اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSurface Structure of Liquid Metals and the Effect of Capillary Waves: X-ray Studies on Liquid Indium
106
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report x-ray reflectivity (XR) and small angle off-specular diffuse scattering (DS) measurements from the surface of liquid Indium close to its melting point of $156^circ$C. From the XR measurements we extract the surface structure factor convolved with fluctuations in the height of the liquid surface. We present a model to describe DS that takes into account the surface structure factor, thermally excited capillary waves and the experimental resolution. The experimentally determined DS follows this model with no adjustable parameters, allowing the surface structure factor to be deconvolved from the thermally excited height fluctuations. The resulting local electron density profile displays exponentially decaying surface induced layering similar to that previously reported for Ga and Hg. We compare the details of the local electron density profiles of liquid In, which is a nearly free electron metal, and liquid Ga, which is considerably more covalent and shows directional bonding in the melt. The oscillatory density profiles have comparable amplitudes in both metals, but surface layering decays over a length scale of $3.5pm 0.6$ AA for In and $5.5pm 0.4$ AA for Ga. Upon controlled exposure to oxygen, no oxide monolayer is formed on the liquid In surface, unlike the passivating film formed on liquid Gallium.
قيم البحث
اقرأ أيضاً
We report an x-ray scattering study of the microscopic structure of the surface of a liquid alkali metal. The bulk liquid structure factor of the eutectic K67Na33 alloy is characteristic of an ideal mixture, and so shares the properties of an element
al liquid alkali metal. Analysis of off-specular diffuse scattering and specular x-ray reflectivity shows that the surface roughness of the K-Na alloy follows simple capillary wave behavior with a surface structure factor indicative of surface induced layering. Comparison of thelow-angle tail of the K67Na33 surface structure factor with the one measured for liquid Ga and In previously suggests that layering is less pronounced in alkali metals. Controlled exposure of the liquid to H2 and O2 gas does not affect the surface structure, indicating that oxide and hydride are not stable at the liquid surface under these experimental conditions.
We present x-ray reflectivity and diffuse scattering measurements from the liquid surface of pure potassium. They strongly suggest the existence of atomic layering at the free surface of a pure liquid metal with low surface tension. Prior to this stu
dy, layering was observed only for metals like Ga, In and Hg, the surface tensions of which are 5-7 fold higher than that of potassium, and hence closer to inducing an ideal hard wall boundary condition. The experimental result requires quantitative analysis of the contribution to the surface scattering from thermally excited capillary waves. Our measurements confirm the predicted form for the differential cross section for diffuse scattering, $dsigma /dOmega sim 1/q_{xy}^{2-eta}$ where $eta = k_BT q_z^2/2pi gamma $, over a range of $eta$ and $q_{xy}$ that is larger than any previous measurement. The partial measure of the surface structure factor that we obtained agrees with computer simulations and theoretical predictions.
Nuclear fusion cross-sections considerably higher than corresponding theoretical predictions are observed in low-energy experiments with metal matrix targets and accelerated deuteron beams. The cross-section increment is significantly higher for liqu
id than for solid targets. We propose that the same two-body correlation entropy used in evaluating the metal melting entropy explains the large liquid-solid difference of the effective screening potential that parameterizes the cross-section increment. This approach is applied to the specific case of the $^6$Li(d,$alpha$)$^4$He reaction, whose measured screening potential liquid-solid difference is $(235 pm 63)$ eV. Cross sections in the two metals with the highest two-body correlation entropy (In and Hg) have not yet been measured: increments of the cross sections in liquid relative to the ones in solid metals are estimated with the same procedure.
Measurements of the surface x-ray scattering from several pure liquid metals (Hg, Ga, and In) and from three alloys (Ga-Bi, Bi-In, and K-Na) with different heteroatomic chemical interactions in the bulk phase are reviewed. Surface-induced layering is
found for each elemental liquid metal. The surface structure of the K-Na alloy resembles that of an elemental liquid metal. Bi-In displays pair formation at the surface. Surface segregation and a wetting film are found for Ga-Bi.
Calcium carbonate is a model system to investigate the mechanism of solid formation by precipitation from solutions, and it is often considered in the debated classical and non-classical nucleation mechanism. Despite the great scientific relevance of
calcium carbonate in different areas of science, little is known about the early stage of its formation. We, therefore, designed contactless devices capable to provide informative investigations on the early stages of the precipitation pathway of calcium carbonate in supersaturated solutions using classical scattering methods such as Wide-Angle X-ray Scattering (WAXS) and Small-Angle X-ray Scattering (SAXS) techniques. In particular, SAXS was exploited for investigating the size of entities formed from supersaturated solutions before the critical conditions for amorphous calcium carbonate (ACC) nucleation are attained. The saturation level was controlled by mixing four diluted solutions (i.e., NaOH, CaCl2, NaHCO3, H2O) at constant T and pH. The scattering data were collected on a liquid jet generated about 75 sec after the mixing point. The data were modeled using parametric statistical models providing insight about the size distribution of denser matter in the liquid jet. Theoretical implications on the early stage of solid formation pathway are inferred.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
