اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدDriving forces for Ag-induced periodic faceting of vicinal Cu(111)
108
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Adsorption of submonolayer amounts of Ag on vicinal Cu(111) induces periodic faceting. The equilibrium structure is characterized by Ag-covered facets that alternate with clean Cu stripes. In the atomic scale, the driving force is the matching of Ag(111)-like packed rows with Cu(111) terraces underneath. This determines the preference for the facet orientation and the evolution of different phases as a function of coverage. Both Cu and Ag stripe widths can be varied smoothly in the 3-30 nm range by tuning Ag coverage, allowing to test theoretical predictions of elastic theories.
قيم البحث
اقرأ أيضاً
The formation of a Ag stabilized regular step lattice on vicinal Si(111) miscut towards [11-2] is reported. The step bunching characteristic of the clean surface is prevented by a single-domain Si(111)-(3x1)-Ag reconstruction. The nanostructured surf
ace is used as a template for growing one-dimensional arrays of 1 nm sized Ag quantum dots with a preferential spacing of 1.5 nm along the rows.
We study current-induced step bunching and wandering instabilities with subsequent pattern formations on vicinal surfaces. A novel two-region diffusion model is developed, where we assume that there are different diffusion rates on terraces and in a
small region around a step, generally arising from local differences in surface reconstruction. We determine the steady state solutions for a uniform train of straight steps, from which step bunching and in-phase wandering instabilities are deduced. The physically suggestive parameters of the two-region model are then mapped to the effective parameters in the usual sharp step models. Interestingly, a negative kinetic coefficient results when the diffusion in the step region is faster than on terraces. A consistent physical picture of current-induced instabilities on Si(111) is suggested based on the results of linear stability analysis. In this picture the step wandering instability is driven by step edge diffusion and is not of the Mullins-Sekerka type. Step bunching and wandering patterns at longer times are determined numerically by solving a set of coupled equations relating the velocity of a step to local properties of the step and its neighbors. We use a geometric representation of the step to derive a nonlinear evolution equation describing step wandering, which can explain experimental results where the peaks of the wandering steps align with the direction of the driving field.
We present density-functional results on the lifetime of the (111) surface state of the noble metals. We consider scattering on the Fermi surface caused by impurity atoms belonging to the 3d and 4sp series. The results are analyzed with respect to fi
lm thickness and with respect to separation of scattering into bulk or into surface states. While for impurities in the surface layer the overall trends are similar to the long-known bulk-state scattering, for adatom-induced scattering we find a surprising behavior with respect to the adatom atomic number. A plateau emerges in the scattering rate of the 3d adatoms, instead of a peak characteristic of the d resonance. Additionally, the scattering rate of 4sp adatoms changes in a zig-zag pattern, contrary to a smooth parabolic increase following Lindes rule that is observed in bulk. We interpret these results in terms of the weaker charge-screening and of interference effects induced by the lowering of symmetry at the surface.
The structure and dynamics of atomic oxygen adsorbed on Ag(410) and Ag(210) surfaces have been investigated using density functional theory. Our results show that the adsorption configuration in which O adatoms decorate the upper side of the (110) st
eps forming O--Ag--O rows is particularly stable for both surfaces. On Ag(210), this arrangement is more stable than other configurations at all the investigated coverages. On Ag(410), adsorption on the terrace and at the step edge are almost degenerate, the former being slightly preferred at low coverage while the latter is stabilized by increasing the coverage. These findings are substantiated by a comparison between the vibrational modes, calculated within density-functional perturbation theory, and the HREEL spectrum which has been recently measured in these systems.
Silicene, analogous to graphene, is a one-atom-thick two-dimensional crystal of silicon which is expected to share many of the remarkable properties of graphene. The buckled honeycomb structure of silicene, along with its enhanced spin-orbit coupling
, endows silicene with considerable advantages over graphene in that the spin-split states in silicene are tunable with external fields. Although the low-energy Dirac cone states lie at the heart of all novel quantum phenomena in a pristine sheet of silicene, the question of whether or not these key states can survive when silicene is grown or supported on a substrate remains hotly debated. Here we report our direct observation of Dirac cones in monolayer silicene grown on a Ag(111) substrate. By performing angle-resolved photoemission measurements on silicene(3x3)/Ag(111), we reveal the presence of six pairs of Dirac cones on the edges of the first Brillouin zone of Ag(111), other than expected six Dirac cones at the K points of the primary silicene(1x1) Brillouin zone. Our result shows clearly that the unusual Dirac cone structure originates not from the pristine silicene alone but from the combined effect of silicene(3x3) and the Ag(111) substrate. This study identifies the first case of a new type of Dirac Fermion generated through the interaction of two different constituents. Our observation of Dirac cones in silicene/Ag(111) opens a new materials platform for investigating unusual quantum phenomena and novel applications based on two-dimensional silicon systems.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
