributions for a number of benchmark Standard Model processes, and discuss new dynamical phenomena arising a
t the highest energies available at this collider. We discuss the intrinsic physics interest in the measurement of these Standard Model processes, as well as their role as backgrounds for New Physics searches.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
