ترغب بنشر مسار تعليمي؟ اضغط هنا

Effect of ice sheet thickness on formation of the Hiawatha impact crater

92   0   0.0 ( 0 )
 نشر من قبل Elizabeth Silber
 تاريخ النشر 2021
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

The discovery of a large putative impact crater buried beneath Hiawatha Glacier along the margin of the northwestern Greenland Ice Sheet has reinvigorated interest into the nature of large impacts into thick ice masses. This circular structure is relatively shallow and exhibits a small central uplift, whereas a peak-ring morphology is expected. This discrepancy may be due to long-term and ongoing subglacial erosion but may also be explained by a relatively recent impact through the Greenland Ice Sheet, which is expected to alter the final crater morphology. Here we model crater formation using hydrocode simulations, varying pre-impact ice thickness and impactor composition over crystalline target rock. We find that an ice-sheet thickness of 1.5 or 2 km results in a crater morphology that is consistent with the present morphology of this structure. Further, an ice sheet that thick substantially inhibits ejection of rocky material, which might explain the absence of rocky ejecta in most existing Greenland deep ice cores if the impact occurred during the late Pleistocene. From the present morphology of the putative Hiawatha impact crater alone, we cannot distinguish between an older crater formed by a pre-Pleistocene impact into ice-free bedrock or a younger, Pleistocene impact into locally thick ice, but based on our modeling we conclude that latter scenario is possible.



قيم البحث

اقرأ أيضاً

We performed numerical simulations of impact crater formation on Europa to infer the thickness and structure of its ice shell. The simulations were performed using iSALE to test both the conductive ice shell over ocean and the conductive lid over war m convective ice scenarios for a variety of conditions. The modeled crater depth-diameter is strongly dependent on thermal gradient and temperature of the warm convective ice. Our results indicate that both a fully conductive (thin) shell and a conductive-convective (thick) shell can reproduce the observed crater depth-diameter and morphologies. For the conductive ice shell over ocean, the best fit is an approximately 8 km thick conductive ice shell. Depending on the temperature (255 - 265 K) and therefore strength of warm convective ice, the thickness of the conductive ice lid is estimated at 5 - 7 km. If central features within the crater, such as pits and domes, form during crater collapse, our simulations are in better agreement with the fully conductive shell (thin shell). If central features form well after the impact, however, our simulations suggest a conductive-convective shell (thick shell) is more likely. Although our study does not provide firm conclusion regarding the thickness of Europas ice shell, our work indicates that Valhalla-class multiring basins on Europa may provide robust constraints on the thickness of Europas ice shell.
Impacts between planetary-sized bodies can explain the origin of satellites orbiting large ($R>500$~km) trans-Neptunian objects. Their water rich composition, along with the complex phase diagram of water, make it important to accurately model the wi de range of thermodynamic conditions material experiences during an impact event and in the debris disk. Since differences in the thermodynamics may influence the system dynamics, we seek to evaluate how the choice of an equation of state (EOS) alters the systems evolution. Specifically, we compare two EOSs that are constructed by different approaches: either by a simplified analytic description (Tillotson), or by interpolation of tabulated data (Sesame). Approximately $50$ pairs of Smoothed Particle Hydrodynamics impact simulations were performed, with similar initial conditions but different EOSs, in the parameter space in which the Pluto-Charon binary is thought to form (slow impacts between Pluto-size, water rich bodies). Generally, we show that impact outcomes (e.g., circumplanetary debris disk) are consistent between EOSs. Some differences arise, importantly in the production of satellitesimals (large intact clumps) that form in the post-impact debris disk. When utilizing an analytic EOS, the emergence of satellitesimals is highly certain, while when using the tabulated EOS it is less common. This is because for the typical densities and energies experienced in these impacts, the analytic EOS predicts very low pressure values, leading to particles artificially aggregating by a tensile instability.
We investigate the patterns observed in ejecta curtain induced by hypervelocity impact (2-6 km/s) with a variety of the size and shape of target particles. We characterize the patterns by an angle, defined as the ratio of the characteristic length of the pattern obtained by Fourier transformation to the distance from the impact point. This angle is found to be almost the same as that obtained by the reanalysis of the patterns in the previous study at lower impact velocities (Kadono et al., 2015, Icarus 250, 215-221), which are consistent with lunar crater-ray systems. Assuming that the pattern is formed by mutual collision of particles with fluctuation velocity in excavation flow, we evaluate an angle at which the pattern growth stops and show that this angle is the same in the order of magnitude as the ratio of the fluctuation velocity and the radial velocity. This relation is confirmed in the results of experiments and numerical simulations. Finally, we discuss the dependence of the patterns on impact conditions. The experiments show no dependence of the angle on impact velocity. This indicates that the ratio between the fluctuation and radial velocity components in excavation flow does not depend on impact velocity. Moreover, the independences on particle size and particle shape suggest that the angle characterizing the structure of the patterns does not depend on cohesive force. Since cohesive forces should be related with elastic properties of particles, the structure does not depend on elastic properties, though inelastic collisions are important for the persistence and contrast of the patterns.
We analyze thermal emission spectra using the 2001 Mars Odyssey Thermal Emission Imaging System (THEMIS) and the Mars Global Surveyor (MGS) Thermal Emission Spectrometer (TES) to characterize grain size and mineralogical composition of dunes at Hargr aves crater, Mars. Thermal inertia and bulk composition of the dunes were compared to inferred provenances from the thermal infrared response of surface constituent materials. We use a Markov Chain Monte Carlo (MCMC) technique to estimate the bulk amount of mineralogy contributed by each inferred provenance to the dune field composition. An average thermal inertia value of 238+/-17 Jm-2K-1s-0.5 was found for the dunes corresponding to a surface composed of an average effective grain size of ~391+/-172 um. This effective particle size suggests the presence of mostly medium sand-sized materials mixed with fine and coarse grain sands. The dunes are likely comprised of a weakly indurated surface mixed with unconsolidated materials. Compositional analysis specifies that the dunes are comprised of a mixture of feldspar, olivine, pyroxene, and relatively low bulk-silica content. Dune materials were likely derived from physical weathering, especially eolian erosion, predominantly from the crater ejecta unit at the crater, mixed with a small amount from the crater floor and crater rim and wall lithologies - indicating the dune materials were likely sourced locally.
264 - Tim Lichtenberg 2017
Chondrules are the dominant bulk silicate constituent of chondritic meteorites and originate from highly energetic, local processes during the first million years after the birth of the Sun. So far, an astrophysically consistent chondrule formation s cenario, explaining major chemical, isotopic and textural features, remains elusive. Here, we examine the prospect of forming chondrules from planetesimal collisions. We show that intensely melted bodies with interior magma oceans became rapidly chemically equilibrated and physically differentiated. Therefore, collisional interactions among such bodies would have resulted in chondrule-like but basaltic spherules, which are not observed in the meteoritic record. This inconsistency with the expected dynamical interactions hints at an incomplete understanding of the planetary growth regime during the protoplanetary disk phase. To resolve this conundrum, we examine how the observed chemical and isotopic features of chondrules constrain the dynamical environment of accreting chondrite parent bodies by interpreting the meteoritic record as an impact-generated proxy of planetesimals that underwent repeated collision and reaccretion cycles. Using a coupled evolution-collision model we demonstrate that the vast majority of collisional debris feeding the asteroid main belt must be derived from planetesimals which were partially molten at maximum. Therefore, the precursors of chondrite parent bodies either formed primarily small, from sub-canonical aluminum-26 reservoirs, or collisional destruction mechanisms were efficient enough to shatter planetesimals before they reached the magma ocean phase. Finally, we outline the window in parameter space for which chondrule formation from planetesimal collisions can be reconciled with the meteoritic record and how our results can be used to further constrain early solar system dynamics.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا