اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدBulk sensitive photo emission spectroscopy of C1b compounds
66
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
This work reports about bulk-sensitive, high energy photoelectron spectroscopy from the valence band of CoTiSb excited by photons from 1.2 to 5 keV energy. The high energy photoelectron spectra were taken at the KMC-1 high energy beamline of BESSY II employing the recently developed Phoibos 225 HV analyser. The measurements show a good agreement to calculations of the electronic structure using the LDA scheme. It is shown that the high energy spectra reveal the bulk electronic structure better compared to low energy XPS spectra.
قيم البحث
اقرأ أيضاً
Electronic structures of Sr_2FeMoO_6 (SFMO) and Ba_2FeMoO_6 (BFMO) double perovskites have been investigated using the Fe 2p->3d resonant photoemission spectroscopy (PES) and the Cooper minimum in the Mo 4d photoionization cross section. The states c
lose to the Fermi level are found to have strongly mixed Mo-Fe t_{2g} character, suggesting that the Fe valence is far from pure 3+. The Fe 2p_{3/2} XAS spectra indicate the mixed-valent Fe^{3+}-Fe^{2+} configurations, and the larger Fe^{2+} component for BFMO than for SFMO, suggesting a kind of double exchange interaction. The valence-band PES spectra reveal good agreement with the LSDA+U calculation.
We have performed bulk-sensitive spin-resolved photoemission spectroscopy in order to clarify the intrinsic spin-resolved electronic states of half-metallic ferromagnet CrO2. We used CrO2 epitaxial films on TiO2(100), which shows a peak at 1 eV with
a clear Fermi edge, consistent with the bulk-sensitive PES spectrum for CrO2. In spin-resolved spectra at 40 K, while the Fermi edge was observed in the spin up (majority spin) state, no states at the Fermi level (EF) with an energy gap of 0.5 eV below EF was observed in the spin down (minority spin) state. At 300 K, the gap in the spin down state closes. These results are consistent with resistivity measurements and magnetic hysteresis curves of the fabricated CrO2 film, constituting spectroscopic evidence for the half-metallicity of CrO2 at low temperature and reducing the spin polarization at room temperature. We also discuss the electron correlation effects of Cr 3d.
Highly sensitive and fast photodetector devices with CdSe quantum nanowires as active elements have been developed exploiting the advantages of electro- and wet-chemical routes. Bismuth nanoparticles electrochemically synthesized directly onto interd
igitating platinum electrodes serve as catalysts in the following solution-liquid-solid synthesis of quantum nanowires directly on immersed substrates under mild conditions at low temperature. This fast and simple preparation process leads to a photodetector device with a film of nanowires of limited thickness bridging the electrode gaps, in which a high fraction of individual nanowires are electrically contacted and can be exposed to light at the same time. The high sensitivity of the photodetector device can be expressed by its on/off-ratio or its photosensitivity of more than 107 over a broad wavelength range up to about 700 nm. The specific detectivity and responsivity are determined to D* = 4*10^13 Jones and R = 0.32 A/W, respectively. The speed of the device reflects itself in a 3 dB frequency above 1 MHz corresponding to rise and fall times below 350 ns. The remarkable combination of a high sensitivity and a fast response is attributed to depletion regions inside the nanowires, tunnel-junction barriers between nanowires, as well as Schottky contacts at the electrodes, where all these features are strongly influenced by the number of photo generated charge carriers.
We demonstrate a new method of x-ray absorption spectroscopy (XAS) that is bulk sensitive, like traditional fluorescence yield measurements, but is not affected by self-absorption or saturation effects. This measure of XAS is achieved by scanning the
incident photon energy through an absorption edge and using an energy sensitive photon detector to measure the partial fluorescence yield (PFY). The x-ray emission from any element or core-hole excitation that is not resonant with the absorption edge under investigation is selected from the PFY. It is found that the inverse of this PFY spectrum, which we term inverse partial fluorescence yield (IPFY), is linearly proportional to the x-ray absorption cross-section without any corrections due to saturation or self-absorption effects. We demonstrate this technique on the Cu L and Nd M absorption edges of the high-Tc cuprate LNSCO by measuring the O K PFY and comparing the total electron yield, total fluorescence yield and IPFY spectra.
We report measurement of the valence-to-core (VTC) region of the K-shell x-ray emission spectra from several Zn and Fe inorganic compounds, and their critical comparison with several existing theoretical treatments. We find generally good agreement b
etween the respective theories and experiment, and in particular find an important admixture of dipole and quadrupole character for Zn materials that is much weaker in Fe-based systems. These results on materials whose simple crystal structures should not, a prior, pose deep challenges to theory, will prove useful in guiding the further development of DFT and time-dependent DFT methods for VTC-XES predictions and their comparison to experiment.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
