اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدFundamental Performance Limits on Terahertz Wireless Links Imposed by Group Velocity Dispersion
50
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
A theoretical framework and numerical simulations quantifying the impact of atmospheric group velocity dispersion on wireless terahertz communication link error rate were developed based upon experimental work. We present, for the first time, predictions of symbol error rate as a function of link distance, signal bandwidth, signal-to-noise ratio, and atmospheric conditions, revealing that long-distance, broadband terahertz communication systems may be limited by inter-symbol interference stemming from group velocity dispersion, rather than attenuation. In such dispersion limited links, increasing signal strength does not improve the symbol error rate and, consequently, theoretical predictions of symbol error rate based only on signal-to-noise ratio are invalid for the broadband case. This work establishes a new and necessary foundation for link budget analysis in future long-distance terahertz communication systems that accounts for the non-negligible effects of both attenuation and dispersion.
قيم البحث
اقرأ أيضاً
This work investigates the temporal dispersion of a wireless terahertz communication signal caused by reflection from a rough (diffuse) surface, and its subsequent impact on symbol error rate versus data rate. Broadband measurements of diffuse reflec
tors using terahertz time-domain spectroscopy were used to establish and validate a scattering model that uses stochastic methods to describe the effects of surface roughness on the phase and amplitude of a reflected terahertz signal, expressed as a communication channel transfer function. The modeled channel was used to simulate a quadrature phase shift keying (QPSK)- modulated wireless communication link to determine the relationships between symbol error rate and data rate as a function of surface roughness. The simulations reveal that surface roughness from wall texturing results in group delay dispersion that limits achievable data rate with low errors. A distinct dispersion limit in surface roughness is discovered beyond which unacceptable numbers of symbol errors begin to accrue for a given data rate.
We report and demonstrate for the first time a method to compensate atmospheric group velocity dispersion of terahertz pulses. In ultra-wideband or impulse radio terahertz wireless communication, the atmosphere reshapes terahertz pulses via group vel
ocity dispersion, a result of the frequency-dependent refractivity of air. Without correction, this can significantly degrade the achievable data transmission rate. We present a method for compensating the atmospheric dispersion of terahertz pulses using a cohort of stratified media reflectors. Using this method, we compensated group velocity dispersion in the 0.2-0.3 THz channel under common atmospheric conditions. Based on analytic and numerical simulations, the method can exhibit an in-band power efficiency of greater than 98% and dispersion compensation up to 99% of ideal. Simulations were validated by experimental measurements.
Terahertz (THz) wireless communication is envisioned as a promising technology, which is capable of providing ultra-high-rate transmission up to Terabit per second. However, some hardware imperfections, which are generally neglected in the existing l
iterature concerning lower data rates and traditional operating frequencies, cannot be overlooked in the THz systems. Hardware imperfections usually consist of phase noise, in-phase/quadrature imbalance, and nonlinearity of power amplifier. Due to the time-variant characteristic of phase noise, frequent pilot insertion is required, leading to decreased spectral efficiency. In this paper, to address this issue, a novel pilot design strategy is proposed based on index modulation (IM), where the positions of pilots are flexibly changed in the data frame, and additional information bits can be conveyed by indices of pilots. Furthermore, a turbo receiving algorithm is developed, which jointly performs the detection of pilot indices and channel estimation in an iterative manner. It is shown that the proposed turbo receiver works well even under the situation where the prior knowledge of channel state information is outdated. Analytical and simulation results validate that the proposed schemes achieve significant enhancement of bit-error rate performance and channel estimation accuracy, whilst attaining higher spectral efficiency in comparison with its classical counterpart.
We investigate which practical constraints are imposed by foregrounds to the detection of the B-mode polarization generated by gravitational waves in the case of experiments of the type currently being planned. Because the B-mode signal is probably d
ominated by foregrounds at all frequencies, the detection of the cosmological component depends drastically on our ability for removing foregrounds. We provide an analytical expression to estimate the level of the residual polarization for Galactic foregrounds, according to the method employed for their subtraction. We interpret this result in terms of the lower limit of the tensor-to-scalar ratio r that allows to disentangle the cosmological B-mode polarization from the foregrounds contribution. Polarized emission from extragalactic radio sources and gravitational lensing is also taken into account. As a first approach, we consider the ideal limit of an instrumental noise--free experiment: for a full--sky coverage and a degree resolution, we obtain a limit of r~10^(-4). This value can be improved by high--resolution experiments and, in principle, no clear fundamental limit on the detectability of gravitational waves polarization is found. Our analysis is also applied to planned or hypothetical future polarization experiments, taking into account expected noise levels.
It has long been thought that normal group-velocity dispersion (GVD) cannot be produced in free space via angular dispersion. Indeed, conventional diffractive or dispersive components such as gratings or prisms produce only anomalous GVD. We identify
the conditions that must be fulfilled by the angular dispersion introduced into a plane-wave pulse to yield normal GVD. We then utilize a pulsed-beam shaper capable of introducing arbitrary angular-dispersion profiles to symmetrically produce normal and anomalous GVD in free space, which are realized here on the same footing for the first time.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
