اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدElectrical and Thermal Property of Si/GaAs Heterojunction Formed by Ultra-Thin Oxide Interfacial Layer
172
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We have successfully demonstrated Si/GaAs p-n heterostructures using Al2O3 ultra-thin oxide interfacial layers. The band diagram and band offsets were investigated using X-ray photoelectron spectroscopy and confirm a small discontinuity in the conduction band (0.03 eV) at the interface. The interface defect density (Dit) values of the heterointerface with different ultra-thin oxide (UO) thicknesses ranged from 0.35 nm to 3.5 nm and were also characterized based on a metal-oxide-semiconductor capacitor (MOSCAP) structure using a capacitance-voltage measurement. The results revealed that a thin UO interfacial layer (around 1 nm) maximizes carrier transport property due to better surface passivation and efficient tunneling properties. Thermal property investigation also shows that the Al2O3 UO interfacial layer offers a good tunneling layer but also facilitates phonon transport across the interface. Finally, the electrical characterization of Si/GaAs heterojunction p-n diodes confirms reliable rectifying behavior with an extremely low ideality factor; thus, heterogeneous integration using the UO approach offers a robust way to create more types of heterojunctions between dissimilar semiconductors.
قيم البحث
اقرأ أيضاً
We demonstrate the formation of semimetal graphite/semiconductor Schottky barriers where the semiconductor is either silicon (Si), gallium arsenide (GaAs) or 4H-silicon carbide (4H-SiC). Near room temperature, the forward-bias diode characteristics a
re well described by thermionic emission, and the extracted barrier heights, which are confirmed by capacitance voltage measurements, roughly follow the Schottky-Mott relation. Since the outermost layer of the graphite electrode is a single graphene sheet, we expect that graphene/semiconductor barriers will manifest similar behavior.
We report the electrical resistivity, thermoelectric power, and thermal conductivity of single-crystalline and sintered samples of the 5d pyrochlore oxide CsW2O6. The electrical resistivity of the single crystal is 3 mohm cm at 295 K and gradually in
creases with decreasing temperature above 215 K (Phase I). The thermoelectric power of the single-crystalline and sintered samples shows a constant value of approximately -60 uV K-1 in Phase I. These results reflect that the electron conduction by W 5d electrons in Phase I is incoherent and in the hopping regime, although a band gap does not open at the Fermi level. The thermal conductivity in Phase I of both samples is considerably low, which might be due to the rattling of Cs+ ions. In Phase II below 215 K, the electrical resistivity and the absolute value of thermoelectric power of both samples strongly increase with decreasing temperature, corresponding to a transition to a semiconducting state with a band gap open at the Fermi level, while the thermal conductivity in Phase II is smaller than that in Phase I.
We demonstrate that the interfacial dipole associated with bonding across the SrTiO3/Si heterojunction can be tuned through space charge, thereby enabling the band alignment to be altered via doping. Oxygen impurities in Si act as donors that create
space charge by transferring electrons across the interface into SrTiO3. The space charge induces an electric field that modifies the interfacial dipole, thereby tuning the band alignment from type-II to type-III. The transferred charge, resulting in built-in electric fields, and change in band alignment are manifested in electrical transport and hard x-ray photoelectron spectroscopy measurements. Ab initio models reveal the interplay between polarization and band offsets. We find that band offsets can be tuned by modulating the density of space charge across the interface. Functionalizing the interface dipole to enable electrostatic altering of band alignment opens new pathways to realize novel behavior in semiconducting heterojunctions.
Electric field modulation analysis of thermopower (S) - carrier concentration (n) relation of a bilayer laminate structure composed of a 1.5-nm thick conducting layer, probably TinO2n-1 (n=2, 3,...) Magneli phase, and rutile TiO2 was performed. The r
esults clearly showed that both the rutile TiO2 and the thin interfacial layer contribute to carrier transport: the rutile TiO2 bulk region (mobility mu~0.03 cm2V-1s-1) and the 1.5-nm thick interfacial layer (mu~0.3 cm2V-1s-1). The effective thickness of the interfacial layer, which was obtained from the S-n relation, was below ~ 3 nm, which agrees well with that of the TEM observation (~1.5 nm), clearly showing that electric field modulation measurement of S-n relation can effectively clarify the carrier transport properties of a bilayer laminate structure.
We report that an ultra-thin, post-oxidized aluminum epilayer grown on the AlGaAs surface works as a high-quality tunnel barrier for spin injection from a ferromagnetic metal to a semiconductor. One of the key points of the present oxidation method i
s the formation of the crystalline AlOx template layer without oxidizing the AlGaAs region near the Al/AlGaAs interface. The oxidized Al layer is not amorphous but show well-defined single crystalline feature reminiscent of the spinel gamma-AlOx phase. A spin-LED consisting of an Fe layer, a crystalline AlOx barrier layer, and an AlGaAs-InGaAs double hetero-structure has exhibited circularly polarized electroluminescence with circular polarization of P_{EL} = 0.145 at the remnant magnetization state of the Fe layer, indicating the relatively high spin injection efficiency (epsilon = 2P_{EL} / P_{Fe}) of 0.63.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
