اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدPolarimetry at a Future Linear Collider - How Precise?
82
0
0.0
(
0
)
تأليف
M. Woods
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
At a future linear collider, a polarized electron beam will play an important role in interpreting new physics signals. Backgrounds to a new physics reaction can be reduced by choice of the electron polarization state. The origin of a new physics reaction can be clarified by measuring its polarization-dependence. This paper examines some options for polarimetry with an emphasis on physics issues that motivate how precise the polarization determination needs to be. In addition to Compton polarimetry, the possibility of using Standard Model asymmetries, such as the asymmetry in forward W-pairs, is considered as a possible polarimeter. Both e+e- and e-e- collider modes are considered.
قيم البحث
اقرأ أيضاً
An electron beam polarization of 80% or greater will be a key feature of a 1 TeV Linear Collider. Accurate measurements of the beam polarization will therefore be needed. We discuss design considerations and capabilities for a Compton-scattering pola
rimeter located in the extraction line from the Interaction Point. Polarization measurements with 1% accuracy taken parasitic to collision data look feasible, but detailed simulations are needed. Polarimeter design issues are similar for both electron-positron and electron-electron collider modes, though beam disruption creates more difficulties for the electron-electron mode.
The physics programme for a coming electron linear collider is dominated by events with final states containing many jets. We develop in this paper the opinion that the best approach is to optimise the independent measurement of the tracks in the tra
cker, the photons in the electromagnetic calorimeter and the neutral hadrons in the camorimetry, together with a good lepton identification. This can be achieved with a high granularity calorimetry providing particle separation, through an efficient energy flow algorithm.
We carried out a feasibility study on the measurement of the branching ratio of H -> cc_bar at a future e+e- linear collider. We used the topological vertex reconstructing algorithm for accumulating secondary vertex information and the neural network
for optimizing c quark selection. With an assumption of a light Higgs mass of 120 GeV/c^2, we estimated the statistical error of Br(H -> cc_bar) to be 20.1% or 25.7% depending on the number of vertex detector layers at the center-of-mass energy of 250 GeV and the intergrated luminosity of 500 fb^-1.
The scalar top discovery potential has been studied with a full-statistics background simulation for sqrt(s) = 500 GeV and L = 500 fb-1. The simulation is based on a fast and realistic simulation of a TESLA detector. The large simulated data sample a
llowed the application of an Iterative Discriminant Analysis (IDA) which led to a significantly higher sensitivity than in previous studies. The effects of beam polarization on signal efficiency and individual background channels are studied using separate optimization with the IDA for both polarization states. The beam polarization is very important to measure the scalar top mixing angle and to determine its mass. Simulating a 180 GeV scalar top at minimum production cross section, we obtain Delta(m) = 1 GeV and Delta(cos(theta)) = 0.009.
The quantitative knowledge of heavy nucleis partonic structure is currently limited to rather large values of momentum fraction $x$ -- robust experimental constraints below $x sim 10^{-2}$ at low resolution scale $Q^2$ are particularly scarce. This i
s in sharp contrast to the free protons structure which has been probed in deep inelastic scattering (DIS) measurements down to $x sim 10^{-5}$ at perturbative resolution scales. The construction of an Electron-Ion Collider (EIC) with a possibility to operate with a wide variety of nuclei, will allow one to explore the low-$x$ region in much greater detail. In the present paper we simulate the extraction of the nuclear structure functions from measurements of inclusive and charm reduced cross sections at an EIC. The potential constraints are studied by analyzing simulated data directly in a next-to-leading order global fit of nuclear parton distribution functions based on the recent EPPS16 analysis. A special emphasis is placed on studying the impact an EIC would have on extracting the nuclear gluon PDF, the partonic component most prone to non-linear effects at low $Q^2$. In comparison to the current knowledge, we find that the gluon PDF can be measured at an EIC with significantly reduced uncertainties.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
