اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدBehavior of implanted Xe, Kr and Ar in nanodiamond and thin graphene stacks: experiment and modeling
58
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Implantation and subsequent behaviour of heavy noble gases (Ar, Kr, Xe) in few-layer graphene sheets and in nanodiamonds is studied both using computational methods and experimentally using X-ray absorption spectroscopy. X-ray absorption spectroscopy provides substantial support for the Xe-vacancy (Xe-V) defect as a main site for Xe in nanodiamond. It is shown that noble gases in thin graphene stacks distort the layers, forming bulges. The energy of an ion placed in between flat graphene sheets is notably lower than in domains with high curvature. However, if the ion is trapped in the curved domain, considerable additional energy is required to displace it.
قيم البحث
اقرأ أيضاً
We present the results of our recent studies of a Thick Gaseous Electron Multiplier (THGEM)-based detector, operated in Ar, Xe and Ar:Xe (95:5) at various gas pressures. Avalanche-multiplication properties and energy resolution were investigated with
soft x-rays for different detector configurations and parameters. Gains above 10E4 were reached in a double-THGEM detector, at atmospheric pressure, in all gases, in almost all the tested conditions; in Ar:Xe (95:5) similar gains were reached at pressures up to 2 bar. The energy resolution dependence on the gas, pressure, hole geometry and electric fields was studied in detail, yielding in some configurations values below 20% FWHM with 5.9 keV x-rays.
The near ultraviolet photodissociation dynamics of silver atom rare gas dimers have been studied by velocity map imaging. AgRG (RG = Ar, Kr, Xe) species generated by laser ablation are excited in the region of the C <- X continuum leading to direct,
near threshold dissociation generating Ag* (2P3/2) + RG (1S0) products. Images recorded at excitation wavelengths throughout the C <- X continuum, coupled with known atomic energy levels, permit determination of the ground X (2SIGMA+) state dissociation energies of 85.9 +/- 23.4 cm-1 (AgAr), 149.3 +/- 22.4 cm-1 (AgKr) and 256.3 +/- 16.0 cm-1 (AgXe). Three additional photolysis processes, each yielding Ag atom photoproducts, are observed in the same spectral region. Two of these are markedly enhanced in intensity upon seeding the molecular beam with nitrous oxide, and are assigned to photodissociation of AgO at the two photon level. These features yield an improved ground state dissociation energy for AgO of 15965 +/- 81 cm-1, which is in good agreement with high level calculations. The third process results in Ag atom fragments whose kinetic energy shows anomalously weak photon energy dependence and is assigned tentatively to dissociative ionization of the silver dimer Ag2.
The nanofriction of Xe monolayers deposited on graphene was explored with a quartz crystal microbalance (QCM) at temperatures between 25 and 50 K. Graphene was grown by chemical vapor deposition and transferred to the QCM electrodes with a polymer st
amp. At low temperatures, the Xe monolayers are fully pinned to the graphene surface. Above 30 K, the Xe film slides and the depinning onset coverage beyond which the film starts sliding decreases with temperature. Similar measurements repeated on bare gold show an enhanced slippage of the Xe films and a decrease of the depinning temperature below 25 K. Nanofriction measurements of krypton and nitrogen confirm this scenario.This thermolubric behavior is explained in terms of a recent theory of the size dependence of static friction between adsorbed islands and crystalline substrates.
We investigate the gas gain behaviour of a triple-GEM configuration in gas mixtures of argon, krypton and xenon with ten and thirty percent of carbon dioxide at pressures between 1 and 3 bar. Since the signal widths affect the dead time behaviour of
the detector we present signal length measurements to evaluate the use of the triple-GEM in time-resolved X-ray imaging.
An interaction potential energy between and adsorbate (Xe and Ar) and the 10-fold Al-Ni-Co quasicrystal is computed by summing over all adsorbate-substrate interatomic interactions. The quasicrystal atoms coordinates are obtained from LEED experiment
s and the Lennard-Jones parameters of Xe-Al, Xe-Ni and Xe-Co are found using semiempirical combining rules. The resulting potential energy function of position is highly corrugated. Monolayer adsorption of Xe and Ar on the quasicrystal surface is investigated in two cases: 1) in the limit of low coverage (Henrys law regime), and 2) at somewhat larger coverage, when interactions between adatoms are considered through the second virial coefficient, C_{AAS}. A comparison with adsorption on a flat surface indicates that the corrugation enhances the effect on Xe-Xe (Ar-Ar) interactions. The theoretical results for the low coverage adsorption regime are compared to experimental (LEED isobar) data.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
