ترغب بنشر مسار تعليمي؟ اضغط هنا

Structural insight using anomalous XRD into Mn2CoAl Heusler alloy films grown by magnetron sputtering, IBAS and MBE techniques

96   0   0.0 ( 0 )
 نشر من قبل Hiroo Tajiri
 تاريخ النشر 2020
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Inverse Heusler alloy Mn2CoAl thin films, known as a spin-gapless semiconductor (SGS), grown by three different methods: ultra-high vacuum magnetron spattering, Ar-ion beam assisted sputtering, and molecular beam epitaxy, are investigated by comparing their electric transport properties, microstructures and atomic-level structures. Of the samples, the Mn2CoAl thin film grown by MBE consists of Mn- and Co-rich phases, the structures of which are determined to be the L21B-type and disordered L21-type, respectively, according to anomalous XRD analysis. None of them forms the XA-type structure expected for SGS Heusler alloy, although they all show SGS characteristics. We suggest, to validate SGS characteristics, it is necessary to extract not only magnetic and electric transport properties but also information about microstructures and atomic-scale structures of the films including defects such as atomic swap.



قيم البحث

اقرأ أيضاً

310 - Valerie Brien 2020
Nanocrystalline n-AlN:Er thin films were deposited on (001) Silicon substrates by r. f. magnetron sputtering at room temperature to study the correlation between 1.54 $mu$m IR photoluminescence (PL) intensity, AlN crystalline structure and Er concent ration rate. This study first presents how Energy-Dispersive Spectroscopy of X-rays (EDSX) Er Cliff Lorimer sensitivity factor alpha = 5 is obtained by combining EDSX and electron probe micro analysis (EPMA) results on reference samples. It secondly presents the relative PL intensities of nanocrystallized samples prepared with identical sputtering parameters as a function of the Er concentration. The structure of crystallites in AlN films is observed by transmission electron microscopy.
The results of characterization of TiAlSiON hard coatings deposited on ferric-chromium AISI 430 stainless steel by plasma enhanced magnetron sputtering are presented. The coating with maximum hardness (of 45 GPa) was obtained at the following optimal values of elemental concentrations: Si ~5 at.%, Al ~15 at.%, and Ti ~27 at.%. The elastic modulus of the coating was 590 GPa. The reading of gaseous mixture (Ar-N2) pressure was 1*10-3 Torr and the reading of partial pressure of oxygen (O2) was 1*10-5 Torr. The X-ray diffraction (XRD) measurements showed the presence of Ti(Al)N. High-energy resolved XPS spectra of core levels revealed the formation of Ti-N, Ti-O-N, Si-N and Al-O-N bonds. Comparison of XPS valence band spectra with specially performed density functional theory calculations for two ordered and few disordered TiN1-xOx (0 =< x <= 1) demonstrates that a Ti(Al)OxNy phase is formed on the surface of AISI430 steel upon the plasma enhanced magnetron sputtering, which provides this material with a good combination of high hardness and improved oxidation resistance.
In the prospect of understanding the photoluminescence mechanisms of AlN films doped with erbium and targeting photonic applications we have synthesized non doped and Er-doped AlN films with different crystallized nanostructures by using PVD magnetro n sputtering. Their crystalline morphology and their visible photoluminescence properties were precisely measured.Due to the weak cross-section absorption of rare earths like erbium, it is necessary to obtain an efficient energy transfer mechanism between the host matrix and the rare earth to obtain high luminescence efficiency. Our strategy is then to elaborate some nanostructures that could introduce additional intermediate electronic levels within the gap thanks to the presence of structural defects (point defects, grain boundaries{ldots}) and could lead to energy transfer from the AlN matrix to the rare earth.Doped and non-doped AlN films were prepared by radio frequency magnetron sputtering by using different experimental conditions that will be detailed. It will notably be shown how a negative polarization of samples during deposition allows obtaining crystalline morphologies ranging from the classical columnar structure to a highly disordered polycrystalline structure with grains of several nanometers (nearly amorphous). The nanostructures of the films could be categorized in three types: 1) type 1 was nanocolumnar (width of column ~ 15 nm), 2) type 2 was made of short columns (width of column ~ 10 nm) and 3) the last type was made of equiaxed nanocrystallites (size of grains ~3-4 nm).High-resolution photoluminescence spectroscopy was performed to characterize their optical behaviour. The samples were excited by the laser wavelengths at 458, 488 or 514 nm. A broad photoluminescence band was observed centred around 520 nm in columnar samples. In the same energy range, the highly resolved spectra also showed several sharp emission peaks. This fine structure could be attributed to erbium transitions. This fine structure tended to disappear going from type 1 to type 3 samples. Indeed, the relative intensity of the peaks decreased and their full width at half maximum increased. This change could be related to the density of defects that increased when the size of the grains decreased. The photoluminescence properties of the films in the visible range will be discussed in relation with their structure.
92 - H. Rinnert 2019
Er-doped aluminum nitride films, containing different Er concentrations, were obtained at room temperature by reactive radio frequency magnetron sputtering. The prepared samples show a nano-columnar microstructure and the size of the columns is depen dent on the magnetron power. The Er-related photoluminescence (PL) was studied in relation with the temperature, the Er content and the microstructure. Steady-state PL, PL excitation spectroscopy and time-resolved PL were performed. Both visible and near infrared PL were obtained at room temperature for the as-deposited samples. It is demonstrated that the PL intensity reaches a maximum for an Er concentration equal to 1 at. % and that the PL efficiency is an increasing function of the magnetron power. Decay time measurements show the important role of defect related non radiative recombination, assumed to be correlated to the presence of grain boundaries. Moreover PL excitation results demonstrate that an indirect excitation of Er 3+ ions occurs for excitation wavelengths lower than 600 nm. It is also suggested that Er ions occupy at least two different sites in the AlN host matrix.
The effect of magnetron power on the room temperature 1.54 $mu$m infra-red photoluminescence intensity of erbium doped AlN films grown by r. f. magnetron sputtering, has been studied. The AlN:Er thin films were deposited on (001) Silicon substrates. The study presents relative photoluminescence intensities of nanocrystallized samples prepared with identical sputtering parameters for two erbium doping levels (0.5 and 1.5 atomic %). The structural evolution of the crystallites as a function of the power is followed by transmission electron microscopy. Copyright line will be provided by the publisher 1 Introduction For some time now, rare-earth (RE)-doped semiconductors represent significant potential applications in the field of opto-electronic technology. Part of this technological interest relies on the shielded 4f levels of the RE ions as they give rise to sharp and strong luminescence peaks [1-5]. Among the RE elements, Er is preferred to its counterparts since the Er ions can produce both visible light at 558 nm (green, one of the primary colours) and IR light at 1.54 $mu$m whose spectrum region coincides with the main low-loss region in the absorption spectrum of silica-based optical fibres, combining so potential applications towards photonic devices and towards optical communication devices operating in the infrared domain. These interesting emissions can however only be exploited when placed into host matrixes. On one side, the shielding of the intra 4f levels prevents the shifting of the RE 3+ energy levels and ensures the frequency emission stability. Moreover the intra 4f transitions are parity forbidden for the isolated ions. Matrixes can render the Er 3+ ions optically active, via a relaxation of selection rules due to crystal field effects. As silicon based materials were tested in the 1960s to the 90s with no clear industrial success it was found that the
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا