اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدUnlocking the Origin of Compositional Fluctuations in InGaN Light Emitting Diodes
93
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The accurate determination of the compositional fluctuations is pivotal in understanding their role in the reduction of efficiency in high indium content $In_{x}Ga_{1-x}N$ light-emitting diodes, the origin of which is still poorly understood. Here we have combined electron energy loss spectroscopy (EELS) imaging at sub-nanometer resolution with multiscale computational models to obtain a statistical distribution of the compositional fluctuations in $In_{x}Ga_{1-x}N$ quantum wells (QWs). Employing a multiscale computational model, we show the tendency of intrinsic compositional fluctuation in $In_{x}Ga_{1-x}N$ QWs at different Indium concentration and in the presence of strain. We have developed a systematic formalism based on the autonomous detection of compositional fluctuation in observed and simulated EELS maps. We have shown a direct comparison between the computationally predicted and experimentally observed compositional fluctuations. We have found that although a random alloy model captures the distribution of compositional fluctuations in relatively low In ($sim$ 18%) content $In_{x}Ga_{1-x}N$ QWs, there exists a striking deviation from the model in higher In content ($geq$ 24%) QWs. Our results highlight a distinct behavior in carrier localization driven by compositional fluctuations in the low and high In-content InGaN QWs, which would ultimately affect the performance of LEDs. Furthermore, our robust computational and atomic characterization method can be widely applied to study materials in which nanoscale compositional fluctuations play a significant role on the material performance.
قيم البحث
اقرأ أيضاً
Efficiency droop effect under high injection in GaN-based light emitting diodes (LEDs) strongly depends on wavelength, which is still not well understood. In this paper, through differential carrier lifetime measurements on commercialized near-UV, bl
ue, and green LEDs, their different efficiency droop behaviors are attributed to different carrier lifetimes, which are prolonged as wavelength increases. This relationship between carrier lifetime and indium composition of InGaN quantum well is believed owing to the polarization-induced quantum confinement Stark effect. Long carrier lifetime not only increases the probability of carrier leakage, but also results in high carrier concentration in quantum well. In other words, under the same current density, the carrier concentration in active region in near-UV LED is the lowest while that in green one is the highest. If considering the efficiency droop depending on carrier concentration, the behaviors of LEDs with different wavelengths do not show any abnormality. The reason why the efficiency droop becomes more serious under lower temperature can be also explained by this model as well. Based on this result, the possible solutions to conquer efficiency droop are discussed. It seems that decreasing the carrier lifetime is a fundamental approach to solve the problem.
Concentration quenching is a major impediment to efficient organic light-emitting devices. We herein report on Organic Light-Emitting Diodes (OLEDs) based on a fluorescent amorphous red-emitting starbust triarylamine molecule (4-di(4-tert-butylbiphen
yl-4-yl)amino-4-dicyanovinylbenzene, named FVIN), exhibiting a very small sensitivity to concentration quenching. OLEDs are fabricated with various doping levels of FVIN into Alq3, and show a remarkably stable external quantum efficiency of 1.5% for doping rates ranging from 5% up to 40%, which strongly relaxes the technological constraints on the doping accuracy. An efficiency of 1% is obtained for a pure undoped active region, along with deep red emission (x=0.6; y=0.35 CIE coordinates). A comparison of FVIN with the archetypal DCM dye is presented in an identical multilayer OLED structure.
A growing interest in colloidal quantum dot (QD) based light-emitting diodes (QD-LEDs) has been motivated by the exceptional color purity and spectral tunability of QD emission as well as the amenability of QD materials to highly scalable and inexpen
sive solution processing. One current challenge in the QD-LED field has been a still incomplete understanding of the role of extrinsic factors (e.g., recombination via QD surface defects) versus intrinsic processes such as multicarrier Auger recombination or electron-hole separation due to applied electric field in defining device efficiency. Here, we address this problem with a study of excited-state dynamics in a series of structurally engineered QDs, which is performed in parallel with characterization of their performance upon incorporation into LEDs. The results of this study indicate that under both zero and forward bias, a significant fraction of the QDs within the active emitting layer is negatively charged and therefore, Auger recombination represents an important factor limiting the efficiency of these devices. We further observe that the onset of the LED efficiency roll-off is also controlled by Auger recombination and can be shifted to higher currents by using newly developed QDs with an intermediate alloy layer at the core-shell interface introduced for suppression of Auger decay. Our findings suggest that further improvement in the performance of QD-LEDs can be achieved by developing effective approaches for controlling Auger recombination and/or minimizing the effects of QD charging via improved balancing of electron and hole injection currents.
Localized surface plasmons (LSPs) have played a significant role in improving the light emission efficiency of light emitting diodes (LEDs). In this report, polygonal nanoholes have been fabricated in the p-GaN layer of InGaN-based LEDs by using Ni n
anoporous film as the etching mask, and then Au/Al metal nanoparticles are embedded in the nanoholes to form the LSP structure. The coupling between the LSP and the LED has been clearly observed. The results show that the light output of the LEDs has been increased by 46% at higher current injection condition, and together with a shift of the gain peak position to the LSP peak resonance energy. As the coupling distance is decreased from 60 nm to 30 nm, the maximum enhancement factor increases to 2.38. The above results indicate that the LSP from the polygonal metal nanoparticles is a kind of very promising structure to enhance the lighting performance of the InGaN-based LEDs.
The performance of solution-processed organic light emitting diodes (OLEDs) is often limited by non-uniform contacts. In this work, we introduce Ni-containing solution-processed metal oxide (MO) interfacial layers inserted between indium tin oxide (I
TO) and poly(3,4-ethylenedioxythiophene):poly(styrene sulfonate) (PEDOT:PSS) to improve the bottom electrode contact for OLEDs using the poly(p-phenylene vinylene) (PPV) derivative Super-Yellow (SY) as an emission layer. For ITO/Ni-containing MO/PEDOT:PSS bottom electrode structures we show enhanced wetting properties that result in an improved OLED device efficiency. Best performance is achieved using a Cu-Li co-doped spinel nickel cobaltite [(Cu-Li):NiCo2O4], for which the current efficiency and luminous efficacy of SY OLEDs increased, respectively, by 12% and 11% from the values obtained for standard devices without a Ni-containing MO interface modification between ITO and PEDOT:PSS. The enhanced performance was attributed to the improved morphology of PEDOT:PSS, which consequently increased the hole injection capability of the optimized ITO/(Cu-Li):NiCo2O4/PEDOT:PSS electrode.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
