اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدFrequency regulation with thermostatically controlled loads: aggregation of dynamics and synchronization
65
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Thermostatically controlled loads (TCLs) can provide ancillary services to the power network by aiding existing frequency control mechanisms. TCLs are, however, characterized by an intrinsic limit cycle behavior which raises the risk that these could synchronize when coupled with the frequency dynamics of the power grid, i.e. simultaneously switch, inducing persistent and possibly catastrophic power oscillations. To address this problem, schemes with a randomized response time in their control policy have been proposed in the literature. However, such schemes introduce delays in the response of TCLs to frequency feedback that may limit their ability to provide fast support at urgencies. In this paper, we present a deterministic control mechanism for TCLs such that those switch when prescribed frequency thresholds are exceeded in order to provide ancillary services to the power network. For the considered scheme, we provide analytic conditions which ensure that synchronization is avoided. In particular, we show that as the number of loads tends to infinity, there exist arbitrarily long time intervals where the frequency deviations are arbitrarily small. Our analytical results are verified with simulations on the Northeast Power Coordinating Council (NPCC) 140-bus system, which demonstrate that the proposed scheme offers improved frequency response compared to conventional implementations.
قيم البحث
اقرأ أيضاً
This paper proposes a control method for allowing aggregates of thermostatically controlled loads to provide synthetic inertia and primary frequency regulation services to the grid. The proposed control framework is fully distributed and basically co
nsists in the modification of the thermostat logic as a function of the grid frequency. Three strategies are considered: in the first one, the load aggregate provides synthetic inertia by varying its active power demand proportionally to the frequency rate of change; in the second one, the load aggregate provides primary frequency regulation by varying its power demand proportionally to frequency; in the third one, the two services are combined. The performances of the proposed control solutions are analyzed in the forecasted scenario of the electric power system of Sardinia in 2030, characterized by a huge installation of wind and photovoltaic generation and no coil and combustible oil power plants. The considered load aggregate is composed by domestic refrigerators and water heaters. Results prove the effectiveness of the proposed approach and show that, in the particular case of refrigerators and water heaters, the contribution to the frequency regulation is more significant in the case of positive frequency variations. Finally, the correlation between the regulation performances and the level of penetration of the load aggregate with respect to the system total load is evaluated.
Demand flexibility is increasingly important for power grids. Careful coordination of thermostatically controlled loads (TCLs) can modulate energy demand, decrease operating costs, and increase grid resiliency. We propose a novel distributed control
framework for the Coordination Of HeterOgeneous Residential Thermostatically controlled loads (COHORT). COHORT is a practical, scalable, and versatile solution that coordinates a population of TCLs to jointly optimize a grid-level objective, while satisfying each TCLs end-use requirements and operational constraints. To achieve that, we decompose the grid-scale problem into subproblems and coordinate their solutions to find the global optimum using the alternating direction method of multipliers (ADMM). The TCLs local problems are distributed to and computed in parallel at each TCL, making COHORT highly scalable and privacy-preserving. While each TCL poses combinatorial and non-convex constraints, we characterize these constraints as a convex set through relaxation, thereby making COHORT computationally viable over long planning horizons. After coordination, each TCL is responsible for its own control and tracks the agreed-upon power trajectory with its preferred strategy. In this work, we translate continuous power back to discrete on/off actuation, using pulse width modulation. COHORT is generalizable to a wide range of grid objectives, which we demonstrate through three distinct use cases: generation following, minimizing ramping, and peak load curtailment. In a notable experiment, we validated our approach through a hardware-in-the-loop simulation, including a real-world air conditioner (AC) controlled via a smart thermostat, and simulated instances of ACs modeled after real-world data traces. During the 15-day experimental period, COHORT reduced daily peak loads by an average of 12.5% and maintained comfortable temperatures.
Load side participation can provide valuable support to the power network in case of urgencies. On many occasions, loads are naturally represented by on and off states. However, the use of on-off loads for frequency control can lead to chattering and
undesirable limit cycle behavior, which are issues that need to be resolved for such loads to be used for network support. This paper considers the problem of primary frequency regulation with ancillary service from on-off loads in power networks and establishes conditions that lead to convergence guarantees and an appropriate power allocation within the network. In particular, in order to assist existing frequency control mechanisms, we consider loads that switch when prescribed frequency thresholds are exceeded. Such control policies are prone to chattering, which limits their practicality. To resolve this issue, we consider loads that follow a decentralized hysteretic on-off policy, and show that chattering is not observed within such a setting. Hysteretic loads may exhibit, however, limit cycle behavior, which is undesirable. To address this, we propose an adapted hysteretic control scheme for which we provide convergence guarantees. Furthermore, we consider a mixed-integer optimization problem for power allocation and propose a suitable design of the control policy such that the cost incurred at equilibrium is within $epsilon$ from the optimal cost, providing a non conservative value for $epsilon$. The practicality of our analytic results is demonstrated with numerical simulations on the Northeast Power Coordinating Council (NPCC) 140-bus system.
Demand flexibility is increasingly important for power grids, in light of growing penetration of renewable generation. Careful coordination of thermostatically controlled loads (TCLs) can potentially modulate energy demand, decrease operating costs,
and increase grid resiliency. However, it is challenging to control a heterogeneous population of TCLs: the control problem has a large state action space; each TCL has unique and complex dynamics; and multiple system-level objectives need to be optimized simultaneously. To address these challenges, we propose a distributed control solution, which consists of a central load aggregator that optimizes system-level objectives and building-level controllers that track the load profiles planned by the aggregator. To optimize our agents policies, we draw inspirations from both reinforcement learning (RL) and model predictive control. Specifically, the aggregator is updated with an evolutionary strategy, which was recently demonstrated to be a competitive and scalable alternative to more sophisticated RL algorithms and enables policy updates independent of the building-level controllers. We evaluate our proposed approach across four climate zones in four nine-building clusters, using the newly-introduced CityLearn simulation environment. Our approach achieved an average reduction of 16.8% in the environment cost compared to the benchmark rule-based controller.
Hybrid AC/DC networks are a key technology for future electrical power systems, due to the increasing number of converter-based loads and distributed energy resources. In this paper, we consider the design of control schemes for hybrid AC/DC networks
, focusing especially on the control of the interlinking converters (ILC(s)). We present two control schemes: firstly for decentralized primary control, and secondly, a distributed secondary controller. In the primary case, the stability of the controlled system is proven in a general hybrid AC/DC network which may include asynchronous AC subsystems. Furthermore, it is demonstrated that power-sharing across the AC/DC network is significantly improved compared to previously proposed dual droop control. The proposed scheme for secondary control guarantees the convergence of the AC system frequencies and the average DC voltage of each DC subsystem to their nominal values respectively. An optimal power allocation is also achieved at steady-state. The applicability and effectiveness of the proposed algorithms are verified by simulation on a test hybrid AC/DC network in MATLAB / Simscape Power Systems.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
