ترغب بنشر مسار تعليمي؟ اضغط هنا

Domino cooling of a coupled mechanical-resonator chain via cold-damping feedback

258   0   0.0 ( 0 )
 نشر من قبل Denggao Lai
 تاريخ النشر 2020
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

We propose a domino-cooling method to realize simultaneous ground-state cooling of a coupled mechanical-resonator chain through an optomechanical cavity working in the unresolved-sideband regime. This domino-effect cooling is realized by combining the cold-damping feedback on the first mechanical resonator with nearest-neighbor couplings between other neighboring mechanical resonators. We obtain analytical results for the effective susceptibilities, noise spectra, final mean phonon numbers, and cooling rates of these mechanical resonators, and find the optimal-cooling condition for these resonators. Particularly, we analyze a two-mechanical-resonator case and find that by appropriately engineering either the laser power or the feedback, a flexible switch between symmetric and asymmetric ground-state cooling can be achieved. This could be used for preparing symmetric quantum states in mechanical systems. We also simulate the cooling performance of a coupled $N$-mechanical-resonator chain and confirm that these resonators can be simultaneously cooled to their quantum ground states in the unresolved-sideband regime. Under proper parameter conditions, the cooling of the mechanical-resonator chain shows a temperature gradient along the chain. This study opens a route to quantum manipulation of multiple mechanical resonators in the bad-cavity regime.

قيم البحث

اقرأ أيضاً

We provide a fully analytical treatment for the partial refrigeration of the thermal motion of a quantum mechanical resonator under the action of feedback. As opposed to standard cavity optomechanics where the aim is to isolate and cool a single mech anical mode, the aim here is to extract the thermal energy from many vibrational modes within a large frequency bandwidth. We consider a standard cold-damping technique where homodyne read-out of the cavity output field is fed into a feedback loop that provides a cooling action directly applied on the mechanical resonator. Analytical and numerical results predict that low final occupancies are achievable independently of the number of modes addressed by the feedback as long as the cooling rate is smaller than the intermode frequency separation. For resonators exhibiting a few nearly degenerate pairs of modes cooling is less efficient and a weak dependence on the number of modes is obtained. These scalings hint towards the design of frequency resolved mechanical resonators where efficient refrigeration is possible via simultaneous cold-damping feedback.
We propose two measurement-based schemes to cool a nonlinear mechanical resonator down to energies close to that of its ground state. The protocols rely on projective measurements of a spin degree of freedom, which interacts with the resonator throug h a Jaynes-Cummings interaction. We show the performance of these cooling schemes, that can be either concatenated -- i.e. built by repeating a sequence of dynamical evolutions followed by projective measurements -- or single-shot. We characterize the performance of both cooling schemes with numerical simulations, and pinpoint the effects of decoherence and noise mechanisms. Due to the ubiquity and experimental relevance of the Jaynes-Cummings model, we argue that our results can be applied in a variety of experimental setups.
A promising route to novel quantum technologies are hybrid quantum systems, which combine the advantages of several individual quantum systems. We have realized a hybrid atomic-mechanical experiment consisting of a SiN membrane oscillator cryogenical ly precooled to 500 mK and optically coupled to a cloud of laser cooled Rb atoms. Here, we demonstrate active feedback cooling of the oscillator to a minimum mode occupation of n = 16 corresponding to a mode temperature of T = 200 {mu}K. Furthermore, we characterize in detail the coupling of the membrane to the atoms by means of sympathetic cooling. By simultaneously applying both cooling methods we demonstrate the possibility of preparing the oscillator near the motional ground state while it is coupled to the atoms. Realistic modifications of our setup will enable the creation of a ground state hybrid quantum system, which opens the door for coherent quantum state transfer, teleportation and entanglement as well as quantum enhanced sensing applications.
We investigate the role of time delay in cold-damping optomechanics with multiple mechanical resonances. For instantaneous electronic response, it was recently shown in textit{Phys. Rev. Lett. textbf{123}, 203605 (2019)}, that a single feedback loop is sufficient to simultaneously remove thermal noise from many mechanical modes. While the intrinsic delayed response of the electronics can induce single mode and mutual heating between adjacent modes, we propose to counteract such detrimental effects by introducing an additional time delay to the feedback loop. For lossy cavities and broadband feedback, we derive analytical results for the final occupancies of the mechanical modes within the formalism of quantum Langevin equations. For modes that are frequency degenerate collective effects dominate, mimicking behavior similar to Dicke super- and subradiance. These analytical results, corroborated with numerical simulations of both transient and steady state dynamics, allow to find suitable conditions and strategies for efficient single or multimode feedback optomechanics.
We experimentally investigate the nonlinear response of a multilayer graphene resonator using a superconducting microwave cavity to detect its motion. The radiation pressure force is used to drive the mechanical resonator in an optomechanically induc ed transparency configuration. By varying the amplitudes of drive and probe tones, the mechanical resonator can be brought into a nonlinear limit. Using the calibration of the optomechanical coupling, we quantify the mechanical Duffing nonlinearity. By increasing the drive force, we observe a decrease in the mechanical dissipation rate at large amplitudes, suggesting a negative nonlinear damping mechanism in the graphene resonator. Increasing the optomechanical backaction, we observe a nonlinear regime not described by a Duffing response that includes new instabilities of the mechanical response.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا