ترغب بنشر مسار تعليمي؟ اضغط هنا

Performance analysis of frequency regulation services provided by aggregates of domestic thermostatically controlled loads

118   0   0.0 ( 0 )
 نشر من قبل Francesco Conte
 تاريخ النشر 2021
والبحث باللغة English




اسأل ChatGPT حول البحث

This paper proposes a control method for allowing aggregates of thermostatically controlled loads to provide synthetic inertia and primary frequency regulation services to the grid. The proposed control framework is fully distributed and basically consists in the modification of the thermostat logic as a function of the grid frequency. Three strategies are considered: in the first one, the load aggregate provides synthetic inertia by varying its active power demand proportionally to the frequency rate of change; in the second one, the load aggregate provides primary frequency regulation by varying its power demand proportionally to frequency; in the third one, the two services are combined. The performances of the proposed control solutions are analyzed in the forecasted scenario of the electric power system of Sardinia in 2030, characterized by a huge installation of wind and photovoltaic generation and no coil and combustible oil power plants. The considered load aggregate is composed by domestic refrigerators and water heaters. Results prove the effectiveness of the proposed approach and show that, in the particular case of refrigerators and water heaters, the contribution to the frequency regulation is more significant in the case of positive frequency variations. Finally, the correlation between the regulation performances and the level of penetration of the load aggregate with respect to the system total load is evaluated.



قيم البحث

اقرأ أيضاً

Demand flexibility is increasingly important for power grids. Careful coordination of thermostatically controlled loads (TCLs) can modulate energy demand, decrease operating costs, and increase grid resiliency. We propose a novel distributed control framework for the Coordination Of HeterOgeneous Residential Thermostatically controlled loads (COHORT). COHORT is a practical, scalable, and versatile solution that coordinates a population of TCLs to jointly optimize a grid-level objective, while satisfying each TCLs end-use requirements and operational constraints. To achieve that, we decompose the grid-scale problem into subproblems and coordinate their solutions to find the global optimum using the alternating direction method of multipliers (ADMM). The TCLs local problems are distributed to and computed in parallel at each TCL, making COHORT highly scalable and privacy-preserving. While each TCL poses combinatorial and non-convex constraints, we characterize these constraints as a convex set through relaxation, thereby making COHORT computationally viable over long planning horizons. After coordination, each TCL is responsible for its own control and tracks the agreed-upon power trajectory with its preferred strategy. In this work, we translate continuous power back to discrete on/off actuation, using pulse width modulation. COHORT is generalizable to a wide range of grid objectives, which we demonstrate through three distinct use cases: generation following, minimizing ramping, and peak load curtailment. In a notable experiment, we validated our approach through a hardware-in-the-loop simulation, including a real-world air conditioner (AC) controlled via a smart thermostat, and simulated instances of ACs modeled after real-world data traces. During the 15-day experimental period, COHORT reduced daily peak loads by an average of 12.5% and maintained comfortable temperatures.
Thermostatically controlled loads (TCLs) can provide ancillary services to the power network by aiding existing frequency control mechanisms. TCLs are, however, characterized by an intrinsic limit cycle behavior which raises the risk that these could synchronize when coupled with the frequency dynamics of the power grid, i.e. simultaneously switch, inducing persistent and possibly catastrophic power oscillations. To address this problem, schemes with a randomized response time in their control policy have been proposed in the literature. However, such schemes introduce delays in the response of TCLs to frequency feedback that may limit their ability to provide fast support at urgencies. In this paper, we present a deterministic control mechanism for TCLs such that those switch when prescribed frequency thresholds are exceeded in order to provide ancillary services to the power network. For the considered scheme, we provide analytic conditions which ensure that synchronization is avoided. In particular, we show that as the number of loads tends to infinity, there exist arbitrarily long time intervals where the frequency deviations are arbitrarily small. Our analytical results are verified with simulations on the Northeast Power Coordinating Council (NPCC) 140-bus system, which demonstrate that the proposed scheme offers improved frequency response compared to conventional implementations.
Demand flexibility is increasingly important for power grids, in light of growing penetration of renewable generation. Careful coordination of thermostatically controlled loads (TCLs) can potentially modulate energy demand, decrease operating costs, and increase grid resiliency. However, it is challenging to control a heterogeneous population of TCLs: the control problem has a large state action space; each TCL has unique and complex dynamics; and multiple system-level objectives need to be optimized simultaneously. To address these challenges, we propose a distributed control solution, which consists of a central load aggregator that optimizes system-level objectives and building-level controllers that track the load profiles planned by the aggregator. To optimize our agents policies, we draw inspirations from both reinforcement learning (RL) and model predictive control. Specifically, the aggregator is updated with an evolutionary strategy, which was recently demonstrated to be a competitive and scalable alternative to more sophisticated RL algorithms and enables policy updates independent of the building-level controllers. We evaluate our proposed approach across four climate zones in four nine-building clusters, using the newly-introduced CityLearn simulation environment. Our approach achieved an average reduction of 16.8% in the environment cost compared to the benchmark rule-based controller.
In this paper, a method to evaluate the flexibility of aggregates of domestic electric water heaters is proposed and applied to the Italian case. Flexibility is defined as the capability of the aggregate to vary its power demand for a given time inte rval. The evaluation method consists of a Monte Carlo analysis, that uses the thermal model of electric water heaters and a proper elaboration of the external inputs, such as ambient and cold water temperatures, and hot water demand. The case of large aggregates defined along the Italian territory has been studied showing the dependence of flexibility on seasons and on time.
This paper investigates how a disturbance in the power network affects the nodal frequencies of certain network buses. To begin with, we show that the inertia of a single generator is in inverse proportion to the initial rate of change of frequency ( RoCoF) under disturbances. Then, we present how the initial RoCoF of the nodal frequencies are related to the inertia constants of multiple generators in a power network, which leads to a performance metric to analyze nodal frequency performance. To be specific, the proposed metric evaluates the impact of disturbances on the nodal frequency performance. The validity and effectiveness of the proposed metric are illustrated via simulations on a multi-machine power system.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا