اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدNanotribological characterization of industrial Polytetrafluorethylene-based coatings by atomic force microscopy
90
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We present the result of a systematic study of the tribological properties of industrial Polytetrafluorethylene (PTFE)-based coatings carried out with an atomic force microscope. A new characterization protocol allowed the reliable and quantitative assessment of the friction coefficient and adhesion forces at the sub-micrometer scale even for highly corrugated industrial samples. We have studied and compared PTFE coatings charged with different additives in dry and humid environment. The influence of additives and humidity on the friction coefficient and on adhesion forces has been investigated using standard silicon nitride tips as sliders in the low-load regime.
قيم البحث
اقرأ أيضاً
Atomic Force Microscopy (AFM) is a suitable tool to perform tribological characterization of materials down to the nanometer scale. An important aspect in nanofriction measurements of corrugated samples is the local tilt of the surface, which affects
the lateral force maps acquired with the AFM. This is one of the most important problems of state-of-the-art nanotribology, making difficult a reliable and quantitative characterization of real corrugated surfaces. A correction of topographic spurious contributions to lateral force maps is thus needed for corrugated samples. In this paper we present a general approach to the topographic correction of AFM lateral force maps and we apply it in the case of multi-asperity adhesive contact. We describe a complete protocol for the quantitative characterization of the frictional properties of corrugated systems in the presence of surface adhesion using the AFM.
Using atomic force microscopy, we have studied the surface structures of high quality molecular beam epitaxy grown (Ga,Mn)As compound. Several samples with different thickness and Mn concentration, as well as a few (Ga,Mn)(As,P) samples have been inv
estigated. All these samples have shown the presence of periodic ripples aligned along the $[1bar{1}0]$ direction. From a detailed Fourier analysis we have estimated the period (~50 nm) and the amplitude of these structures.
To visualize the topography of thin oxide films during growth, thereby enabling to study its growth behavior quasi real-time, we have designed and integrated an atomic force microscope (AFM) in a pulsed laser deposition (PLD) vacuum setup. The AFM sc
anner and PLD target are integrated in a single support frame, combined with a fast sample transfer method, such that in-situ microscopy can be utilized after subsequent deposition pulses. The in-situ microscope can be operated from room temperature (RT) up to 700$^circ$C and at (process) pressures ranging from the vacuum base pressure of 10$^{-6}$ mbar up to 1 mbar, typical PLD conditions for the growth of oxide films. The performance of this instrument is demonstrated by resolving unit cell height surface steps and surface topography under typical oxide PLD growth conditions.
By employing single charge injections with an atomic force microscope, we investigated redox reactions of a molecule on a multilayer insulating film. First, we charged the molecule positively by attaching a single hole. Then we neutralized it by atta
ching an electron and observed three channels for the neutralization. We rationalize that the three channels correspond to transitions to the neutral ground state, to the lowest energy triplet excited states and to the lowest energy singlet excited states. By single-electron tunneling spectroscopy we measured the energy differences between the transitions obtaining triplet and singlet excited state energies. The experimental values are compared with density functional theory calculations of the excited state energies. Our results show that molecules in excited states can be prepared and that energies of optical gaps can be quantified by controlled single-charge injections. Our work demonstrates the access to, and provides insight into, ubiquitous electron-attachment processes related to excited-state transitions important in electron transfer and molecular optoelectronics phenomena on surfaces.
Single electron charging in an individual InAs quantum dot was observed by electrostatic force measurements with an atomic force microscope (AFM). The resonant frequency shift and the dissipated energy of an oscillating AFM cantilever were measured a
s a function of the tip-back electrode voltage and the resulting spectra show distinct jumps when the tip was positioned above the dot. The observed jumps in the frequency shift, with corresponding peaks in dissipation, are attributed to a single electron tunneling between the dot and the back electrode governed by Coulomb blockade effect, and are consistent with a model based on the free energy of the system. The observed phenomenon may be regarded as the ``force version of the Coulomb blockade effect.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
