اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدDiffusion-reaction in thermal growth of silicon oxide films on Si
50
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The thermal growth of silicon oxide films on Si in dry O2 is modelled as a dynamical system, assuming that it is basically a diffusion-reaction phenomenon. Relevant findings of the last decade are incorporated, as structure and composition of the oxide/Si interface and O2 transport and reaction at initial stages of growth. The present model departs from the well established Deal and Grove framework (Deal, B.E. and Grove, A. S. General Relationship for the Thermal Oxidation of Silicon, J. Appl. Phys. 36, 3770-3778 (1965)) indicating that its basic assumptions, steady-state regime and reaction between O2 and Si at a sharp oxide/Si interface are only attained asymptotically. Experimental growth kinetics by various authors, obtained for a wide range of growth parameters are shown to collapse into one single curve when the scaling properties of this model equations are explored.
قيم البحث
اقرأ أيضاً
Precise control of the chemical valence or oxidation state of vanadium in vanadium oxide thin films is highly desirable for not only fundamental research, but also technological applications that utilize the subtle change in the physical properties o
riginating from the metal- insulator transition (MIT) near room temperature. However, due to the multivalent nature of vanadium and the lack of a good understanding on growth control of the oxidation state, stabilization of phase pure vanadium oxides with a single oxidation state is extremely challenging. Here, we systematically varied the growth conditions to clearly map out the growth window for preparing phase pure epitaxial vanadium oxides by pulsed laser deposition for providing a guideline to grow high quality thin films with well-defined oxidation states of V2(+3)O3, V(+4)O2, and V2(+5)O5. A well pronounced MIT was only observed in VO2 films grown in a very narrow range of oxygen partial pressure P(O2). The films grown either in lower (< 10 mTorr) or higher P(O2) (> 25 mTorr) result in V2O3 and V2O5 phases, respectively, thereby suppressing the MIT for both cases. We have also found that the resistivity ratio before and after the MIT of VO2 thin films can be further enhanced by one order of magnitude when the films are further oxidized by post-annealing at a well-controlled oxidizing ambient. This result indicates that stabilizing vanadium into a single valence state has to compromise with insufficient oxidation of an as grown thin film and, thereby, a subsequent oxidation is required for an improved MIT behavior.
Ultrathin (111)-oriented polar iron oxide films were grown on a Pt(111) single crystal either by the reactive deposition of iron or oxidation of metallic iron monolayers. These films were characterized using low energy electron diffraction, scanning
tunneling microscopy and conversion electron Mossbauer spectroscopy. The reactive deposition of Fe led to the island growth of Fe3O4, in which the electronic and magnetic properties of the bulk material were modulated by superparamagnetic size effects for thicknesses below 2 nm, revealing specific surface and interface features. In contrast, the oxide films with FeO stoichiometry, which could be stabilized as thick as 4 nm under special preparation conditions, had electronic and magnetic properties that were very different from their bulk counterpart, wustite. Unusual long range magnetic order appeared at room temperature for thicknesses between three and ten monolayers, the appearance of which requires severe structural modification from the rock-salt structure.
Enhanced diffusion of gold atoms into silicon substrate has been studied in Au thin films of various thicknesses (2.0, 5.3, 10.9 and 27.5 nm) deposited on Si(111) and followed by irradiation with 1.5 MeV Au2+ at a flux of 6.3x10^12 ions cm-2 s-1 and
fluence up to 1x10^15 ions cm-2. The high resolution transmission electron microscopy measurements showed the presence of gold silicide formation for the above-mentioned systems at fluence greater than equal to 1x1014 ions cm-2. The maximum depth to which the gold atoms have been diffused at a fluence of 1x10^14 ions cm-2 for the cases of 2.0, 5.3, 10.9 and 27.5 nm thick films has been found to be 60, 95, 160 and 13 nm respectively. Interestingly, at higher fluence of 1x1015 ions cm-2 in case of 27.5 nm thick film, gold atoms from the film transported to a maximum depth of 265 nm in the substrate. The substrate silicon is found to be amorphous at the above fluence values where unusually large mass transport occurred. Enhanced diffusion has been explained on the basis of ion beam induced, flux dependent amorphous nature of the substrate, and transient beam induced temperature effects. This work confirms the absence of confinement effects that arise from spatially confined structures and existence of thermal and chemical reactions during ion irradiation.
Phase stabilities of Hf-Si-O and Zr-Si-O have been studied with first-principles and thermodynamic modeling. From the obtained thermodynamic descriptions, phase diagrams pertinent to thin film processing were calculated. We found that the relative st
ability of the metal silicates with respect to their binary oxides plays a critical role in silicide formation. It was observed that both the HfO$_2$/Si and ZrO$_2$/Si interfaces are stable in a wide temperature range and silicide may form at low temperatures, partially at the HfO$_2$/Si interface.
Homogeneous highly epitaxial LaSrMnO3 (LSMO) thin films have been grown on Yttria-stabilized-Zirconia (YsZ) / CeO2 buffer layers on technological relevant 4 silicon wafers using a Twente Solid State Technology B.V. (TSST) developed large area Pulsed
Laser Deposition (PLD) setup. We study and show the results of the effect of an additional SrRuO3 buffer layer on the growth temperature dependent structural and magnetic properties of LSMO films. With the introduction of a thin SrRuO3 layer on top of the buffer stack, LSMO films show ferromagnetic behaviour for growth temperatures as low as 250C. We suggest that occurrence of epitaxial crystal growth of LSMO at these low growth temperatures can be understood by an improved surface diffusion, which ensures sufficient intermixing of surface species for formation of the correct phase. This intermixing is necessary because the full plume is collected on the 4 wafer resulting in a compositional varying flux of species on the wafer, in contrast to small scale experiments.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
