اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSpin-flop led peculiar behavior of temperature-dependent anomalous Hall effect in Hf/Gd-Fe-Co
59
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Here we investigate the temperature dependence of anomalous Hall effect in Hf/GdFeCo/MgO sheet film and Hall bar device. The magnetic compensation temperature ($T_{comp}$) for the sheet film and device is found to be ~240 K and ~118 K, respectively. In sheet film, spin-flopping is witnessed at a considerably lower field, 0.6 T, close to $T_{comp}$. The AHE hysteresis loops in the sheet film have a single loop whereas in the Hall bar device, hystereses consist of triple loops are observed just above the Tcomp. Moreover, the temperature-dependent anomalous Hall resistance ($R_mathrm{AHE}$) responds unusually when a perpendicular magnetic field is applied while recording the $R_mathrm{AHE}$. The zero-field $R_mathrm{AHE}$ scan suggests the Hall signal generates solely from the FeCo moment. However, the behavior of 3 T-field $R_mathrm{AHE}$ scan in which the $R_mathrm{AHE}$ drops close to zero near the $T_{comp}$ seems to be following the net magnetization response of the device, is explained by considering the low field spin-flopping around the compensation temperature. The results presented here give important insight to understand the complex AHE behavior of ferrimagnets for their spintronic applications.
قيم البحث
اقرأ أيضاً
Non-monotonic dependence of anomalous Hall resistivity on temperature and magnetization, including a sign change, was observed in Fe/Gd bilayers. To understand the intriguing observations, we fabricated the Fe/Gd bilayers and single layers of Fe and
Gd simultaneously. The temperature and field dependences of longitudinal resistivity, Hall resistivity and magnetization in these films have also been carefully measured. The analysis of these data reveals that these intriguing features are due to the opposite signs of Hall resistivity/or spin polarization and different Curie temperatures of Fe and Gd single-layer films.
The anomalous Hall effect (AHE) is a fundamental spintronic charge-to-charge-current conversion phenomenon and closely related to spin-to-charge-current conversion by the spin Hall effect. Future high-speed spintronic devices will crucially rely on s
uch conversion effects at terahertz (THz) frequencies. Here, we reveal that the AHE remains operative from DC up to 40 THz with a flat frequency response in thin films of three technologically relevant magnetic materials: DyCo$_{5}$, Co$_{32}$Fe$_{68}$ and Gd$_{27}$Fe$_{73}$. We measure the frequency-dependent conductivity-tensor elements ${sigma}_{xx}$ and ${sigma}_{yx}$ and find good agreement with DC measurements. Our experimental findings are fully consistent with ab-initio calculations of ${sigma}_{yx}$ for CoFe and highlight the role of the large Drude scattering rate (~100 THz) of metal thin films, which smears out any sharp spectral features of the THz AHE. Finally, we find that the intrinsic contribution to the THz AHE dominates over the extrinsic mechanisms for the Co$_{32}$Fe$_{68}$ sample. The results imply that the AHE and related effects such as the spin Hall effect are highly promising ingredients of future THz spintronic devices reliably operating from DC to 40 THz and beyond.
We present the Co-Gd composition dependence of the spin-Hall magnetoresistance (SMR) and anisotropic magnetoresistance (AMR) for ferrimagnetic Co100-xGdx / Pt bilayers. With Gd concentration x, its magnetic moment increasingly competes with the Co mo
ment in the net magnetization. We find a nearly compensated ferrimagnetic state at x = 24. The AMR changes sign from positive to negative with increasing x, vanishing near the magnetization compensation. On the other hand, the SMR does not vary significantly even where the AMR vanishes. These experimental results indicate that very different scattering mechanisms are responsible for AMR and SMR. We discuss a possible origin for the alloy composition dependence.
Constructing heterostructures of a topological insulator (TI) with an undoped magnetic insulator (MI) is a clean and versatile approach to break the time-reversible symmetry in the TI surface states. Despite a lot of efforts, the strength of interfac
ial magnetic proximity effect (MPE) is still too weak to achieve the quantum anomalous Hall effect and many other topological quantum phenomena. Recently, a new approach based on intercalation of atomic layers of MI, referred to as magnetic extension, was proposed to realize strong MPE [2D Mater. 4, 025082(2017)]. Motivated by this proposal, here, we study a magnetic extension system prepared by molecular beam epitaxy growth of MnSe thin films on topological insulator (Bi,Sb)2Te3. Direct evidence is obtained for intercalation of MnSe atomic layer into a few quintuple layers of (Bi,Sb)2Te3, forming either a double magnetic septuple layer (SL) or an isolated single SL at the interface, where one SL denotes a van der Waals building block consisting of B-A-B-Mn-B-A-B (A=Bi1-xSbx, B= Te1-ySey). The two types of interfaces (namely TI/mono-SL and TI/bi-SL) have different MPE, which is manifested as distinctively different transport behaviors. Specifically, the mono-SL induces a spinflip transition with a sharp change at small magnetic field in the anomalous Hall effect of TI layers, while the bi-SL induces a spin-flop transition with a slow change at large field. Our work demonstrates a useful platform to realize the full potential of the magnetic extension approach for pursuing novel topological physics and related device applications.
Graphene on ferroelectric structures can be promising candidates for advanced field effect transistors, modulators and electrical transducers, providing that research of their electrotransport and electromechanical performances can be lifted up from
mostly empirical to prognostic theoretical level.Recently we have shown that alternating piezoelectric displacement of the ferroelectric domain surfaces can lead to the alternate stretching and separation of graphene areas at the steps between elongated and contracted domains, and the conductance of graphene channel can be increased essentially at room temperature, because electrons in the stretched section scatter on acoustic phonons.The piezoelectric mechanism of graphene conductance control requires systematic studies of the ambient condition impact on its manifestations. This theoretical work studies in details the temperature behavior of the graphene conductance changes induced by piezoelectric effect in a ferroelectric substrate with domain stripes.We revealed the possibility to control graphene conductance (that can change up to 100 times for PZT ferroelectric substrate) by tuning the ambient temperature from low values to the critical one for given gate voltage and channel length.Also we demonstrate the possibility to control graphene conductance changes up to one hundred of times by tuning the gate voltage from 0 to the critical value at a given temperature and channel length. Obtained results can be open the way towards graphene on ferroelectric applications in piezoresistive memories operating in a wide temperature range.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
